Adaptive Two-Dimensional Microgas Chromatography

In-Line Detection with Microfluidic Bulk Acoustic Wave Resonator Gas Sensor for Gas Chromatography

A microfluidic film bulk acoustic wave resonator gas sensor (mFBAR) adapted specifically as an in-line detector in gas chromatography was described. This miniaturized vapor sensor was a non-destructive detector with very low dead volume (0.02 μL). It was prepared by enclosing the resonator in a microfluidic channel on a chip with dimensions of only 15 mm × 15 mm × 1 mm. The device with polymer coating showed satisfactory performance in the detection of organophosphorus compound, demonstrating a very low detection limit (a dozen parts per billion) with relatively short response time (about fifteen seconds) toward the simulant of chemical warfare agent, dimethyl methylphosphonate. The in-line detection of the mFBAR sensor with FID was constructed and employed to directly measure the concentration profile on the solid surface by the mFBAR with the controlled concentration profile in the mobile phase at the same time. The difference of peak-maximum position between mobile phase and solid phase could be a convenient indicator to measure mass transfer rate. With the response of the mFBAR and FID obtained in one injection, an injection mass-independent parameter can be calculated and used to identify the analyte of interest.

Parallel Ionic Liquid Semi-Packed Microfabricated Columns for Complex Gas Analysis

The paper presents a parallel micro gas chromatography approach using three ionic liquid semipacked columns. Switching from single column to multiple parallel columns with different selectivity enhances the power of compound identification without increasing the analysis time. The columns are fabricated using microelectromechanical systems (MEMS) technology containing an array of microfabricated pillars. The columns are 1 m-long and 240 μm-deep with four pillars per row. All columns were functionalized with ionic liquid stationary phases using a modified static coating technique and demonstrated the number of theoretical plates between 5000 and 8300 per meter. The chip performance was investigated with four different samples: (1) a mixture of C7-C30 saturated alkanes, (2) a multianalyte mixture consisting of 20 compounds ranging from 80 to 238 °C in boiling point, (3) a mixture of five organic chemicals with varying degrees of polarity, and (4) 46-compounds mixture containing all the chemicals in the first three samples. The individual columns separated 75%-100% of the first three samples but failed to distinguish all 46 compounds due to coeluting analytes; however, the parallel configuration provided more retention time information by which all the compounds in all samples were fully determined.

Development of a Novel Micro Photoionization Detector for Rapid Volatile Organic Compounds Measurement

The simulation of the gas flow field and electrostatic field in the photoionization detector by COMSOL was conducted based on principle investigation in the present study. Under the guidance of simulation results, structural optimization was carried out to significantly reduce the dead volume of the ionization chamber, and finally, the relationship between offset voltage and collection efficiency was obtained which led to a remarkable increase in the collection efficiency of charged ions in the photoionization detector. Then an ionization chamber with low interference and fast response was developed. Then experiment was performed with toluene as a VOCs gas under the condition of optimal gas flow rate of 50 ml, UV lamp ionization energy of 10.86 eV. The results showed that the ion collection efficiency reached 91% at a bias voltage of 150 V. Moreover, a preferred linearity of 99.99% was obtained, and a ppb level of LOD can be achieved. The determination results well-fitted the relationship between offset voltage and the response value obtained in the simulation.

A miniature closed-loop gas chromatography system

This paper reports the characterization of a miniaturized circulatory column system that is capable of magnifying the effective column length by forming a circulatory loop with chip-scale columns, thus ultimately achieving high-efficiency target separation. The circulatory column system is composed of a tandem of 25 cm microcolumns and six valves for fluidic flow control in order to enable chromatographic separation in circulatory motions while requiring only 5.5 kPa of pressure, which current micropumps are currently capable of supplying. The developed column system (1) successfully demonstrated 16 times elongation of a virtual column length up to 800 cm by only utilizing two 25 cm microcolumns, which is the longest column length reported by any MEMS-scale functioning GC column, (2) achieved a high theoretical plate number of 68,696 with pentane circulating after 15.5 circulatory cycles, which corresponds to the plate number per length-pressure of 1611 plate m(-1) kPa(-1), the highest record reported yet, and (3) demonstrated successful separation of target molecules during circulation by utilizing a pentane/hexane mixture, resulting in magnification of the two corresponding peaks via circulation.

Smart three-dimensional gas chromatography

We developed a complete computer-controlled smart 3-dimensional gas chromatography (3-D GC) system with an automation algorithm. This smart 3-D GC architecture enabled independent optimization of and control over each dimension of separation and allowed for much longer separation time for the second- and third-dimensional columns than the conventional comprehensive 3-D GC could normally achieve. Therefore, it can potentially be employed to construct a novel GC system that exploits the multidimensional separation capability to a greater extent. In this Article, we introduced the smart 3-D GC concept, described its operation, and demonstrated its feasibility by separating 22 vapor analytes.

Smart multi-channel two-dimensional micro-gas chromatography for rapid workplace hazardous volatile organic compounds measurement

We developed a novel smart multi-channel two-dimensional (2-D) micro-gas chromatography (μGC) architecture that shows promise to significantly improve 2-D μGC performance. In the smart μGC design, a non-destructive on-column gas detector and a flow routing system are installed between the first dimensional separation column and multiple second dimensional separation columns. The effluent from the first dimensional column is monitored in real-time and decision is then made to route the effluent to one of the second dimensional columns for further separation. As compared to the conventional 2-D μGC, the greatest benefit of the smart multi-channel 2-D μGC architecture is the enhanced separation capability of the second dimensional column and hence the overall 2-D GC performance. All the second dimensional columns are independent of each other, and their coating, length, flow rate and temperature can be customized for best separation results. In particular, there is no more constraint on the upper limit of the second dimensional column length and separation time in our architecture. Such flexibility is critical when long second dimensional separation is needed for optimal gas analysis. In addition, the smart μGC is advantageous in terms of elimination of the power intensive thermal modulator, higher peak amplitude enhancement, simplified 2-D chromatogram re-construction and potential scalability to higher dimensional separation. In this paper, we first constructed a complete smart 1 × 2 channel 2-D μGC system, along with an algorithm for automated control/operation of the system. We then characterized and optimized this μGC system, and finally employed it in two important applications that highlight its uniqueness and advantages, i.e., analysis of 31 workplace hazardous volatile organic compounds, and rapid detection and identification of target gas analytes from interference background.