Oxidation State-Differentiated Measurement of Aqueous Inorganic Arsenic by Continuous Flow Electrochemical Arsine Generation Coupled to Gas-Phase Chemiluminescence Detection

Gas-phase chemiluminescence of reactive negative ions evolved through corona discharge in air and O2 atmospheres

The reactive performance of negative ions evolved in air and O₂ atmospheres through a gas-phase chemiluminescence method was investigated.

The application of a G-quadruplex based assay with an iridium(iii) complex to arsenic ion detection and its utilization in a microfluidic chip

In this work, the iridium(iii) complex 1 was synthesized and employed in constructing an assay which is based on a G-quadruplex for detecting arsenic ions in aqueous solution.

Electrochemical generation of antimony volatile species, stibine, using gold and silver mercury amalgamated cathodes and determination of Sb by flame atomic absorption spectrometry

The electrochemical generation of antimony volatile species (stibine) using Au and Ag mercury amalgamated cathodes is described. Compared with some other cathode materials commonly used for electrochemical hydride generation, performance of the amalgamated cathodes is substantially better in the following aspects: higher interference tolerance, higher erosion resistance and longer useful working time. Using the amalgamated cathodes, it could be shown that interferences from major constituents at high concentrations, especially from transition metals, affecting stibine generation are not as significant as they are using other cathode types in regards to sensitivity and useful working time. Results obtained using the Ag/Hg amalgamated cathode showed a slightly higher sensitivity than the corresponding results obtained using the Au/Hg cathode. The Au/Hg cathode, which to our knowledge has not previously been used to generate stibine, showed considerably longer useful working time than the Ag/Hg one. The optimum catholytes for electrolytic generation of stibine (SbH3) from Sb(III) and Sb(V) using the Au/Hg electrode were aqueous solutions containing 0.5mol L(-1) H2SO4 and 0.5mol L(-1)HCl, respectively. Under optimized conditions, using the Au/Hg cathode and comparing to aqueous standards calibration curves, detection limits (3σ) of 0.027µg L(-1) for Sb(III) and 0.056µg L(-1) for Sb(V), were obtained. To check accuracy a marine sediment reference material (PACS-2, NRC) was analyzed using a method purportedly developed for this task. Good agreement, 95% confidence, was found between the certified and the experimental values for Sb. The proposed method was also applied to the determination of Sb in aqueous solutions of marine sediments samples from Comuna de Bajo Alto Provincia de El Oro-Ecuador. Recoveries of five replicate determinations of these samples were in the range of 98-103% thus showing acceptable accuracy in the analysis of real samples.

A nanogold resonance Rayleigh scattering method for determination of trace As based on the hydride nanoreaction

In H2 SO4 solution, As(III) was reduced to arsine (AsH3 ) by NaBH4 , and was absorbed in HAuCl4 solution to form nanogold particles (NGs) that exhibited a resonance Rayleigh scattering (RRS) effect at 370 nm. Under the selected conditions, when the As(III) concentration increased the RRS peak also increased due to the formation of more NGs. There was a linear correlation between RRS intensity and As(III) concentration in the range 6-1000 ng/mL, with a detection limit of 3 ng/mL. This new hydride generation-nanogold reaction RRS (HG-NG RRS) method was applied to determine trace amounts of As in milk samples, with satisfactory results.

A paper based microfluidic device for the detection of arsenic using a gold nanosensor

A paper based microfluidic device is fabricated that can rapidly detect very low concentrations of As³⁺ ions using a gold nanosensor, Au–TA–TG.