Dual-Stage Consumable-Free Thermal Modulator for the Hyphenation of Thermal Analysis, Gas Chromatography, and Mass Spectrometry

A fast temperature-programmed second-dimension column for comprehensive two-dimensional gas chromatography

The short analysis time and constant temperature environment in the second dimension of two-dimensional comprehensive chromatography frequently causes wraparound problems, especially for complex high boilers. This problem can be solved by temperature programming on the second column, but since this requires heating and cooling the column in a matter of seconds, it is difficult to implement. In this study, we describe a method of accomplishing rapid heating and cooling with a resistively heated column cooled by compressed air. Critical to this method is minimizing the lag time between the actual temperature and the reported temperature by using the column heating element as the temperature sensor, virtually eliminating the danger of overshooting the temperature setpoint. This technique facilitates a ramp rate of up to 100 °C/s with minimal overshooting-well beyond the requirements of gas chromatography. A single-layer column bundle design allows a compressed-air cooling device to cool the column from 200 to 50 °C at an average rate of -21 °C/s. The secondary dimension temperature programming is facilitated by the longer secondary dimension time made possible by the direct flow modulation method. We evaluated the performance of the single-layer column bundle and demonstrated this method by applying it to a gasoline sample. We also compared this method with the traditional isothermal approach and found that use of the secondary temperature program reduced the naphthalene retention time from 12.1 to 6.3 s and its peak width at half height from 846 to 126 ms.

Hyper-fast gas chromatography and single-photon ionisation time-of-flight mass spectrometry with integrated electrical modulator-based sampling for headspace and online VOC analyses

We developed a novel fast gas chromatography (fastGC) instrument with integrated sampling of volatile organic compounds (VOCs) and detection by single-photon ionisation (SPI) time-of-flight mass spectrometry (TOFMS). A consumable-free electrical modulator rapidly cools down to -55 °C to trap VOCs and inject them on a short chromatographic column by prompt heating to 300 °C, followed by carrier gas exchange from air to helium. Due to the low thermal mass and optical heating, the fastGC is operated within total runtimes including cooling for 30 s and 15 s, referring to hyper-fast GC, and at a constantly increasing temperature ramp from 30 °C to 280 °C. The application of soft SPI-TOFMS allows the detection of co-eluting VOCs of different molecular compositions, which cannot be resolved by conventional GC (cGC) with electron ionisation (EI). Among other analytical figures of merit, we achieved limits of detection for toluene and p-xylene of 2 ppb and 0.5 ppb, respectively, at a signal-to-noise ratio of 3 and a linear response over a range of more than five orders of magnitude. Furthermore, we demonstrate the performance of the instrument on samples from the fields of environmental research and food science by headspace analysis of roasted coffee beans and needles from coniferous trees as well as by quasi-real-time analysis of biomass burning emissions and coffee roast gas.

External trap-and-release membrane inlet for photoionization mass spectrometry: Towards fast direct analysis of aromatic pollutants in aquatic systems

RATIONALE

Fast and sensitive detection of aromatic hydrocarbons (AHs) in water is of high importance because of their significant impact on human health and the environment. For this, resonance-enhanced multiphoton ionization (REMPI) coupled to trap-and-release membrane-introduction mass spectrometry (T&R-MIMS) offers the possibility of sensitive on-line water analysis with a time resolution of minutes.

METHODS

REMPI is a versatile tool for sensitive gas-phase analysis, in which AHs are selectively ionized in complex gas mixtures by the subsequent absorption of at least two photons. In T&R-MIMS, selective extraction and enrichment of analytes from water can be achieved using semipermeable membranes. By the subsequent stimulated desorption of enriched compounds, mass spectrometric detection is enabled.

RESULTS

We present an external T&R inlet for hollow-fiber membranes coupled to REMPI time-of-flight mass spectrometry, which enables direct and sensitive detection of semi-volatile AHs in water. In laboratory experiments, spiked water samples were analyzed. For the investigated compounds, limits of detection (LODs) in the range 1-47 ng/L were determined. The LODs are approximately one order of magnitude lower than in a previously reported continuous membrane-introduction approach using a planar membrane. Further improvement of LOD may be realized by extending the trapping time and by increasing the release temperature. Furthermore, the system was applied to investigate different fuels suspended in water and real water samples. The obtained data are in good agreement with findings of a former study.

CONCLUSIONS

In the framework of the present study, we demonstrate the high potential of the combination of REMPI and T&R-MIMS in the form of a newly developed external hollow-fiber membrane inlet. With the developed system, semi-volatile AHs can be directly detected down to ng/L levels on a minute time scale. The approach thus may pave the way to future ship application in marine sciences, natural resources exploration or pollutant and hazard detection.