Dissolution of USP prednisone calibrator tablets: effects of stirring conditions and particle size distribution

Mechanistic Approach to Understanding the Influence of USP Apparatus I and II on Dissolution Kinetics of Tablets with Different Operating Release Mechanisms

This article provides an analysis of dissolution kinetics associated with formulations subjected to different dissolution methods with the purpose of revealing credible direction on selection of apparatus type and hydrodynamics on in vitro drug release profiles using three different formulations. The dissolution kinetics of immediate release (IR) and controlled release (CR) ibuprofen tablets under different hydrodynamic conditions were determined, and potential existence of any correlation between USP apparatus I and II were analyzed using adequate kinetic models. Two types of CR tablets based on PEO (polyethylene oxide-N80) and HPMC (hydroxypropyl methylcellulose- K100M) polymers were prepared. Marketed ibuprofen 200-mg IR tablets were also used. Dissolution studies were carried out using USP 34 apparatuses I and II methods at stirring speed of 100 and 50 rpm in 900 mL phosphate buffer, pH 7.2 at 37°C. The drug release profiles for each formulation was determined and statistically analyzed using model-dependent, model-independent (f ₂ ), and ANOVA methods. No significant dissolution differences existed between IR tablets, whereas CR tablets were significantly impacted by apparatus types and hydrodynamics. PEO matrices displayed higher sensitivity to hydrodynamics relative to HPMC matrices, and differences in dissolution profiles were confirmed by ANOVA and boxplot analysis. It is concluded that in the case of CR systems, selection of apparatus type and adherence to the monograph specifications and hydrodynamic conditions is critical, while for IR tablets, both apparatus types and agitation rates had no significant impact on drug release rate, suggesting the possibility of apparatus interchangeability if desired.

Dissolution characteristics of cylindrical particles and tablets

In this paper, dissolution characteristics of primary-particles and compressed tablets were investigated by experiments using a mathematical model. For the primary-particle, it was found that the dissolution rate increased with a decrease in the particle size. Assuming that primary-particles of size distribution were of cylindrical shape and that the dissolution occurs from the total external surface, an extended Nernst-Noyes-Whitney equation fitted to the experimental data well. As the influences of particle size and shape on thickness of a diffusion-boundary film were found to be quite low, the dissolution rate was considered to be affected by the specific surface area dominantly. Furthermore, the same model was applied to a compressed tablet and fitted to the data well. Though the rate constant obtained were not affected by the properties of primary-particles forming the tablet, it was found to increase with the apparent voidage which occupies the inter-particle volume of tablet diluent among less soluble particles. Consequently, an increase in the apparent voidage is presumed to accelerate penetration of water into the internal voids of the tablet. Thus, the dissolution going, the effective surface area inside the tablet is considered to be extended.