Quantifying the Impact of Electrically Conductive Membrane-Generated Hydrogen Peroxide and Extreme pH on the Viability of Escherichia coli Biofilms

Facile Synthesis of Electrically Conductive Membranes

A facile and effective strategy that can be used to fabricate electrically conductive membranes (ECMs) of diverse filtration performance (i.e., water productivity and solute rejection) is not available yet. Herein, we report a facile method that enables the fabrication of ECMs of a broad performance range. The method is based on the use of polyethylenimine (PEI), glutaraldehyde, and any of a diverse set of conductive materials to cast an electrically conductive layer atop any of a diverse set of substrates (i.e., from microfiltration to reverse osmosis membranes). We developed the reported ECM fabrication method using graphite as the conductive material and PVDF membranes as substrates. We demonstrate that graphite-PVDF ECMs were stable and electrically conductive and could be successfully used for solute filtration and electrochemical degradation. We also confirmed that the PEI/glutaraldehyde-based ECM fabrication method is suitable for conductive materials other than graphite, including carbon nanotubes, reduced graphene oxide, activated charcoal, and silver nanoparticles. Compared with the substrates used for their fabrication, ECMs showed low electrical sheet resistances that varied with conductive material, increased solute rejection, and reduced water permeance. Taken together, this work presents a promising general strategy for the fabrication of ECMs for environmental applications from diverse substrates and conductive materials.

In-situ cathodic electrolysis coupled with hydraulic backwash inhibited biofilm formation on a backwashable carbon nanotube membrane

Electro-coupled membrane filtration (ECMF) is an innovative and green technology for water and wastewater treatment. However, the dynamics of biofouling development in the ECMF system has yet been determined. This fundamental question was systematically investigated in this study through laboratory dead-end ECMF experiments. It was found that the ECMF process with an applied voltage of 3 V and a backwash interval of 60 min was capable of completely eradicating membrane biofouling in an extended filtration time of 1450 min. In contrast, membrane biofouling was much severer with a longer backwash interval of 720 min or without backwash. The complemental permeate analysis and membrane characterization results revealed that biofouling during ECMF involved two sequential stages. During the first stage, dead bacteria and their degradation debris formed a loose deposit layer on the membrane surface. The continuous accumulation of this layer decreased the electrochemical performance of the membrane cathode. As such, bacteria in the top deposit layer proliferated and secreted extracellular polymeric substances, which led to irreversible fouling in the second stage. Therefore, timely removal of the initial deposit layer by hydraulic backwash was crucial in preventing irreversible membrane biofouling. These findings provided novel insights into the synergistic effects of cathodic electrolysis and hydraulic backwash for biofouling mitigation.