Amphiphobic PFTMS@nano-SiO2/ePTFE Membrane for Oil Aerosol Removal

Advanced Design of Fiber-Based Particulate Filters: Materials, Morphology, and Construction of Fibrous Assembly

With increasing air pollution and sporadic outbreaks of epidemics, there is ramping attention on the filtration devices. The main constituents of airborne pollutants are particulate matters of solid particles, liquid aerosol, bioaerosol/bio-droplets, and gas/vapor. With the growing demand for high-performance filters, novel materials and functionalities are being developed applying advanced technologies. In this paper, recent developments of fiber-based particulate filters are reviewed, with a focus on the important performance parameters and material properties. Trends in technology and research activities are briefly reviewed, and the evaluative measures of filtration performance are reported. Recent studies on the advanced filter materials are reviewed in the aspect of polymers and the fabrication process of fibrous assembly. The characterization method including 3D modeling and simulation is also briefly introduced. Multifunctional filters such as antimicrobial filter and gas and particulate filters are briefly introduced, and efforts for developing environmentally sustainable filters are noted.

Substantial Improvement of Oil Aerosol Filtration Performance Using In-Plane Asymmetric Wettability

Oil aerosol usually causes air pollution, health issues, and corrosion to equipment. The removal of aerosol oil particles from the air is a crucial process in industrial production and daily life. Although fibrous filters have been a widely used material for the separation of oil aerosol from the air, it is still a challenge to separate submicrometer aerosol oil particles with both high filtration efficiency and low resistance. Herein, we report a novel approach to markedly reduce the pressure drop of a fibrous filter and simultaneously increase its aerosol filtration efficiency, only by surface treatment to make the filter have in-plane alternating superoleophilic and superoleophobic patterns. We used a spraying method to prepare superoleophobic and superoleophilic patterns on the filter. The best filtration results were achieved when two layers of the patterned filters that have superoleophobic and superoleophilic strips (both width, 5 mm) were stacked in a way that the opposite wetting surfaces contacted each other between the layers. The filter showed a much-reduced filtration resistance and the pressure drop (4.16 kPa) at the pseudo-steady state being at least 45% lower when compared to the two-layer controls with a homogeneous surface wettability (i.e., untreated surface, superoleophobicity, and superoleophilicity). It also showed higher filtration efficiency (98.37% for small oil mists and 99.99% for large oil mists) and over two times higher quality factor (0.99 kPa^-1 for small oil mists and 2.27 kPa^-1 for large oil mists). The asymmetric wettability leads to the formation of unobstructed channels for the air stream to penetrate through the filter matrix, leading to a low resistance with improved oil capture efficiency. The pattern strip width showed an effect on filtration performance. This unexpected finding may provide a novel approach to designing high-performance, low energy consumption, and long-life coalescence filters.