Highly Sensitive Photoelectrochemical Biosensor for MicroRNA-21 Based on a Dumbbell-Shaped Heterostructure AuNRs@end-TiO2 Combined with Carbon Dots as Photosensitizers and Duplex-Specific Nuclease-Assisted Signal Amplification

A signal-on photoelectrochemical aptasensor based on ferrocene labeled triple helix DNA molecular switch for detection of antibiotic amoxicillin

A sensitive signal-on photoelectrochemical aptasensor for antibiotic determination was constructed based on the energy level matching between ferrocene and CuInS2. P-type CuInS2 microflower was complexed with reduced graphene oxide (CuInS2/rGO) to get photocathode current with good photoelectric conversion efficiency and stability. Then, hairpin DNA (HP) was covalently bonded to the electrode surface. A triple helix DNA (THMS) was used as a molecular switch. After the specific recognition between target and THMS in homogeneous solution, ferrocene labeled probe (Fc-T2) was released. Finally, Fc-T2 was captured by the HP, which leaded the obvious increase of photocurrent for the energy level matching between ferrocene and CuInS2. The increase of the photocurrent signal was proportional to the concentration of target amoxicillin (AMOX), the linear range was 100 fM-100 nM with detection limit of 19.57 fM. Meanwhile, the method has been successfully applied for milk and lake water samples analysis with satisfactory results.

Rigidifying AIEgens in covalent organic framework nanosheets for electrochemiluminescence enhancement: TABE-PZ-CON as a novel emitter for microRNA-21 detection

Enhancing electrochemiluminescence (ECL) properties of luminophores is a hot direction in the current ECL field. Herein, we found that covalent rigidification of the aggregation-induced emission luminogens (AIEgens) TABE (TABE = tetra-(4-aldehyde-(1,1-biphenyl))ethylene) into covalent organic framework nanosheets (TABE-PZ-CON, PZ = piperazine) could result in stronger ECL emission than those of TABE aggregates and TABE monomers. We termed the interesting phenomenon "covalent rigidification-triggered electrochemiluminescence (CRT-ECL) enhancement". The superior ECL performance of TABE-PZ-CON not only because massive TABE luminogens were covalently assembled into the rigid TABE-PZ-CON network, which limited the intramolecular motions of TABE and hampered the radiationless transition, but also because the ultrathin porous TABE-PZ-CON significantly reduced the transportation distance of ions, electrons, and coreactants, which enabled the electrochemical excitation of more TABE luminogens and thus enhanced the ECL efficiency. Bearing in mind the exceptional ECL performance of TABE-PZ-CON, it was utilized as a high-efficient ECL indicator in combination with the DNA walker and duplex-specific nuclease-assisted target recycling amplification strategies to design an "off-on" ECL biosensor for the ultrasensitive assay of microRNA-21, exhibiting a favorable response range (100 aM-1 nM) with an ultralow detection limit of 17.9 aM. Overall, this work offers a valid way to inhibit the intramolecular motions of AIEgens for ECL enhancement, which gives a new vision for building high-performance AIEgen-based ECL materials, thus offering more chances for assembling hypersensitive ECL biosensors.

Self-Powered Biosensor Based on DNA Walkers for Ultrasensitive MicroRNA Detection

A novel self-powered biosensor is fabricated for ultrasensitive microRNA-21 (miRNA-21) detection, which includes an enzymatic biofuel cell (EBFC), DNA walkers, a digital multimeter (DMM), and a capacitor. As a novel strategy for signal amplification, DNA walkers are designed in the cathode, while the capacitor stores electrochemical energy from the EBFC to further boost the instantaneous current displayed by the DMM. When miRNA-21 is present, the DNA walkers are provoked to walk from as-opened hairpin structures to other hairpin structures, generating double-strand DNA structures, which stimulate [Ru(NH3)6]3+ to be adsorbed on the cathode surface by electrostatic interaction. Afterward, [Ru(NH3)6]3+ is reduced to [Ru(NH3)6]2+, and the open circuit voltage (EOCV) is significantly increased. Depending on the approach of signal amplification from DNA walkers, this biosensor displays an ultrasensitive assay toward miRNA-21 in the range of 0.5 to 104 fM, with a detection limit of 0.15 fM. In addition, this self-powered biosensor displays high selectivity for miRNA-21 assay in human serum samples.

Type-I heterojunction destruction by In situ formation of Bi2S3 for split-type photoelectrochemical aptasensor

Development of new strategies in photoelectrochemical (PEC) sensors is an important way to realize sensitive detection of biomolecule. In this study, mesoporous silica nanospheres (MSNs)-assisted split-type PEC aptasensor with in situ generation of Bi₂S₃ was proposed to achieve reliable detection of prostate-specific antigen (PSA). To be more specific, this bioresponsive release system will release large amounts of Na₂S by the reaction between PSA and aptamer that capped Na₂S-loading MSNs. Next, the Na₂S reacts with Bi to yield BiOI/BiOBr/Bi₂S₃ composite, which leads to an alteration in the electron-hole transfer pathway of the photoelectric material and a decrease in the response. As the PSA concentration increases, more Na₂S can be released and lower photocurrent is obtained. The linear range under the optimal experimental conditions is 10 pg·mL^-1-1 μg⋅mL^-1, and the detection limit is 1.23 pg⋅mL^-1, which has satisfactory stability and anti-interference.

A photoelectrochemical sensor for Hg2+ detection with enhanced cathodic photocurrent via BiOI/Bi2S3 photoanode of self-sacrifice

Due to the inherent merits of the anodic photoelectrochemical (PEC) sensor, it was widely utilized in the field of analytical chemistry. However, it must be noted that the anodic PEC sensor was susceptible to interference in practical applications. The situation with the cathodic PEC sensor was exactly the opposite. Therefore, this work fabricated a PEC sensor combining photoanode and photocathode that solved the defects of conventional PEC sensors in detecting Hg²⁺. Specifically, Na₂S solution was carefully dropped on the BiOI-modified indium-tin oxide (ITO) to obtain ITO/BiOI/Bi₂S₃ directly by self-sacrifice method and the resulting electrode was used as photoanode. In addition, a sequential modification process was employed to decorate the ITO substrate with Au nanoparticles (Au NPs), Cu₂O, and L-cysteine (L-cys), thereby realizing the fabrication of the photocathode. Moreover, the presence of Au NPs further amplified the photocurrent of the PEC platform. During the detection process, when Hg²⁺ is present it will bind to the L-cys, resulting in an increase in current, thus enabling sensitive detection of Hg²⁺. The proposed PEC platform exhibited good stability and reproducibility, providing a new idea for the detection of other heavy metal ions.

Synergistic Signal Amplification-Initiated Innovative Self-Powered Photoelectrochemical Aptasensing: An Ingenious Photocathode Activated by the High-Light-Harvesting Photoanode

Exploiting ingenious photoelectrodes and innovative signal amplification strategies has the potential to achieve high sensitivity in self-powered cathodic photoelectrochemical (PEC) analysis. In this work, a novel self-powered PEC sensing platform was constructed by integrating a synergistic signal amplification of an ingenious photocathode with a high light-harvesting photoanode. In the dual photoelectrode-based PEC system, the amplified photocurrent signals were induced by a synergistic enhancement: (1) the photocurrent of the BiOBr photocathode was improved by the incorporation of nitrogen-doped graphene; (2) the photocurrent of the self-powered sensor was activated by the high-light-harvesting Bi₂S₃-C₃N₄ photoanode. Subsequently, the rational mechanism for synergistic signal amplification was investigated. For the construction of the sensing interface, an aptamer was introduced as the recognition element to specifically capture the streptomycin (STR) target. Under optimal conditions, the constructed self-powered aptasensor has the merits of good linear range (1 × 10^-11 to 5 × 10^-7 M), acceptable limit of detection (1.18 × 10^-12 M), and excellent stability and selectivity for STR detection. Additionally, the proposed self-powered aptasensor showed acceptable accuracy for the detection of STR in water. Hopefully, this might stimulate more interest in designing and constructing novel platforms for exquisite photocathodic monitoring of various contaminants in the environment.

Self-Powered Biosensor for a Highly Efficient and Ultrasensitive Dual-Biomarker Assay

A dual-biomarker, self-powered biosensor was fabricated for the ultrasensitive detection of microRNA-21 (miRNA-21) and miRNA-155 based on enzymatic biofuel cells (EBFCs), catalytic hairpin assembly (CHA), and DNA hybridization chain reaction (HCR), with a capacitor and digital multimeter (DMM). In the presence of miRNA-21, the CHA and HCR are triggered and lead to the generation of a double-helix chain, which stimulates [Ru(NH₃)₆]³⁺ to move to the biocathode surface due to electrostatic interaction. Subsequently, the biocathode obtains electrons from the bioanode and reduces [Ru(NH₃)₆]³⁺ to [Ru(NH₃)₆]²⁺, which significantly increases the open-circuit voltage (E₁^OCV). When miRNA-155 is present, CHA and HCR cannot be completed, resulting in a low E₂^OCV. The self-powered biosensor allows for the simultaneous ultrasensitive detection of miRNA-21 and miRNA-155 with detection limits of 0.15 and 0.66 fM, respectively. Moreover, this self-powered biosensor exhibits the highly sensitive detection for miRNA-21 and miRNA-155 assay in human serum samples.