Beneficial Effect of Water on the Catalytic Conversion of Sugars to Methyl Lactate in Near-Critical Methanol Solutions

Catalytic Conversion of High Fructose Corn Syrup to Methyl Lactate with CoO@silicalite-1

Methyl lactate (MLA), a versatile biomass platform, was typically produced from the catalytic conversion of high-priced fructose. High fructose corn syrup (HFCS) is a mixture of glucose, fructose, water, etc., which is viewed as an economical substitute for fructose to produce MLA due to the much lower cost of separation and drying processes. However, the transformation of HFCS to MLA is still a challenge due to its complex components and the presence of water. In this work, the catalytic conversion of HFCS to MLA over CoO@silicalite-1 catalyst synthesized via a straightforward post citric acid treatment approach was reported. The maximum MLA yield reached 43.8% at 180 °C for 18 h after optimizing the reaction conditions and Co loading. Interestingly, adding extra 3% water could further increase the MLA yield, implying that our CoO@silicalite-1 catalyst is also capable for upgrading wet HFCS. As a result, the costly drying process of wet HFCS can be avoided. Moreover, the activity of CoO@silicalite-1 catalyst can be regenerated for at least four cycles via facile calcination in air. This study, therefore, will provide a new opportunity to not only solve the HFCS-overproduction issues but also produce value-added MLA.

Mesoporous Sn-In-MCM-41 Catalysts for the Selective Sugar Conversion to Methyl Lactate and Comparative Life Cycle Assessment with the Biochemical Process

The use of biomass for the production of energy and higher added value products is a topic of increasing interest in line with growing environmental concerns and circular economy. Mesoporous material Sn-In-MCM-41 was synthesized for the first time and used as a catalyst for the transformation of sugars to methyl lactate (ML). This catalyst was characterized in depth by various techniques and compared with Sn-MCM-41 and In-MCM-41 catalysts. In the new Sn-In-MCM-41 material, both metals, homogeneously distributed throughout the mesoporous structure of MCM-41, actuate in a cooperative way in the different steps of the reaction mechanism. As a result, yields to ML of 69.4 and 73.9% in the transformation of glucose and sucrose were respectively reached. In the case of glucose, the ML yield 1.5 and 2.6 times higher than those of Sn-MCM-41 and In-MCM-41 catalysts, respectively. The Sn-In-MCM-41 catalyst was reused in the transformation of glucose up to four cycles without significant loss of catalytic activity. Finally, life cycle assessment comparison between chemical and biochemical routes to produce ML allowed us to conclude that the use of Sn-In-MCM-41 reduces the environmental impacts compared to Sn-MCM-41. Nevertheless, to make the chemical route comparable to the biochemical one, improvements in the catalyst and ML synthesis have to be achieved.

One-pot conversion of dihydroxyacetone into ethyl lactate by Zr-based catalysts

Efficient strategies for producing bio-based reagents from sustainable biomass are highly attractive for cost-effective sustainable manufacturing. In this study, a series of eco-friendly Zr-based catalysts (basic zirconium carbonate, zirconium dioxide and zirconium hydroxide) were investigated for the efficient conversion of dihydroxyacetone to ethyl lactate in a one-pot system, in which basic zirconium carbonate exhibited the best performance with 100% dihydroxyacetone conversion and 85.3% EL (ethyl lactate) yield at 140 °C, 4.0 h and 1.0 MPa N2. The improved activity of basic zirconium carbonate could be attributed to the synergistic effect among acid and base active sites. Furthermore, this low-cost catalyst shows improved thermochemical stability and recyclability under optimal conditions, where no significant decrease in activity was observed after three runs. This catalytic process could be identified as a promising alternative to produce ethyl lactate from renewable biomass and its derivatives.