Screening for the presence of drugs in serum and urine using different separation modes of capillary electrophoresis

Sensitive Electrochemical Monitoring of Piroxicam in Pharmaceuticals Using Carbon Ionic Liquid Electrode

Background:

Piroxicam is a non-steroidal anti-inflammatory drug. The prevailing clinical use and investigation of piroxicam necessitate a rapid and sensitive method for its determination. A carbon ionic liquid electrode, fabricated using graphite and the ionic liquid 1-octylpyridinium hexafluorophosphate (OPFP) was used as an electrochemical sensor for piroxicam determination.

Methods:

The surface of the proposed electrode was characterized by scanning electron microscopy. Cyclic voltammetry (CV) was applied to study the oxidation of piroxicam and to acquire information about the reaction mechanism. Differential pulse voltammetry was also used as an analytical technique for quantification of the sub-micromolar concentration of piroxicam.

Results:

One oxidation peak at 0.55V was observed at CILE. The oxidation peak at the CPE was weak, while the response was notably increased at the CILE. The proposed electrode exhibited interesting sensitivity towards the determination of piroxicam and the anodic peak current versus piroxicam concentration was linear in the ranges of 0.2-60 µM. The detection limit of 40 nM was achieved.

Conclusion:

The electroxidation process was irreversible and revealed adsorption controlled behavior. The method was successfully applied for the determination of piroxicam content in pharmaceutical samples.

Validated method for the determination of piroxicam by capillary zone electrophoresis and its application to tablets

Simple and rapid capillary zone electrophoretic method was developed and validated in this study for the determination of piroxicam in tablets. The separation of piroxicam was conducted in a fused-silica capillary by using 10 mM borate buffer (pH 9.0) containing 10% (v/v) methanol as background electrolyte. The optimum conditions determined were 25 kV for separation voltage and 1 s for injection time. Analysis was carried out with UV detection at 204 nm. Naproxen sodium was used as an internal standard. The method was linear over the range of 0.23-28.79 µg/mL. The accuracy and precision were found to be satisfied within the acceptable limits (<2%). The LOD and LOQ were found to be 0.07 and 0.19 µg/mL, respectively. The method described here was applied to tablet dosage forms and the content of a tablet was found in the limits of USP-24 suggestions. To compare the results of capillary electrophoretic method, UV spectrophotometric method was developed and the difference between two methods was found to be insignificant. The capillary zone electrophoretic method developed in this study is rapid, simple, and suitable for routine analysis of piroxicam in pharmaceutical tablets.

CAPILLARY ELECTROPHORESIS AS A VERIFICATION TOOL FOR IMMUNOCHEMICAL DRUG SCREENING

BACKGROUND

The aim of this work was to develop a simple capillary electrophoretic method as the verification and confirmation tool in the screening analysis for amphetamines, opiates, benzodiazepines and cocaine and their metabolites for toxicological applications.

METHODS

50 mM phosphate Tris pH 2.0 with 30% (v/v) of methanol was used as a background electrolyte that enabled fast separation of drugs and their metabolites in saliva and urine. Verification of the data from the electrophoretic method was done by High Performance Thin Layer Chromatography (HPTLC) and the immunochemical screening test QuikScreen.

RESULTS

The experimental conditions of the Capillary Electrophoresis (CE) were partially optimized (mainly the influence of concentration and types of additives, e.g. cyclodextrines, organic solvents) and validated; the method was used for analysing samples from drug abusers.

CONCLUSIONS

The non-instrumental, immunoassay tests could only confirm qualitative addictions and are mainly employed when the emergency detection of drugs is needed. For quantitative analysis and verification of obtained results the confirmation step is strongly recommended. The simple screening capillary zone electrophoresis method allows recognition of the most abused drugs. The agreement of the results from CE, HPTLC and QuikScreen test was more than 95%.

Modern instrumental methods in forensic toxicology

This article reviews modern analytical instrumentation in forensic toxicology for identification and quantification of drugs and toxins in biological fluids and tissues. A brief description of the theory and inherent strengths and limitations of each methodology is included. The focus is on new technologies that address current analytical limitations. A goal of this review is to encourage innovations to improve our technological capabilities and to encourage use of these analytical techniques in forensic toxicology practice.

Nonaqueous capillary electrophoresis in pharmaceutical analysis

This review presents different solvents and electrolytes commonly used as BGEs in NACE for the analysis of pharmaceutical compounds. Most NACE applications carried out since 1998 for the analysis of compounds of pharmaceutical interest are presented in four tables: (i) analysis of drugs and related substances, (ii) analysis of chiral substances, (iii) analysis of phytochemical extracts and (iv) analysis of drugs in biological fluids. These selected examples are used to illustrate the interest in NACE versus conventional aqueous CE.

Factorial design applied to a non-aqueous capillary electrophoresis method for the separation of β-agonists

The aim of this work was to study the effects of both chemical and instrumental parameters on the separation of beta-agonists (clenbuterol (CLE), salbutamol (SAL) and terbutaline (TER)) by non-aqueous capillary electrophoresis (NACE) method. Due to the number of parameters involved and their interactions, factorial experimental designs (EDs) at two levels was applied to investigate the influence of experimental factors (ionic strength of the background electrolyte (BGE), organic solvent, injection time, voltage and temperature) in sets of several CE responses (resolution, (RS), number of theoretical plate (N), tailing factor (TF) and migration time (tm)). As a compromise between the four responses, the optimum condition was obtained in 18 mM ammonium acetate in methanol (MeOH):acetonitrile (ACN):glacial acetic acid (66:33:1%, v/v/v) using an injection time of 4 s, the voltage and the temperature of 28 kV and 24 degrees C, respectively. The proposed NACE permitted the baseline separation of the three beta-agonists within 10.5 min with good repeatability (%RSD < 3.5%) and linearity (r2 > 0.99). The developed method was applicable for the analysis of the beta-agonists in syrup and tablets and the NACE condition was compatible with a mass spectrometer detector.

Coated Wire Potentiometric Detection for Capillary Electrophoresis Studied Using Organic Amines, Drugs, and Biogenic Amines

Capillary electrophoresis was coupled successfully and reliably to potentiometric sensors, which are based on an ionically conductive rubber phase coating, applied on a 250 microm diameter metal substrate. The membrane components included potassium tetrakis(p-chlorophenyl)borate (TCPB), bis(2-ethylhexyl)sebacate (DOS), and high molecular mass poly(vinyl chloride) (PVC). Potentiometry reveals a very sensitive CE detection mode, with sub-micromolar detection limits for amines and the randomly chosen drugs quinine, clozapine, cocaine, heroine, noscapine, papaverine, and ritodrine. The lowest detection limit, 1 x 10(-8) M injected concentration, was obtained for the quaternary ammonium compound tetrahexylammonium chloride. The more polar lower aliphatic amines and the biogenic amines dopamine, adrenaline, and cadaverine have much higher detection limits. The detection limits are log P dependent. Addition of a commercially available calixarene molecule or a synthetic macrocyclic amphiphilic receptor molecule to the electrode coatings enhanced the sensitivity respectively for the lower aliphatic amines and for the biogenic amines. A transpose of the Nikolskii-Eisenman-type function was suggested and used to convert the signal of the detector to a concentration-dependent signal.

Nonaqueous capillary electrophoresis in coated capillaries: An interesting alternative for proteomic applications

This work brings together some contributions for the use of nonaqueous media for proteomic analysis, for both capillary electrophoresis (CE) separation and the preparation of tryptic digests. First, a ternary nonaqueous buffer consisting of 60/30/10 v/v methanol/acetonitrile/acetic acid with 12.5 mmol/L ammonium acetate was optimized for CE separation of the tryptic digest of lysozyme. Lysozyme was chosen as a model system for the protein digestion, which has also been prepared in an organic-rich medium with methanol/50 mmol/L NH(4)HCO(3), pH 8.0 (60/40 v/v). The separation results were compared to in silico (PeptideCutter program) digestion conditions, and high-efficiency peak separation (18 peaks) was obtained in 20 min with an electric field of 350 V/cm. In addition, we have evaluated the stability of a coated capillary with poly-N,N-dimethylacrylamide (60/30 cm total/effective length and 75 microm ID) for over 100 runs of tryptic digest with the nonaqueous background electrolyte solvent system. The migration times for ten selected peptide peaks presented 3-7% relative standard deviation.

Is capillary electrophoresis a method of choice for systematic toxicological analysis?

This review presents an overview of current research on the use of capillary electrophoretic techniques for the analysis of drugs in biological matrices. The discussion focuses on the applicability of the methods for the identification of unknown toxic compounds, which is defined as systematic toxicological analysis (STA). The aim is to establish whether or not capillary electrophoresis (CE), in one or more of its separation modes, is a method of choice in systematic toxicological analysis. To answer this question, various aspects are discussed, including sample work-up, separation modes, detection techniques, electrophoretic concentration, and identification by database retrieval. Several ways to improve the poor reproducibility and sensitivity are discussed. This leads to the conclusion that CE can be comparable to HPLC in those respects, while it is more favorable in speed, efficiency, and cost. Thus, we conclude that CE is a method of choice for STA, keeping in mind that every method has its limitations and that a combination of several non-correlated methods is always required for the identification of unknown compounds.

Separation of new antidepressants and their metabolites by micellar electrokinetic capillary chromatography

Selective serotonin reuptake inhibitors (SSRIs), serotonin noradrenergic reuptake inhibitors (SNaRIs) and noradrenergic and specific serotoninergic antidepressant (NaSSA) are widely used in the treatment of depression. An increase in antidepressant intoxications led to the development of reliable analytical methods for their analysis. A new determination procedure for these compounds (milnacipran, venlafaxine, desmethylvenlafaxine, mirtazapine, desmethylmirtazapine, citalopram, desmethylcitalopram, fluvoxamine, paroxetine, sertraline and fluoxetine) was developed by micellar electrokinetic capillary chromatography (MEKC) with diode array detection (DAD). Separation and determination were optimised on an uncoated fused-silica capillary (600 mm, 75 microm I.D.). The migration buffer consisted of 20 mM sodium borate, pH 8.55, with 20 mM SDS and 15% isopropanol, at an operating voltage of 25 kV. The column temperature was maintained at 40 degrees C. Injection in the capillary was performed in the hydrodynamic mode (0.5 p.s.i., 15 s). In these conditions, the migration time of the antidepressants was less than 11 min. In most cases, calibration curves were established for 30 - 2000 ng/ml (r > 0.995). The limit of detection and the limit of quantification were ranged between 10 and 20 and between 20 and 30 ng/ml, respectively, for all the molecules. This method allowed the determination of some of these compounds in biological fluids (blood, urine) in post-mortem cases. Samples (1 ml) were extracted with diethyl ether (5 ml) at pH 9.6 and reconstituted in diluted migration buffer. Similar results were obtained by a HPLC-DAD determination, performed as a reference method. These results suggest that this MEKC method can be useful for the determination of new antidepressants in post-mortem cases.