Vibrational spectra and ab initio analysis of tert-butyl, trimethylsilyl, and trimethylgermyl derivatives of 3,3-dimethylcyclopropene IV. 3,3-dimethyl-1,2-bis(trimethylgermyl)cyclopropene

Vibrational spectra and ab initio analysis of tert-butyl, trimethylsilyl, trimethylgermyl, trimethylstannyl and trimethylplumbyl derivatives of 3,3-dimethylcyclopropene. XII. 1,2-Di-tert-butyl-3,3-dimethylcyclopropene

The synthesis of 1,2-di-tert-butyl-3,3-dimethylcyclopropene (I) is performed and its IR and Raman spectra are measured. Optimized geometries of I are obtained at the HF/6-31G* and CCSD/cc-pVDZ levels. The ab initio calculated spectra are used for the assignments of the experimental spectral data. The results obtained are compared with the corresponding data for 3,3-dimethylbut-1-ene and 3,3-dimethylcyclopropene. These experimental data and the total vibrational analysis of I supplement the information obtained in the series of investigations of tert-butyl, trimethylsilyl, trimethylgermyl, trimethylstannyl, and trimethylplumbyl derivatives of 3,3-dimethylcyclopropene.

Vibrational spectra and ab initio analysis of tert-butyl, trimethylsilyl, trimethylgermyl, trimethylstannyl, and trimethylplumbyl derivatives of 3,3-dimethylcyclopropene X. Some regularities

The changes in the vibrational frequencies of 1-tert-butyl and 1,2-di-tert-butyl derivatives of 3,3-dimethylcyclopropene brought about by substitution of the central carbon atom (X) of the tert-butyl moieties by Si, Ge, Sn, or Pb atoms are examined. The most important decrease in the vibrational frequencies implicating the X(CH(3))(3) moieties is noted for substitution of X=C by Si. The substitutions of Si by Ge or Ge by Sn or Sn by Pb are not accompanied by the pronounced frequency shifts observed for the C-->Si transition. An explanation is given for trends in these vibrational frequencies for the transitions X=C-->Si-->Ge-->Sn-->Pb. It is concluded that there are lower limiting values of the vibrational frequencies of a molecular moiety which are approached when the mass of its isovalent atom is increased. This leads to the formation of cluster regions in the vibrational spectra for the frequencies of the SnC(3) and PbC(3) moieties.

Vibrational spectra and ab initio analysis of tert-butyl, trimethylsilyl, trimethylgermyl, trimethylstannyl, and trimethylplumbyl derivatives of 3,3-dimethylcyclopropene IX. 3,3-Dimethyl-1-(trimethylplumbyl)cyclopropene

The geometrical parameters and quantum mechanical force fields (QMFF's) of 3,3-dimethyl-1-(trimethylplumbyl)cyclopropene (I), 3,3-dimethyl-1-(t-butyl)cyclopropene (II), 3,3-dimethyl-1-(trimethylsilyl)cyclopropene (III), 3,3-dimethyl-1-(trimethylgermyl)cyclopropene (IV), and 3,3-dimethyl-1-(trimethylstannyl)cyclopropene (V) were calculated at the pseudopotential (HF/SDDAll) level. Analysis of the optimised geometrical parameters was performed. The set of scale factors for correction of the pseudopotential QMFF of III was determined using its earlier well-characterised vibrational spectrum. Transferral of the set of scale factors obtained for III to the QMFF's of I, II, IV and V was followed by calculation of the fundamental vibrational frequencies. Analysis of the results for these molecules revealed some peculiarities in the vibrational frequencies obtained at the pseudopotential level.

Vibrational spectra and ab initio analysis of tert-butyl, trimethylsilyl, trimethylgermyl, and trimethylstannyl derivatives of 3,3-dimethylcyclopropene VII. 3,3-Dimethyl-1-(trimethylstannyl) cyclopropene

The quantum mechanical force fields (QMFF's) of 3,3-dimethyl-1-(tert-butyl)cyclopropene (I), 3,3-dimethyl-1-(trimethylsilyl)cyclopropene (II), 3,3-dimethyl-1-(trimethylgermyl)cyclopropene (III), and 3,3-dimethyl-1-(trimethylstannyl)cyclopropene (IV) were calculated at the HF/3-21G*//HF/3-21G* level. The set of scale factors for the correction of HF/3-21G*//HF/3-21G* QMFF of II was determined using its well-characterised vibrational spectrum. Transferral of the set of scale factors obtained for II to the QMFF's of I, III and IV and calculation of the fundamental frequencies resulted in good agreement between the calculated and previously assigned experimental frequencies of III. This again demonstrates the feasibility of transferral of a set of scale factors obtained for the correction of the QMFF of a molecule to others containing heteroatoms from the same column of the Mendeleyev Periodic Table. Thus the calculations performed permitted the accurate assignment of the fundamental vibrational frequencies in the experimental IR spectrum of IV. The vibrational frequencies of 3,3-dimethyl-1-(tert-butyl)cyclopropene (I) were also calculated from the HF/6-31G*//HF/6-31G* QMFF, scaled by the set of scale factors used previously for the HF/6-31G*//HF/6-31G* QMFF's of II and III. Regularities in the trends of some vibrational frequencies with increasing atomic number of the heteroatom are observed.

Vibrational spectra and ab initio analysis of tert-butyl, trimethylsilyl, and trimethylgermyl derivatives of 3,3-dimethylcyclopropene. VI: Application of observed trends to stannyl derivatives

The effects of substitution of X = C by Si or Ge in X(CH(3))(3) moieties attached to the formal double bond of 3,3-dimethylcyclopropene are examined. Regularities in observed trends of vibrational frequencies implicating the moieties containing the X atom, as the X atomic mass is increased, are extrapolated to X = Sn. The results of this extrapolation made it possible to assign the known experimental vibrational frequencies of 3,3-dimethyl-1-(trimethylstannyl)cyclopropene and 3,3-dimethyl-1,2-bis(trimethylstannyl)cyclopropene.

Vibrational spectra and ab initio analysis of tert-butyl, trimethylsilyl, and trimethylgermyl derivatives of 3,3-dimethyl cyclopropene V. 3,3-dimethyl-1-(trimethylgermyl)cyclopropene

3,3-dimethyl-1-(trimethylgermyl)cyclopropene (I) was synthesised using a standard procedure. The IR and Raman spectra of I in the liquid phase were measured. The molecular geometry of I was optimised completely at the HF/6-31G* level. The HF/6-31G*//HF/6-31G* force field was calculated and scaled using the set of scale factors transferred from those determined previously for scaling the theoretical force fields of 3,3-dimethylbutene-1 and 1-methyl-, 1,2-dimethyl-, and 3,3-dimethylcyclopropene. The assignments of the observed vibrational bands were performed using the theoretical frequencies calculated from the scaled HF/6-31G*//HF/6-31G* force field and the ab initio values of the IR intensities, Raman cross-sections and depolarisation ratios. The theoretical spectra are given. The completely optimised structural parameters of I and its vibrational frequencies are compared with corresponding data of related molecules.