Predicting Concentration- and Ionic-Strength-Dependent Air-Water Interfacial Partitioning Parameters of PFASs Using Quantitative Structure-Property Relationships (QSPRs)

Preferential Partitioning of Per- and Polyfluoroalkyl Substances (PFAS) and Dissolved Organic Matter in Freshwater Surface Microlayer and Natural Foam

Per- and polyfluoroalkyl substances (PFAS) are surfactants that can accumulate in the surface microlayer (SML) and in natural foams, with potential elevated exposure for organisms at the water surface. However, the impact of water chemistry on PFAS accumulation in these matrices in freshwater systems is unknown. We quantified 36 PFAS in water, the SML, and natural foams from 43 rivers and lakes in Wisconsin, USA, alongside measurements of pH, cations, and dissolved organic carbon (DOC). PFAS partition to foams with concentration ranging 2300-328,200 ng/L in waters with 6-139 ng/L PFAS (sum of 36 analytes), corresponding to sodium-normalized enrichment factors ranging <50 to >7000. Similar enrichment is observed for DOC (∼70). PFAS partitioning to foams increases with increasing chain length and is positively correlated with [DOC]. Modest SML enrichment is observed for PFOS (1.4) and FOSA (2.4), while negligible enrichment is observed for other PFAS and DOC due to low specific surface area and turbulent conditions that inhibit surfactant accumulation. However, DOC composition in the SML is distinct from bulk water, as assessed using high-resolution mass spectrometry. This study demonstrates that natural foams in unimpacted and impacted waters can have elevated PFAS concentrations, whereas SML accumulation in surface waters is limited.

Per- and polyfluoroalkyl substances (PFAS) as contaminants in groundwater resources - A comprehensive review of subsurface transport processes

Per- and polyfluorinated alkyl substances (PFAS) are persistent contaminants in the environment. An increased awareness of adverse health effects related to PFAS has further led to stricter regulations for several of these substances in e.g. drinking water in many countries. Groundwater constitutes an important source of raw water for drinking water production. A thorough understanding of PFAS subsurface fate and transport mechanisms leading to contamination of groundwater resources is therefore essential for management of raw water resources. A review of scientific literature on the subject of processes affecting subsurface PFAS fate and transport was carried out. This article compiles the current knowledge of such processes, mainly focusing on perfluoroalkyl acids (PFAA), in soil- and groundwater systems. Further, a compilation of data on transport parameters such as solubility and distribution coefficients, as well as, insight gained and conclusions drawn from the reviewed material are presented. As the use of certain fire-fighting foams has been identified as the major source of groundwater contamination in many countries, research related to this type of pollution source has been given extra focus. Uptake of PFAS in biota is outside the scope of this review. The review showed a large spread in the magnitude of distribution coefficients and solubility for individual PFAS. Also, it is clear that the influence of multiple factors makes site-specific evaluation of distribution coefficients valuable. This article aims at giving the reader a comprehensive overview of the subject, and providing a base for further work.

Air-water interfacial collapse and rate-limited solid desorption control Perfluoroalkyl acid leaching from the vadose zone

Some Per- and polyfluoroalkyl substances (PFAS) are strongly retained in the vadose zone due to their sorption to both soils and air-water interfaces. While significant research has been dedicated to understanding equilibrium behavior for these multi-phase retention processes, leaching and desorption from aqueous film-forming foam (AFFF) impacted soils under field relevant conditions can exhibit significant deviations from equilibrium. Herein, laboratory column studies using field collected AFFF-impacted soils were employed to examine the leaching of perfluoroalkyl acids (PFAAs) under simulated rainfall conditions. The HYDRUS 1-D model was calibrated to estimate the unsaturated hydraulic properties of the soil in a layered system using multiple boundary condtions. Forward simulations of equilibrium PFAS partitioning using the HYDRUS model and simplified mass balance calculations showed good agreement with the net PFAS mass flux out of the column. However, neither were able to predict the PFAS concentrations in the leached porewater. To better understand the mechanisms controlling the leaching behavior, the HYDRUS 1-D two-site leaching model incorporating solid phase rate limitation and equilibrium air-water interfacial partitioning was employed. Three variations of the novel model incorporating different forms of equilibrium air-water interfacial partitioning were considered using built-in numerical inversion. Results of numerical inversion show that a combination of air-water interfacial collapse and rate-limited desorption from soils can better predict the unique leaching behavior exhibited by PFAAs in AFFF-impacted soils. A sensitivity analysis of the initial conditions and rate-limited desorption terms was conducted to assess the agreement of the model with measured data. The models demonstrated herein show that, under some circumstances, laboratory equilibrium partitioning data can provide a reasonable estimation of total mass leaching, but fail to account for the significant rate-limited, non-Fickian transport which affect PFAA leaching to groundwater in unsaturated soils.

Evaluation of per- and polyfluoroalkyl substances (PFAS) in landfill liquids from Pennsylvania, Colorado, and Wisconsin

PER: and polyfluoroalkyl substances (PFAS) have been measured in aqueous components within landfills. To date, the majority of these studies have been conducted in Florida. This current study aimed to evaluate PFAS concentrations in aqueous components (leachate, gas condensate, stormwater, and groundwater) from four landfills located outside of Florida, in Pennsylvania, Colorado, and Wisconsin (2 landfills). The Pennsylvania landfill also provided the opportunity to assess a leachate treatment system. Sample analyses were consistent across studies including the measurements of 26 PFAS and physical-chemical parameters. For the four target landfills, average PFAS concentrations were 6,900, 22,000, 280, and 260 ng L-1 in the leachate, gas condensate, stormwater, and groundwater, respectively. These results were not significantly different than those observed for landfills in Florida except for the significantly higher PFAS concentrations in gas condensate compared to leachate. For on-site treatment at the Pennsylvania landfill, results suggest that the membrane biological bioreactor (MBBR) system performed similarly as aeration-based leachate treatment systems at Florida landfills resulting in no significant decreases in ∑26PFAS. Overall, results suggest a general consistency across US regions in PFAS concentrations within different landfill liquid types, with the few differences observed likely influenced by landfill design and local climate. Results confirm that leachate exposed to open air (e.g., in trenches or in treatment systems) have lower proportions of perfluoroalkyl acid precursors relative to leachate collected in enclosed pipe systems. Results also confirm that landfills without bottom liner systems may have relatively higher PFAS levels in adjacent groundwater and that landfills in wetter climates tend to have higher PFAS concentrations in leachate.

PFAS Porewater concentrations in unsaturated soil: Field and laboratory comparisons inform on PFAS accumulation at air-water interfaces

Poly- and perfluoroalkyl substance (PFAS) leaching from unsaturated soils impacted with aqueous film-forming foams (AFFFs) is an environmental challenge that remains difficult to measure and predict. Complicating measurements and predictions of this process is a lack of understanding between the PFAS concentrations measured in a collected environmental unsaturated soil sample, and the PFAS concentrations measured in the corresponding porewater using field-deployed lysimeters. The applicability of bench-scale batch testing to assess this relationship also remains uncertain. In this study, field-deployed porous cup suction lysimeters were used to measure PFAS porewater concentrations in unsaturated soils at 5 AFFF-impacted sites. Field-measured PFAS porewater concentrations were compared to those measured in porewater extracted in the laboratory from collected unsaturated soil cores, and from PFAS concentrations measured in the laboratory using batch soil slurries. Results showed that, despite several years since the last AFFF release at most of the test sites, precursors were abundant in 3 out of the 5 sites. Comparison of field lysimeter results to laboratory testing suggested that the local equilibrium assumption was valid for at least 3 of the sites and conditions of this study. Surprisingly, PFAS accumulation at the air-water interface was orders of magnitude less than expected at two of the test sites, suggesting potential gaps in the understanding of PFAS accumulation at the air-water interface at AFFF-impacted sites. Finally, results herein suggest that bench-scale testing on unsaturated soils can in some cases be used to inform on PFAS in situ porewater concentrations.

Removal of per- and polyfluoroalkyl substances from wastewater via aerosol capture

The widespread use of per- and polyfluoroalkyl substances (PFAS)-containing products in numerous commercial and industrial applications has resulted in their occurrence in wastewater treatment plants (WWTPs). Herein, proof-of-concept bench-scale experiments were performed to measure the extent to which PFAS could be removed from a WWTP if aerosols generated during aeration were captured. Experiments were designed to mimic the aeration rate:water volume ratio, the water volume:surface area ratio, and aeration bubble size applicable to the full-scale aeration vessel. Results showed that substantial (75%) removal of perfluorooctane sulfonate (PFOS) was observed under these operating conditions in the bench-scale system; up to 97% PFOS removal was observed if the aeration rate was increased 3-fold. PFAS removal generally increased with increasing aerosol capture and with increasing PFAS surface activity. Analysis of semi-quantified PFAS showed that the semi-quantified PFAS accounted for approximately 93% of the identified PFAS in the raw wastewater, dominated largely by the presence of 2:2 fluorotelomer carboxylic acid (2:2 FTCA). This preliminary study suggests that aerosol capture in aeration basins has potential for mitigating PFAS in WWTPs. Further testing is needed to assess the feasibility of this approach at the field scale.

Evaluation of per- and polyfluoroalkyl substances (PFAS) released from two Florida landfills based on mass balance analyses

Per- and polyfluoroalkyl substances (PFAS) have been found at high levels within landfill environments. To assess PFAS distributions, this study aimed to evaluate PFAS mass flux leached from disposed solid waste and within landfill reservoirs by mass balance analyses for two full-scale operational Florida landfills. PFAS mass flux in different aqueous components within landfills were estimated based on PFAS concentrations and water flow rates. For PFAS concentration, 26 PFAS, including 18 perfluoroalkyl acids (PFAAs) and 8 PFAA-precursors, were measured in samples collected from the landfills or estimated based on previous studies. Flow rates of aqueous components (rainfall, evapotranspiration, runoff, stormwater, groundwater, leakage, gas condensate, and leachate) were evaluated through the Hydrologic Evaluation of Landfill Performance model, water balance, and Darcy's Law. Results showed that the average PFAS mass flux leached from the solid waste standardized by area was estimated as 36.8 g/ha-yr, which was approximately 1 % to 3 % of the total amount of PFAS within the solid waste. The majority of PFAS leached from the solid waste (95 % to 97 %) is captured by the leachate collection system, with other aqueous components representing much smaller fractions (stormwater system at 3 % to 5 %, and gas condensate and groundwater at < 1 %). Also, based on the results, we estimate that PFAS releases will likely occur at least over 40 years. Overall, these results can help prioritize components for waste management and PFAS treatment during the anticipated landfill release periods.

Investigating rate-limited sorption, sorption to air-water interfaces, and colloid-facilitated transport during PFAS leaching

Various sorption processes affect leaching of per- and polyfluoroalkyl substances (PFAS) such as PFOA and PFOS. The objectives of this study are to (1) compare rate-limited leaching in column and lysimeter experiments, (2) investigate the relevance of sorption to air-water interfaces (AWI), and (3) examine colloid-facilitated transport as a process explaining early experimental breakthrough. A continuum model (CM) with two-domain sorption is used to simulate equilibrium and rate-limited sorption. A random walk particle tracking (PT) model was developed and applied to analyze complex leaching characteristics. Results show that sorption parameters derived from column experiments underestimate long-term PFOA leaching in lysimeter experiments due to early depletion, suggesting that transformation of precursors contributes to the observed long-term leaching in the lysimeters (approximately 0.003 µg/kg/d PFOA). Both models demonstrate that sorption to AWI is the dominant retention mechanism for PFOS in lysimeter experiments, with retardation due to AWI being 3 (CM) to 3.7 (PT) times higher than retardation due to solid phase sorption. Notably, despite a simplified conception of AWI sorption, the PT results are closer to the observations. The PT simulations demonstrate possible colloid-facilitated transport at early time; however, results using substance-specific varying transport parameters align better with the observations, which should be equal if colloid-facilitated transport without additional kinetics is the sole mechanism affecting early breakthrough. Possibly, rate-limited sorption to AWI is relevant during the early stages of the lysimeter experiment. Our findings demonstrate that rate-limited sorption is less relevant for long-term leaching under field conditions compared to transformation of precursors and that sorption to AWI can be the dominant retention mechanism on contaminated sites. Moreover, they highlight the potential of random walk particle tracking as a practical alternative to continuum models for estimating the relative contributions of various retention mechanisms.