Dielectric barrier electrospray-polarity cycle and trigger

Coupling Miniaturized Free-Flow Electrophoresis to Mass Spectrometry via a Multi-Emitter ESI Interface

We present a novel multi-emitter electrospray ionization (ESI) interface for the coupling of microfluidic free-flow electrophoresis (μFFE) with mass spectrometry (MS). The effluents of the μFFE outlets are analyzed in near real-time, allowing a direct optimization of the electrophoretic separation and an online monitoring of qualitative sample compositions. The short measurement time of just a few seconds for all outlets even enables a reasonable time-dependent monitoring. As a proof of concept, we employ the multi-emitter ESI interface for the continuous identification of analytes at 15 μFFE outlets via MS to optimize the μFFE separation of important players of cellular respiration in operando. The results indicate great potential of the presented system in downstream processing control, for example, for the monitoring and purification of products in continuous-flow microreactors.

Electrospray Modifications for Advancing Mass Spectrometric Analysis

Generation of analyte ions in gas phase is a primary requirement for mass spectrometric analysis. One of the ionization techniques that can be used to generate gas phase ions is electrospray ionization (ESI). ESI is a soft ionization method that can be used to analyze analytes ranging from small organics to large biomolecules. Numerous ionization techniques derived from ESI have been reported in the past two decades. These ion sources are aimed to achieve simplicity and ease of operation. Many of these ionization methods allow the flexibility for elimination or minimization of sample preparation steps prior to mass spectrometric analysis. Such ion sources have opened up new possibilities for taking scientific challenges, which might be limited by the conventional ESI technique. Thus, the number of ESI variants continues to increase. This review provides an overview of ionization techniques based on the use of electrospray reported in recent years. Also, a brief discussion on the instrumentation, underlying processes, and selected applications is also presented.

Binding States of Protein-Metal Complexes in Cells

The identification of endogenous proteins as well as their binding to metal ions in living cells is determined by combining pulsed electrophoretic separations with nanoelectrospray ionization followed by mass spectrometric detection. This approach avoids problems resulting from the complicated cellular environment. In this manner, we demonstrate the rapid identification (300 ms or less) of intact proteins from living E. coli cells including the complexation of calmodulin with calcium ion. The latter showed different binding states from those observed in in vitro studies. These observations also reveal in vitro measurements do not necessarily represent the actual situation in living cells. We conclude that the attempted in situ measurement of intracellular proteins with minimal sampling processes should be preferred.

Alleviation of electrochemical oxidation for peptides and proteins in electrospray ionization: obtaining more accurate mass spectra with induced high voltage

Accurate mass spectrometry (MS) signal for peptide/protein analysis, which could be affected by various MS conditions, plays an essential role in identification and quantification of biological samples. Herein, we tried to alleviate the possible interferences from electrochemical oxidations during electrospray ionization (ESI). Three most common electrochemical oxidation reactions in ESI include oxidation of analyte, solvent, and electrode. With introduction of induced electrospray ionization (IESI) (a variant form of ESI), these interferences were significantly alleviated for peptides/proteins. That effect was also tested with flow injection experiments with different solution flow rates, electrolyte concentrations and solvent compositions, which was to simulate various chromatography conditions in conventional liquid chromatography (LC) separations. For all chromatography conditions tested, electrochemical oxidation was significantly alleviated for the absence of physical contact between spray solution and electrode.