Online Biogenic Carbon Analysis Enables Refineries to Reduce Carbon Footprint during Coprocessing Biomass- and Petroleum-Derived Liquids

Efficient preparation of hybrid biofuels from biomass-derived 5-(acetoxymethyl)furfural and petroleum-derived aromatic hydrocarbons

Fuel candidates containing both petroleum-derived and biomass-derived molecules in their structural motifs ensure both feedstocks are used optimally and coherently. This work reports a straightforward and efficient preparation of 5-(arylmethyl)furfurals (AMFFs), 2-(arylmethyl)furans (AMFs), and 2-(arylmethyl)-5-methylfurans (AMMFs) as hybrid biofuels (or fuel oxygenates) starting from carbohydrate-derived 5-(acetoxymethyl)furfural (AcMF) and petroleum-derived aromatic hydrocarbons. The AMFFs were prepared by Friedel-Crafts reaction between AcMF and aromatic hydrocarbons (e.g., BTX, mesitylene) by employing anhydrous ZnCl2 as the catalyst. AMFs were prepared by decarbonylation of AMFFs over the Pd(OAc)2 catalyst under solvent-free conditions. In contrast, AMMFs were produced by hydrogenating AMFFs in methanol using gaseous hydrogen and the 10% Pd/C catalyst. The catalytic transformations were optimized on various parameters, and all the biofuel candidates were obtained in good to excellent isolated yields (>80%) under moderate conditions.

Room-Temperature Optical Detection of 14CO2 below the Natural Abundance with Two-Color Cavity Ring-Down Spectroscopy

Radiocarbon's natural production, radiative decay, and isotopic rarity make it a unique tool to probe carbonaceous systems in the life and earth sciences. However, the difficulty of current radiocarbon (14C) detection methods limits scientific adoption. Here, two-color cavity ring-down spectroscopy detects 14CO2 in room-temperature samples with an accuracy of one-tenth the natural abundance in 3 min. The intracavity pump-probe measurement uses two cavity-enhanced lasers to cancel out cavity ring-down rate fluctuations and strong one-photon absorption interference (>10 000 1/s) from hot-band transitions of CO2 isotopologues. Selective, room-temperature detection of small 14CO2 absorption signals (<1 1/s) reduces the technical and operational burdens for cavity-enhanced measurements of radiocarbon, which can benefit a wide range of applications like biomedical research and field-detection of combusted fossil fuels.

Fractional Condensation of Fast Pyrolysis Bio-Oil to Improve Biocrude Quality towards Alternative Fuels Production

Fast pyrolysis of biomass is a well-known opportunity for sustainable alternative fuel production for transport and energy. However, bio-oils from biomass pyrolysis are viscous, acidic bio-crudes that need further steps of upgrading before being used either as fuels or chemicals. A process that is complementary to bio-oil hydrotreatment or co-processing consists of optimizing and tuning the upstream condensation steps of fast pyrolysis to separate and concentrate selected classes of compounds. This can be implemented by varying the condensation temperatures in a multi-step condensation unit. In this study, fractional condensation of fast pyrolysis vapors from pinewood has been applied to a bubbling fluidized bed reactor of 1 kg h−1 feed. The reactor was operated at 500 °C and connected to a downstream interchangeable condensation unit. Tests were performed using two different condensing layouts: (1) a series of two spray condensers and a tube-in-tube water-jacketed condenser, referred to as an intensive cooler; (2) an electrostatic precipitator and the intensive cooler. Using the first configuration, which is the focus of this study, high boiling point compounds—such as sugars and lignin-derived oligomers—were condensed at higher temperatures in the first stage (100–170 °C), while water-soluble lighter compounds and most of the water was condensed at lower temperatures and thus largely removed from the bio-oil. In the first two condensing stages, the bio-oil water content remained below 7% in mass (and therefore, the oil’s high calorific content reached 22 MJ kg−1) while achieving about 43% liquid yield, compared to 55% from the single-step condensation runs. Results were finally elaborated to perform a preliminary energy assessment of the whole system toward the potential upscaling of this fractional condensation approach. The proposed layout showed a significant potential for the upstream condensation step, simplifying the downstream upgrading stages for alternative fuel production from fast pyrolysis bio-oil.

Surface Properties and Liquid Crystal Properties of Alkyltetra(oxyethyl) β-d-Glucopyranoside

Hydrophilic alkyl polyglycosides (APGs) and alkyl glycosides (AGs) with anomeric pure are a class of important substitutes for petroleum-based surfactants. Improving their water solubility should make such hydrophilic glycosurfactants have more excellent potential application value. To solve the inherent problem of poor water solubility of traditional alkyl β-d-glucopyranoside (5), a series of alkyltetra(oxyethyl) β-d-glucopyranosides (4a-4g, n = 7-18) were successfully synthesized by introducing tetra(oxyethylene) fragments to carry out the structural modification. The relationship between the related structure and the physicochemical properties was further investigated, including their hydrophilic-lipophilic balance (HLB), water-solubility, foaming performance, emulsification, hygroscopicity, surface activity, and thermotropic/lyotropic liquid crystal phase behavior. The results showed that the water solubility gradually decreased as the alkyl chain length increased due to the gradual decrease of their HLB number. Octadecyltetra(oxyethyl) β-d-glucopyranoside (4g, n = 18) was found to be insoluble in water at 25 °C. Taken together, long-chain alkyl glycosides had good foaming properties and excellent emulsifying properties. Among them, dodecyltetra(oxyethyl) β-d-glucopyranoside (4d, n = 12) had the best foaming performance. In the rapeseed oil/water system, cetyltetra(oxyethyl) β-d-glucopyranoside (4f, n = 16) had the best emulsifying ability. With the increase of the alkyl chain length, the critical micelle concentration (C_cmc), γ_cmc, Γ_max, and hygroscopicity of this series of glycosides showed a downward trend. Differential scanning calorimetry (DSC) and polarizing optical microscopy (POM) showed that the thermal stability increased with the increase of the alkyl chain length, and alkyltetra(oxyethyl) β-d-glucopyranosides (4d-4g, n = 12-18) had the corresponding melting points and clearing points. Alkyltetra(oxyethyl) β-d-glucopyranosides (4b-4g, n = 8-18) formed a smectic phase with a typical fan-shaped and focal conic texture during the cooling process. In the water contact experiments, it was found that glycosides (4b-4g, n = 8-18) at high concentrations transformed into various lyotropic liquid crystal including hexagonal phase, bicontinuous cubic phase, and lamellar phase phases. Therefore, such green nonionic glycosurfactants alkyltetra(oxyethyl) β-d-glucopyranosides should have potential practical application prospects.