Determination of cannabinoids by gas chromatography-mass spectrometry and large-volume programmed-temperature vaporiser injection using 25 microl of biological fluid

Cannabis Sativa L.: a comprehensive review on the analytical methodologies for cannabinoids and terpenes characterization

The global Cannabis Sativa market, including essential oils, foods, personal-care products, and medical formulations has gained much attention over the last years due to the favorable regulatory framework. Undoubtedly, the enormous interest about cannabis cultivation mainly derives from the well-known pharmacological properties of cannabinoids and terpenes biosynthesized by the plants. In this review, the most recently used analytical methodologies for detecting both cannabinoids and terpenes are described. Well-established and innovative extraction protocols, and chromatographic separations, such as GC and HPLC, are reviewed highlighting their respective advantages and drawbacks. Lastly, GC × GC techniques are also reported for accurate identification and quantification of terpenes in complex cannabis matrices.

Simultaneous determination of major phytocannabinoids, their main metabolites, and common synthetic cannabinoids in urine samples by LC-MS/MS

Simultaneous determination of major phytocannabinoids (THC, CBD, CBN), their main metabolites (11-OH-THC, THC-COOH, THC-COOH-glucuronide) and common synthetic cannabinoids (HU-210, JWH-018, JWH-073, JWH-250) remains an issue in forensic toxicology. The present study has developed a liquid chromatography-tandem mass spectrometry (LC-MS/MS) method to simultaneously detect the above 10 analytes in human urine samples. The chromatographic separation was performed on an ACQUITY UPLC(®)BEH Phenyl 1.7μm (2.1×100mm) column, using a mobile phase consisting of 0.1% formic acid in water and acetonitrile at a flow rate of 0.3mL/min in gradient elution mode. The limit of detection (LOD) and limit of quantification (LOQ) of all analytes were 0.01-0.5ng/mL and 0.05-1ng/mL, respectively. The assay was linear from LOQ to 100ng/mL for phytocannabinoids, their main metabolites and HU-210, and from 0.05 to 50ng/mL for JWH-250, JWH-018 and JWH-073. The extraction recoveries were over 50% and the matrix effects were between 59.4% and 100.1%. The accuracy and precision were <10.4% of bias and <10.5% of relative standard deviation (RSD), respectively. The developed method was applied to 5 urine samples from real caseworks, and the results that THC metabolites together with synthetic cannabinoids were detected demonstrated the effectiveness of our method.

Critical evaluation of the determination of pharmaceuticals, personal care products, phenolic endocrine disrupters and faecal steroids by GC/MS and PTV-GC/MS in environmental waters

An analytical method is described for the determination of a broad range of emerging and priority pollutants, together with sewage molecular markers in environmental waters. The step-by-step study of the GC/MS analyses focuses on the effects of experimental variables using a large volume injection (LVI) technique [a programmed temperature-vaporising (PTV) inlet], the evaluation of a clean-up step using classical and newer sorbents (i.e. Al-N, Fl, NH(2), PSA, Si, CN and DIOL), and the revision of how organic matter [i.e. humic acids (HA) content] affects method performance. Reproducibility and recoveries from spiked coastal water samples at different analyte concentrations (100, 250 and 500 ng L(-1)) as well as with different levels of spiked humic acids (2, 10 and 20 mg L(-1)) are reported indicating a good performance of the extraction procedure with low levels of HA (<10 mg L(-1)). The presence of HA is a critical parameter during the solid-phase extraction (SPE) procedures. Of the clean-up sorbents tested, CN and DIOL proved most efficient in cleaning-up the extracts with recoveries in the range of 66-77% and 100-114%, respectively for the selected analytes. Both GC/MS and PTV-GC/MS instrumental configurations were tested using final sewage effluents, riverine, estuarine and coastal water samples. However, limited applicability of the PTV inlet is reported for environmental applications, affording only a modest improvement in chromatographic signal-to-noise ratios.

Bioanalytical procedures for determination of drugs of abuse in blood

Determination of drugs of abuse in blood is of great importance in clinical and forensic toxicology. This review describes procedures for detection of the following drugs of abuse and their metabolites in whole blood, plasma or serum: Delta9-tetrahydrocannabinol, 11-hydroxy-Delta9-tetrahydrocannabinol, 11-nor-9-carboxy-Delta9-tetrahydrocannabinol, 11-nor-9-carboxy-Delta9-tetrahydrocannabinol glucuronide, heroin, 6-monoacetylmorphine, morphine, morphine-6-glucuronide, morphine-3-glucuronide, codeine, amphetamine, methamphetamine, 3,4-methylenedioxymethamphetamine, N-ethyl-3,4-methylenedioxyamphetamine, 3,4-methylenedioxyamphetamine, cocaine, benzoylecgonine, ecgonine methyl ester, cocaethylene, other cocaine metabolites or pyrolysis products (norcocaine, norcocaethylene, norbenzoylecgonine, m-hydroxycocaine, p-hydroxycocaine, m-hydroxybenzoylecgonine, p-hydroxybenzoylecgonine, ethyl ecgonine, ecgonine, anhydroecgonine methyl ester, anhydroecgonine ethyl ester, anhydroecgonine, noranhydroecgonine, N-hydroxynorcocaine, cocaine N-oxide, anhydroecgonine methyl ester N-oxide). Metabolites and degradation products which are recommended to be monitored for assessment in clinical or forensic toxicology are mentioned. Papers written in English between 2002 and the beginning of 2007 are reviewed. Analytical methods are assessed for their suitability in forensic toxicology, where special requirements have to be met. For many of the analytes sensitive immunological methods for screening are available. Screening and confirmation is mostly done by gas chromatography (GC)-mass spectrometry (MS) or liquid chromatography (LC)-MS(/MS) procedures. Basic information about the biosample assayed, internal standard, workup, GC or LC column and mobile phase, detection mode, and validation data for each procedure is summarized in two tables to facilitate the selection of a method suitable for a specific analytic problem.

Recent developments in extraction procedures relevant to analytical toxicology

Sample preparation is an important step in the development of an analytical method but is often regarded as time-consuming, laborious work. Optimum sample preparation leads to enhanced selectivity and sensitivity, however, and reduces amounts of interfering matrix compounds, resulting in less signal suppression or enhancement. Recent developments in extraction techniques that could be of interest in clinical and forensic toxicology, for example liquid-liquid, solid-phase, and headspace extraction, are summarized in this review. The advantages and disadvantages of several extraction techniques are discussed, to enable the reader to choose an appropriate method of extraction for his or her application. Attention is paid to current trends in analytical toxicology, for example miniaturization, high throughput, and automation.

Determination of multiclass pesticide residues in apple juice by gas chromatography–mass spectrometry with large-volume injection

This study presents two GC-MS SIM methods, in combination with large-volume injection programmed-temperature vaporization (LVI-PTV) injection, for the determination of 141 pesticide residues in apple juice. The sample was extracted with ACN, and coextractives were removed with primary/secondary amine sorbent. ACN extract (20 microL) was injected into a PTV injection port in solvent vent mode, and the pesticides were determined by GC-MS using retention time locking software. Deuterium-labeled pesticides (surrogate standards) were used for analytical quality control. In the validation experiments, pesticides recoveries were found to be 70-121% with RSDs of 4.6-21% (n = 6).