Monte Carlo simulation of radon SSNT detectors

Theoretical and experimental study of the LR-115 detector response in a non-commercial radon monitor

B.trαcks, a simulation program for SSNTD's sensitivity, has been developed to study the response of LR-115 (cellulose nitrate) and CR-39 (poly allyl glycol carbonate) nuclear track detectors. Detectors are located inside detector holders and are used for radon measurements. The program incorporates a variety of special features gathered together to achieve good agreement between theoretical approach and experimental results. The input parameters to study the detector response are radon exposure, geometry and dimensions of a detector holder (it can be cylindrical, conical or semi-spherical), entrance type for radon gas, detector type, and V function (four different functions were selected from literature). The output results are detector response and radon progeny distribution onto internal chamber walls. In this article, the response of the LR-115, which is placed inside a non-commercial-conductive radon monitor based on diffusion chambers called G2, was theoretically and experimentally studied. The common Monte Carlo simulation procedure and an alternative approach that replicates how monitors are exposed to different radon exposures were used as theoretical approaches. Experimental methodology was conducted in a radon test chamber from Italy (MI.AM s.r.l.). Comparison results of both theoretical and experimental methodology are presented and discussed. One of the major results, among others, shows that the monitor material (conductive or non-conductive) does not influence the LR-115 response.

Computer program for the sensitivity calculation of a CR-39 detector in a diffusion chamber for radon measurements

Computer software for calculation of the sensitivity of a CR-39 detector closed in a diffusion chamber to radon is described in this work. The software consists of two programs, both written in the standard Fortran 90 programming language. The physical background and a numerical example are given. Presented software is intended for numerous researches in radon measurement community. Previously published computer programs TRACK_TEST.F90 and TRACK_VISION.F90 [D. Nikezic and K. N. Yu, Comput. Phys. Commun. 174, 160 (2006); D. Nikezic and K. N. Yu, Comput. Phys. Commun. 178, 591 (2008)] are used here as subroutines to calculate the track parameters and to determine whether the track is visible or not, based on the incident angle, impact energy, etching conditions, gray level, and visibility criterion. The results obtained by the software, using five different V functions, were compared with the experimental data found in the literature. Application of two functions in this software reproduced experimental data very well, while other three gave lower sensitivity than experiment.

A Monte Carlo study of radon detection in cylindrical diffusion chambers

The functioning of radon diffusion chambers was studied using the Monte Carlo code RAMMX developed here. The alpha particles from radon are assumed randomly produced in the volume of the cylinder, and those from the progeny are assumed to originate randomly at the cylindrical surface. The energy spectrum, the distribution of incident angles, and the distribution of path lengths of the alpha particles on the detector were obtained. These quantities vary depending on input parameters such as initial alpha particle energy, radius and depth of the diffusion chamber, detector size and atmospheric pressure. The calculated energy spectrum for both (222)Rn and (220)Rn was compared with experiment, permitting the identification of each peak and its origin, and a better understanding of radon monitoring. Three aspects not considered in previous calculations are progeny alphas coming from surfaces of the monitor, taking into account the atmospheric pressure, and including the isotope (220)Rn.