Voltammetric determination of isoxsuprine and fenoterol in dosage forms and biological fluids through nitrosation

Novel kinetic spectrophotometric method for estimation of certain biologically active phenolic sympathomimetic drugs in their bulk powders and different pharmaceutical formulations

A simple, selective and sensitive kinetic spectrophotometric method was described for estimation of four phenolic sympathomimetic drugs namely; terbutaline sulfate, fenoterol hydrobromide, isoxsuprine hydrochloride and etilefrine hydrochloride. This method is depended on the oxidation of the phenolic drugs with Folin-Ciocalteu reagent in presence of sodium carbonate. The rate of color development at 747-760nm was measured spectrophotometrically. The experimental parameters controlling the color development were fully studied and optimized. The reaction mechanism for color development was proposed. The calibration graphs for both the initial rate and fixed time methods were constructed, where linear correlations were found in the general concentration ranges of 3.65×10^-6-2.19×10^-5molL^-1 and 2-24.0μgmL^-1 with correlation coefficients in the following range 0.9992-0.9999, 0.9991-0.9998 respectively. The limits of detection and quantitation for the initial rate and fixed time methods were found to be in general concentration range 0.109-0.273, 0.363-0.910 and 0.210-0.483, 0.700-1.611μgmL^-1 respectively. The developed method was validated according to ICH and USP 30 -NF 25 guidelines. The suggested method was successfully implemented to the estimation of these drugs in their commercial pharmaceutical formulations and the recovery percentages obtained were ranged from 97.63%±1.37 to 100.17%±0.95 and 97.29%±0.74 to 100.14±0.81 for initial rate and fixed time methods respectively. The data obtained from the analysis of dosage forms were compared with those obtained by reported methods. Statistical analysis of these results indicated no significant variation in the accuracy and precision of both the proposed and reported methods.

Spectrophotometric and spectrofluorimetric methods for determination of certain biologically active phenolic drugs in their bulk powders and different pharmaceutical formulations

Two simple and sensitive spectrophotometric and spectrofluorimetric methods for the determination of terbutaline sulfate, fenoterol hydrobromide, etilefrine hydrochloride, isoxsuprine hydrochloride, ethamsylate, doxycycline hyclate have been developed. Both methods were based on the oxidation of the cited drugs with cerium (IV) in acid medium. The spectrophotometric method was based on measurement of the absorbance difference (ΔA), which represents the excess cerium (IV), at 317nm for each drug. On the other hand, the spectrofluorimetric method was based on measurement of the fluorescent of the produced cerium (III) at emission wavelength 354nm (λ_excitation=255nm) for the concentrations studied for each drug. For both methods, the variables affecting the reactions were carefully investigated and the conditions were optimized. Linear relationships were found between either ΔA or the fluorescent of the produced cerium (III) values and the concentration of the studied drugs in a general concentration range of 2.0-24.0μgmL^-1, 20.0-24.0ngmL^-1 with good correlation coefficients in the following range 0.9990-0.9999, 0.9990-0.9993 for spectrophotometric and spectrofluorimetric methods respectively. The limits of detection and quantitation of spectrophotometric method were found in general concentration range 0.190-0.787 and 0.634-2.624μgmL^-1respectively. For spectrofluorimetric method, the limits of detection and quantitation were found in general concentration range 4.77-9.52 and 15.91-31.74ngmL^-1 respectively. The stoichiometry of the reaction was determined, and the reactions pathways were postulated. The analytical performance of the methods, in terms of accuracy and precision, were statistically validated and the results obtained were satisfactory. The methods have been successfully applied to the determination of the cited drugs in their commercial pharmaceutical formulations. Statistical comparison of the results with the reference methods showed excellent agreement and proved that no significant difference in the accuracy and precision.

Simultaneous determination of ritodrine and isoxsuprine using coupling technique of synchronous fluorimetry and H-point standard addition method

Simultaneous determination of two structurally related ss(2) adrenergic receptor agonists namely, Ritodrine HCl (RTH) and Isoxsuprine HCl (ISP) was performed using coupling technique of synchronous fluorimetry and H-point standard addition method. Under optimum conditions, linear determination ranges were 1.48 - 14.80 x 10(-6) mol L(-1) and 1.54 - 15.44 x 10(-6) mol L(-1) for ISP and RTH respectively. RTH and ISP could be determined simultaneously without interference from each other when their concentration ratio varies from 5:1 to 1:5 in the mixed sample. The proposed method was applied to the determination of RTH and ISP in synthetic mixture of pharmaceutical samples, the accuracy and precision of the results were satisfactory.

Determination of isoxsuprine hydrochloride by sequential injection visible spectrophotometry

An automated sequential injection (SI) spectrophotometric method for the determination of isoxsuprine hydrochloride is described. The method is based on the condensation of aminoantipyrine with phenols (isoxsuprine hydrochloride) in the presence of an alkaline oxidizing agent (potassium hexacyanoferrate) to yield a pink colored product, the absorbance of which is monitored at 507 nm. Chemical as well as physical SI parameters that affect the signal response have been optimized in order to get better sensitivity, higher sampling rate and better reagent economy. Using the optimized aforesaid parameters, a linear relationship between the relative peak height and concentration was obtained in the range 1-60 mg l-1. The detection limit (as 3sigma value) was 0.3 mg l-1 and precision was 1.4% and 1.6% at 5 and 10 mg l-1, respectively. As compared to previous reports, wide linear range, low detection limit, and highly economical reagent consumption are the advantages of this automated method.

Voltammetric analysis of drugs

A review on the voltammetric analysis of drugs is presented. The review includes a summary of the rules that must be considered for drug analysis and a survey of the use of voltammetry for drug analysis in the period from 1998 till 2002.

Spectrophotometric determination of fenoterol hydrobromide in pure form and dosage forms

A sensitive and rapid spectrophotometric procedure has been investigated for the determination of fenoterol either per se or in pharmaceutical preparations. The proposed procedure is based on the reaction between the drug and 4-chloro-7-nitrobenzo-2-oxa-1,3-diazole (NBD-Cl) at pH 7.2, using borate buffer, to produce a yellow adduct. The latter has maximum absorbance at 400 nm and obeys Beer's law within the concentration range 5-30 microg/ml. Regression analysis of the calibration data showed a good correlation coefficient (r=0.9996) with minimum detection limit of 0.24 microg/ml (6.2 x 10(-8) M). The proposed procedure has been successfully applied to the determination of this drug in its tablets and in syrup, the mean percent recoveries were 97.45+/-0.59 and 98.7+/-0.64%, respectively. The results obtained are in good agreement with those given using a reference method. The pharmaceutical additives other than active ingredient did not interfere. A proposal of the reaction pathway has been postulated.

A simple kinetic spectrophotometric method for the determination of isoxsuprine in dosage forms

A simple and sensitive kinetic method was developed for the determination of isoxsuprine in pharmaceutical preparations. The method is based upon a kinetic investigation of the oxidation reaction of the drug with alkaline potassium permanganate at room temperature for a fixed time of 30 min. The absorbance of the coloured manganate ion was measured at 610 nm. Alternatively, the decrease in the absorbance of potassium permanganate after addition of the drug was measured at 525 nm. The absorbance-concentration plots in both procedures were rectilinear over the range of 0.5-4 microg ml(-1) (r = 0.9998) with a minimum detectability of 0.05 microg ml (-1) (1.48 x 10(-7) M). The different experimental parameters affecting the development and stability of the colours were carefully studied and optimized. The determination of isoxsuprine by the fixed concentration and rate constant methods is also feasible with the calibration equations obtained but the fixed time method has been found to be more applicable. Both procedures were applied to the determination of isoxsuprine in formulations. The results obtained were in good agreement with those obtained using a reference method. The proposed method was also adopted to detect isoxsuprine in spiked human plasma at its therapeutic level of concentration (0.4 microg ml(-1)). A proposal of the reaction pathway was postulated.

Fluorimetric determination of isoxsuprine hydrochloride in pharmaceuticals and biological fluids

Two simple and highly sensitive fluorimetric methods have been developed for the determination of isoxsuprine hydrochloride in bulk, in dosage forms and in biological fluids. The first method involves the direct measurement of the native fluorescence of the drug in the concentration range 0.4-4.0 microg ml(-1), the second method is based on the oxidation of isoxsuprine HCl with cerium(IV) followed by fluorimetric measurement in the concentration range 0.02-0.2 microg ml(-1). The average % found were 99.9 +/- 0.78 and 100.0 +/- 0.62 for the two methods, respectively. The minimum detectability (3 S(B)) were 0.11 and 0.007 microg ml(-1) for the two methods, respectively. The methods results showed insignificant difference with those of the official method.

Advances in the voltammetric analysis of small biologically relevant compounds

The problems associated with attempting to apply voltammetric techniques to the analysis of biologically relevant organics within complex media are identified and, through reviewing the very recent literature (1999-mid-2001), possible solutions are described. The boundaries of the search were limited to research targeted at the resolution of specific problems, associated with quantitative determinations. Various strategies have emerged to counter problems of poor sensitivity and selectivity and these have been summarized and critically appraised. Where possible, the characteristics of each approach have been distilled into a table format to ease comparison. Emphasis has been placed on the collation of information that will improve the intrinsic electrode response and as such should be of value to those interested in pursuing electroanalytical methodologies regardless of context.