Performance appraisals of digital spectroscopy systems for the measurement of bone lead

In vivostudy of an x-ray fluorescence system to detect bone strontium non-invasively

An x-ray fluorescence (XRF) system using 125I as the source was developed to measure strontium in bone in vivo. As part of an in vivo pilot study, 22 people were measured at two bone sites, namely the index finger and the tibial ankle joint. Ultrasound measurements were used to obtain the soft tissue thickness at each site, which was necessary to correct the signal for tissue attenuation. For all 22 people, the strontium peak was clearly distinguishable from the background, proving that the system is able to measure Sr in vivo in people having normal bone Sr levels. Monte Carlo simulations were carried out to test the feasibility and the limitations of using the coherently scattered peak at 35.5 keV as a means to normalize the signal to correct for the bone size and shape. These showed that the accuracy of the normalized Sr signal when comparing different people is about 12%. An interesting result arising from the study is that, in the measured population, significantly higher measurements of bone Sr concentration were observed in continental Asian people, suggesting the possibility of a dietary or race dependence of the bone Sr concentration or a different bone biology between races.

Quantification of bone strontium levels in humans by in vivo x-ray fluorescence

The need for in vivo bone strontium assessment arises because strontium may exert a number of effects on bone, which may be either beneficial or toxic. Measurements discussed here are noninvasive, no sample is taken, nor is there discomfort to patients. The developed source excited x-ray fluorescence system employs a 109Cd source to excite the strontium K x rays, with the source and detector in approximately 90 degree geometry relative to the sample position. The factors affecting the accuracy and minimal detectable limit for bone strontium in vivo measurements are discussed. A system calibration revealed a minimum detectible limit of approximately 0.25 mg Sr/g Ca, which is sufficient for the monitoring of strontium levels in healthy subjects and patients with elevated bone strontium concentrations. Preliminary in vivo measurements in ten healthy subjects at two bone sites (phalanx and tibia) indicated that this system can be applied for cumulative bone strontium estimation while delivering a low effective dose of 80 nSv during the measurement time. Future work will involve attempts to enhance system precision with alternative fluorescing sources and further optimization of the detection system.

Calibration and characterization of a digital X-ray fluorescence bone lead system

Five different combinations of digital shaping parameters were tested for a newly assembled. 109Cd source, K X-ray fluorescence bone lead system. System calibration results are presented, along with analyses of measurement uncertainty and reproducibility obtained from repeat measurements of a bone phantom and a human tibia. Digital shaping parameters of 2.4 micros for a rise time/fall time and 1.2 micros for a flat top width were identified as superior. The digital system provided significant improvements in overall measurement precision, with gains of at least 25-35% over conventional system results.