Cd0.5Zn0.5S/CoWO4 Nanohybrids with a Twinning Homojunction and an Interfacial S-Scheme Heterojunction for Efficient Visible-Light-Induced Photocatalytic CO2 Reduction

Design of p-n heterojunction between CoWO4 and Zn-defective Zn0.3Cd0.7S for efficient photocatalytic H2 evolution

To enhance the efficiency of photocatalytic H2 evolution, numerous methods are employed by increasing the utilization of photogenerated charge carriers (PCCs), including catalyst design, defect regulation, and selection of suitable H+ resources. Using self-assembly method, CoWO4/ZnxCd1-xS with p-n heterojunction was synthesized. Although CoWO4 (CW) cannot produce H2 under visible light irradiation, it can provide photogenerated electrons (e-) to Zn0.3Cd0.7S (ZCS), and largely increase the photocatalytic activity of ZCS. The optimal CW/ZCS composite can reach 15.58 mmol·g-1·h-1, which is 45.8 and 24.3 times higher than the values of the pure CdS and ZCS, respectively. The largely enhanced photocatalytic H2 production is attributed to the Zn vacancies (VZn), p-n heterojunction, and p-chlorobenzyl alcohol (Cl-PhCH2OH) as the H+ source of H2 production. VZn on the ZCS surface as the capture center of photogenerated holes (h+), can regulate the carrier distribution, which results in more photogenerated e- and less generated h+. The combination of p-n heterojunction and VZn can enhance the separation and transfer efficiency of PCCs, and effectively inhibit the recombination of charge carriers. To further improve the utilization rate of PCCs, the photocatalytic H2 evolution is proceeded by Cl-PhCH2OH oxidation in N,N-dimethylformamide solution, with 4-chlorobenzaldehyde (Cl-PhCHO) generated. The separated photogenerated e- and h+ both participated in the redox reaction of H+ reduction and Cl-PhCH2OH oxidation, considering that the amount of H2 and Cl-PhCHO products are close to 1:1. This work not only facilitates the separation and transfer of PCCs, but also provides directions for the design of efficient photocatalysts and H2 evolution in the organic phase.

Rational Photodeposition of Cobalt Phosphate on Flower-like ZnIn2S4 for Efficient Photocatalytic Hydrogen Evolution

The high electrons and holes recombination rate of ZnIn2S4 significantly limits its photocatalytic performance. Herein, a simple in situ photodeposition strategy is adopted to introduce the cocatalyst cobalt phosphate (Co-Pi) on ZnIn2S4, aiming at facilitating the separation of electron-hole by promoting the transfer of photogenerated holes of ZnIn2S4. The study reveals that the composite catalyst has superior photocatalytic performance than blank ZnIn2S4. In particular, ZnIn2S4 loaded with 5% Co-Pi (ZnIn2S4/5%Co-Pi) has the best photocatalytic activity, and the H2 production rate reaches 3593 μmol·g-1·h-1, approximately double that of ZnIn2S4 alone. Subsequent characterization data demonstrate that the introduction of the cocatalyst Co-Pi facilitates the transfer of ZnIn2S4 holes, thus improving the efficiency of photogenerated carrier separation. This investigation focuses on the rational utilization of high-content and rich cocatalysts on earth to design low-cost and efficient composite catalysts to achieve sustainable photocatalytic hydrogen evolution.

Bi3O4Cl/g-C3N4/Cd0.5Zn0.5S Double Z-Scheme Heterojunction Photocatalyst for Highly Selective CO2 Reduction to Methane

Solar-energy-driven CO2 hydrogenation is a promising strategy to alleviate the climate crisis. Methane is a desirable derivative of CO2 reduction. However, developing a photocatalyst for highly active and selective CH4 generation remains challenging. Herein, we report a double Z-scheme Bi3O4Cl/g-C3N4/Cd0.5Zn0.5S photocatalyst for efficient reduction of CO2 to CH4. In situ characterization techniques confirmed that the charge migration mechanism in Bi3O4Cl/g-C3N4/Cd0.5Zn0.5S promotes charge separation through double internal electric fields. As a result, the optimized C0.01B0.02C catalyst displayed a formation rate high up to 25.34 μmol g-1 h-1 and a selectivity of 96.52% of CH4. Moreover, the AQY of CO2 conversion on C0.01B0.02C (1.84%) was almost 41 times higher than that of the bare CN. This study provides a novel perspective to develop heterojunction photocatalysts for selective CO2 conversion to CH4.

Conductive Polymer-Inorganic Polythiophene/Cd0.5Zn0.5S Heterojunction with Apace Charge Separation and Strong Light Absorption for Boosting Photocatalytic Activity

In order to utilize the synergistic effect between a conductive polymer and an inorganic semiconductor to efficaciously enhance charge transfer and solve the problem of unsatisfactory performance of a single photocatalyst, thiophene (Th) was polymerized on the Cd0.5Zn0.5S nanoparticle surface to prepare a conductive polymer-inorganic polythiophene/Cd0.5Zn0.5S (PTh/CZS) heterostructrue through a simple in situ oxidation polymerization for the first time. The as-prepared PTh/CZS heterostructures significantly improved photocatalytic TCH degradation and hydrogen production activities. Especially, the 15PTh/CZS sample exhibited the optimal hydrogen production rate (18.45 mmol g-1 h-1), which was 2.51 times higher than pure Cd0.5Zn0.5S nanoparticles. In addition, 15PTh/CZS also showed very fast and efficient photodegradation ability for degrading 88% of TCH in 25 min. Moreover, the degradation rate (0.06229 min-1) was five times more than that of Cd0.5Zn0.5S. The π-π* transition characteristics, high optical absorption coefficient, wide absorption wavelength of PTh, the tight contact interface, and synergistic effect of PTh and Cd0.5Zn0.5S efficiently boosted charge transfer rate and increased the light absorption of PTh/CZS photocatalysts, which greatly enhanced the photocatalytic abilities. Besides, the mechanism of improved photocatalytic activities for TCH degradation and H2 production was also carefully proposed. Undoubtedly, this work would provide new insights into coupling conductive polymers to inorganic photocatalysts for achieving multifunctional applications in the field of photocatalysis.

Integrating Co(OH)2 nanosheet arrays on graphene for efficient noble-metal-free EY-sensitized photocatalytic H2 evolution

The development of an efficient noble-metal-free cocatalyst is the key to photocatalytic hydrogen production technology. In this study, hierarchical Co(OH)2 nanosheet array-graphene (GR) composite cocatalysts are developed. With Eosin Y (EY) as a photosensitizer, the optimal Co(OH)2-10%GR hybrid cocatalyst presents excellent photocatalytic activity with an H2 production rate of 17 539 μmol g-1 h-1, and the apparent quantum yield for hydrogen production can reach 12.8% at 520 nm, which remarkably surpasses that of pure Co(OH)2 and most similar hybrid cocatalyst systems. Experimental investigations demonstrate that the excellent photocatalytic activity of Co(OH)2-GR arises from its unique nanosheet array architecture, which can collaboratively expose rich active sites for photocatalytic hydrogen evolution and facilitate the migration and separation of photogenerated charge carriers. It is desired that this study would supply a meaningful direction for the rational optimization of the constitute and structure of cocatalysts to achieve efficient photocatalytic hydrogen generation.

Constructing a noble-metal-free 0D/2D CdS/SnS2heterojunction for efficient visible-light-driven photocatalytic pollutant degradation and hydrogen generation

Semiconductor photocatalysis has attracted the attention of a wide audience for its outstanding capabilities in water purification and energy conversion. Herein, a noble-metal-free nanoheterojunction is created by planting zero-dimensional (0D) CdS nanograins, of 10-20 nm in size, on the surface of 2D SnS2nanosheets (NSs) using anin situchemical bathing deposition process, where SnS2NSs have an average diameter of 400 nm and thicknesses of less than 20 nm. The possible formation mechanism of the CdS/SnS2(CS/SS) heterogeneous nanostructure is elaborated upon. The catalytic activities over CS/SS nanocomposites for the photodegradation of organic dye and hydrogen evolution from photolysis water splitting are examined under visible light irradiation. The apparent rate constant (k) of the optimal CS/SS-3 composite in the decontamination of methylene blue (MB) is up to 3.34 and 1.87 times as high as that of pristine SnS2and pure CdS counterparts, respectively. The optimized CS/SS-3 sample consistently achieves the highest photocatalytic hydrogen production rate, at 10.3 and 5.7 folds higher than that of solo SnS2and CdS panels, respectively. The boosted photocatalytic capacities of CdS/SnS2heterostructures are essentially attributed to the formation of the closely interfacial incorporation of CdS and SnS2semiconductors, resulting in the effective charge transportation and spatial separation of the photoinduced electron-hole pairs. Furthermore, the traditional type-II charge transfer pathway is proposed based on the perfect band structure and the free radical experiment results.

Single-Atom Phosphorus Defects Decorated CoP Cocatalyst Boosts Photocatalytic Hydrogen Generation Performance of Cd0.5 Zn0.5 S by Directed Separating the Photogenerated Carriers

Design and preparation of an efficient and nonprecious cocatalysts, with structural features and functionality necessary for improving photocatalytic performance of semiconductors, remain a formidable challenge until now. Herein, for the first time, a novel CoP cocatalyst with single-atom phosphorus vacancies defects (CoP-V_p ) is synthesized and coupled with Cd_0.5 Zn_0.5 S to build CoP-V_p @Cd_0.5 Zn_0.5 S (CoP-V_p @CZS) heterojunctions photocatalysts via a liquid phase corrosion method following by an in suit growth process. The nanohybrids deliver an attractive photocatalytic hydrogen production activity of 2.05 mmol h^-1 30 mg^-1 under visible-light irradiation, which is 14.66 times higher than that of the pristine ZCS samples. As expected, CoP-V_p further enhances the charge-separation efficiency of ZCS, in addition to the improvement of the electron transfer efficiency, which is confirmed by the ultrafast spectroscopies. Mechanism studies based on density functional theory calculations verify that Co atoms adjacent with single-atom V_p play the key role in translation, rotation, and transformation of electrons for H₂ O reduction. This scalable strategy focusing defect engineering provides a new insight into designing the highly active cocatalysts to boost the photocatalytic application.

Rhombohedral/Cubic In2O3 Phase Junction Hybridized with Polymeric Carbon Nitride for Photodegradation of Organic Pollutants

In recent studies, phase junctions constructed as photocatalysts have been found to possess great prospects for organic degradation with visible light. In this study, we designed an elaborate rhombohedral corundum/cubic In₂O₃ phase junction (named MIO) combined with polymeric carbon nitride (PCN) via an in situ calcination method. The performance of the MIO/PCN composites was measured by photodegradation of Rhodamine B under LED light (λ = 420 nm) irradiation. The excellent performance of MIO/PCN could be attributed to the intimate interface contact between MIO and PCN, which provides a reliable charge transmission channel, thereby improving the separation efficiency of charge carriers. Photocatalytic degradation experiments with different quenchers were also executed. The results suggest that the superoxide anion radicals (O₂^-) and hydroxyl radicals (·OH) played the main roles in the reaction, as opposed to the other scavengers. Moreover, the stability of the MIO/PCN composites was particularly good in the four cycling photocatalytic reactions. This work illustrates that MOF-modified materials have great potential for solving environmental pollution without creating secondary pollution.

Emerging S-Scheme Photocatalyst

Photocatalysis is a green technology to use ubiquitous and intermittent sunlight. The emerging S-scheme heterojunction has demonstrated its superiority in photocatalysis. This article covers the state-of-the-art progress and provides new insights into its general designing criteria. It starts with the challenges confronted by single photocatalyst from the perspective of energy dissipation by borrowing the common behaviors in the dye molecule. Subsequently, other problems faced by single photocatalyst are summarized. Then a viable solution for these problems is the construction of heterojunctions. To overcome the problems and mistakes of type-II and Z-scheme heterojunctions, S-scheme heterojunction is proposed and the underlying reaction mechanism is summarized. Afterward, the design principles for S-scheme heterojunction are proposed and four types of S-scheme heterojunctions are suggested. Following this, direct characterization techniques for testifying the charge transfer in S-scheme heterojunction are presented. Finally, different photocatalytic applications of S-scheme heterojunctions are summarized. Specifically, this work endeavors to clarify the critical understanding on curved Fermi level in S-scheme heterojunction interface, which can help strengthen and advance the fundamental theories of photocatalysis. Moreover, the current challenges and prospects of the S-scheme heterojunction photocatalyst are critically discussed.