Analysis of total mercury in human tissues prepared by microwave decomposition using a hydride generator system coupled to an atomic absorption spectrometer

Method optimization for heavy metal determination in milk powder: application to milk samples from Greece

The scope of this study was the development, optimization and validation of an analytical method for the determination of selected heavy metals and trace elements (As, Hg, Se, Cd, Cu, Pb, Mn, Fe, Ni, Zn, Cr) in milk powder, using microwave-assisted digestion. A statistical experimental design approach using central composite design (CCD) was carried out, to investigate the effects of three independent pretreatment variables (final digestion temperature (°C), HNO₃ concentration (in % w/v), microwave hold time) on the heavy metal recovery of spiked undigested milk powder sample and to calculate the variable factor values which produce the optimum recovery. CCD results revealed that the optimum digestion conditions, with respect to maximum recovery were as follows: temperature 190 °C, HNO₃ 56.8% w/v, and digestion time of 8.47 min. The method was fully validated. Recoveries for all metals ranged between 92 and 108% while intra-day repeatability was below 6.59% (rsd). A certified reference material (ERM BD 150) that included 8 out of the total 11 heavy metals of the present study (Hg, Se, Cd, Cu, Pb, Mn, Ni, and Zn) was used to test the accuracy of the method where acceptable recovery values ranging between 96 and 107% were obtained. High heavy metal recoveries, short digestion time, and low acid consumption were the advantages of the pretreatment method. The analytical process was successfully applied for the determination of heavy metals in different milk samples from the Greek market. Heavy metal concentrations for Ni, Cr, Pb, Cd, Se, Mn, and Cu measured in this study reached 307, 102, 8.01, 5.96, 60.2, 519, and 438 μg/kg wet weight (ww), respectively. Zn and Fe were found at concentrations ranging 3.21-8.39 and 0.170-10.1 mg/kg ww, respectively. Risk assessment based on the WHO tolerable daily intake levels and the calculated target hazard quotients revealed that the consumption of the selected milk samples is considered safe.

Concentrations of trace elements [corrected] and organochlorines in Mutton bird (Puffinus griseus)

The Sooty Shearwater (Puffinus griseus, commonly known as Mutton bird) is a migratory wild seabird, annually harvested for food by certain native groups in New Zealand and Australia and in many parts of the world. The concentrations of 22 elements and several organochlorine pesticides [2,2-bis(chlorophenyl)-1,1,1-trichloroethane (DDT), its derivatives dichlorodiphenyldichloroethene (DDE) and dichlorodiphenyldichloroethane (DDD), aldrin, chlordane, dicofol, lindane, and methoxychlor] in Mutton bird were determined over two consecutive years to evaluate its safety for human consumption. Twenty bird carcasses were purchased in each of 2007 and 2008 from a local source. No significant year effect (P>0.05) was found in the following nine trace elements: Al, As, Cd, Co, Cr, Cu, Ni, Pb and Se. The concentrations of Hg, Li and Na were higher (P<0.05) in 2008 samples compared to 2007. The toxic trace elements (mg/kg wet weight) in all the samples were below the maximum residual level (MRL). The concentration of Fe, Ca and Se in Mutton bird was higher than that in domestic land animal meats reported in literature. The residual organochlorine concentrations were all below the recommended MRL. Thus Mutton bird meat is high in essential nutrient elements and of low toxicological risk. Due to active use of agrochemical in New Zealand, a monitoring program for contaminants in Mutton birds is recommended.

Sampling procedure and a radio-indicator study of mercury determination in whole blood by using an AMA 254 atomic absorption spectrometer

A sampling procedure appropriate for the determination of mercury in whole blood was tested by using both inactive controls and a 197Hg mercury radio-indicator. To exclude the influence of the instrumental device (an AMA 254 single-purpose mercury atomic absorption spectrometer) on the determination of mercury in whole blood, the function of the instrument was checked by using rat blood with metabolised 197Hg. The measurement procedure was found to be free of errors. However, the study showed that the material used for the sampling vessels is a crucial parameter for obtaining accurate analytical results. The stability of solutions and samples was tested towards polyethylene (PE) and polypropylene (PP) vessels. PE displayed a time-dependent increase in the mercury content both in the samples and in the blood control material. The probable cause of this increase was direct contamination from the material of the vessel and/or diffusion of mercury from the environment through the vessel walls related to a strong complexing affinity of the sample matrix. This assumption was confirmed by supplying the vessels with the complexing agent Na2EDTA (0.05 mol L(-1)). Commercial PP vessels for blood sampling (Sarstedt S-Monovette Metall Analytik) did not give rise to statistically significant variations in mercury content in the samples and blood control material over a 30-day period.