Coagulation of homogenized milk particles by rennet

Clotting Properties of Onopordum tauricum (Willd.) Aqueous Extract in Milk of Different Species

Plant proteases used in cheesemaking are easily available and could increase the acceptability of cheeses, otherwise hindered by ethical issues (e.g., religions, dietary habits, aversion to genetically engineered food and food ingredients). The milk clotting potential of Onopordum tauricum (Willd.) aqueous extract as an alternative to animal rennet was assessed for the first time in milk of different species (ewe, goat, cow). Among the aerial anatomical parts, i.e., receptacle, leaves, stems, and flowers, only the latter ones showed clotting properties. A response surface methodology (RSM) was used to explore the effects of three independent variables (temperature, pH, volume of coagulant) on the milk clotting activity (MCA) of the flower extract. A second-order polynomial model adequately described the experimental data and predicted a temperature value of 55 °C, a pH value of 4.9–5.7, and a volume of coagulant of 300–500 μL (added to 5 mL of milk) as optimal conditions to maximize the MCA. At a 35 °C temperature and natural milk pH of 6.7–6.8, the estimated MCA of the O. tauricum extract was 72–87, 69–86, and 75–151, in goat’s, ewe’s, and cow’s milk, respectively. In comparison, the MCA of calf rennet was 5.4–4.9, 3.3–14.7, and 4.9–16.7 times higher than that of the plant extract in goat’s, ewe’s, and cow’s milk, respectively.

Ultra-high pressure homogenisation of milk: technological aspects of cheese-making and microbial shelf life of a starter-free fresh cheese

Fresh cheeses from pasteurised (80°C for 15 s), homogenised–pasteurised (15+3 MPa at 60°C; 80°C for 15 s) or ultra-high pressure homogenised milks (300 MPa and inlet temperature of 30°C) were produced in order to evaluate different technological aspects during cheese-making and to study their microbial shelf life. Although the coagulation properties of milk were enhanced by ultra-high pressure homogenisation (UHPH), the cheese-making properties were somewhat altered; both conventional homogenisation and UHPH of milk provoked some difficulties at cutting the curd due to crumbling and improper curd matting due to poor cohesion of the grains. Cheese-milk obtained by UHPH showed a higher microbiological quality than milk obtained by conventional treatments. Starter-free fresh cheeses made from UHPH-treated milk showed less syneresis during storage and longer microbiological shelf-life than those from conventionally treated milk samples.

Centrifugal fractionation of homogenized milks

A set of 12 fractions was isolated from homogenized cows' milk by a method of successive centrifugation steps. The fractions were analysed in terms of fat and protein contents and the diameters of the particles in them were also measured. Detailed comparisons of the turbidities of the samples and their light scattering properties allows comparison between them. It is concluded that the separation is less effective than a similar technique applied to casein micelles, but nonetheless that the different fractions do contain particles with different properties.

Effect of pH, calcium concentration and temperature on the evolution of the refractometric signal produced during rennet coagulation of milk

An industrial refractometer connected to a microcomputer was used to study the rennet coagulation of milk. The amplitude of the refractometer's signal changes during coagulation was about 104 times more important than the resolution of the computerized refractometer. The signal v. time derivatives were calculated and the inflection point time (ti) was correlated with pH, Ca concentration and temperature. The inflection point time was inversely proportional to the rennet and Ca concentrations and the logarithm of the proportionality factor (k) was linearly correlated with pH. The relation between ti and temperature was curvilinear. It is concluded that the refractometer tested could be used for research on the coagulation process.

Effect of heat treatments on the incorporation of milk serum proteins into the fat globule membrane of homogenized milk

The incorporation of serum proteins into the synthetic fat globule membrane in milks that had been heated and subsequently homogenized has been quantitatively determined using electrophoresis and densitometry. The results indicated that the amounts of serum proteins present in the fat globule membrane were smaller in milk that was heated before homogenization than in milk that had been homogenized and then heated. The thickness of the adsorbed layer of protein on the surfaces of the fat particles, measured using photon correlation spectroscopy in dissociating and non-dissociating buffer solutions, was also lower in the former case (∼ 20 nm) compared with the latter (∼ 34 nm). The kinetics of adsorption of both β–lactoglobulin and α-lactalbumin in heated homogenized milk on the vacant ‘sites’ on the synthetic fat globule membrane followed similar trends at 75 and 90 °C.

Effects of Ultra-High Pressure Homogenization on the Cheese-Making Properties of Milk

The effects of single- or 2-stage ultra-high pressure homogenization (UHPH; 100 to 330 MPa) at an inlet temperature of 30 degrees C on the cheese-making properties of bovine milk were investigated. Effects were compared with those from raw, heat-pasteurized (72 degrees C for 15 s), and conventional homogenized-pasteurized (15 + 3 MPa, 72 degrees C for 15 s) treatments. Rennet coagulation time, rate of curd firming, curd firmness, wet yield, and moisture content of curds were assessed. Results of particle size and distribution of milk, whey composition, and gel microstructure observed by confocal laser scanning microscopy were analyzed to understand the effect of UHPH. Single-stage UHPH at 200 and 300 MPa enhanced rennet coagulation properties. However, these properties were negatively affected by the use of the UHPH secondary stage. Increasing the pressure led to higher yields and moisture content of curds. The improvement in the cheese-making properties of milk by UHPH could be explained by changes to the protein-fat structures due to the combined effect of heat and homogenization.

Native vs. damaged milk fat globules: membrane properties affect the viscoelasticity of milk gels

The storage modulus G' of rennet and acid milk gels filled with milk fat globules was measured as a function of the fat globule surface composition (native milk fat globule membrane, caseins and whey proteins, or a mixture of the three due to mechanical treatments) and surface area (i.e., the fat globule size). By different technological procedures, it was possible to obtain fat globules of constant surface composition but various sizes, and vice-versa, which had never been done. For both rennet and acid gels, a critical fraction of the fat globule surface covered by caseins and whey proteins was identified (approximately 40%), beyond which G' increased. Below this threshold, the gel viscoelasticity was unaffected by mechanical treatments. When the diameter of native milk fat globules decreased, the G' of rennet gels increased slightly, whereas that of acid gels decreased sharply. For both types of gels, G' increased when the diameter of partially disrupted fat globules decreased. For recombined globules completely covered with caseins and few whey proteins, G' increased with fat globule surface area for rennet gels whereas it decreased for acid gels. With the help of confocal microscopy and in the light of general structural differences between rennet and acid gels, a mechanism is proposed for the effect of fat globule damage and diameter on G', depending on the interactions the globules can undergo with the casein network.

Chemical species in cheese and their origin in milk components

Cheese making is the process of concentrating milk fat and protein by separation from water and soluble components. The objective of the cheese maker is to maximize yield efficiency by optimum utilization of each milk component while not compromising cheese quality. Cheese yielding potential of milk may be increased by selective breeding for specific protein genotypes, especially the BB variant of both kappa-casein and beta-lactoglobulin. Milk fat is included in cheese by occlusion into the protein coagulum. Participation of casein in both lactic and rennet coagulation is nearly complete so that casein losses to the whey occur mainly during cutting and the early stages of cooking. In lactic cheese, excepting cottage cheese, it is possible to eliminate losses of fines by centrifugal or membrane separation of curd. In heat-acid precipitated varieties protein recovery is increased by inclusion of whey proteins but fat recovery is very dependent on coagulation conditions. In ripened cheese obtaining the correct basic structure and composition is critical to texture and flavour development during curing.