Sulfuric Acid Solutions of [Pt(OH)4(H2O)2]: A Platinum Speciation Survey and Hydrated Pt(IV) Oxide Formation for Practical Use

(Me4N)2[Pt(CO3)2(OH)2]: The Isolated PtIVO6 Carbonato-Complex

The first fully inorganic Pt(IV) carbonato-complex trans-[Pt(CO3)2(OH)2]2- with a {PtO6} coordination sphere was isolated as the (Me4N)2[Pt(CO3)2(OH)2] (1) salt. The compound 1 was characterized using single-crystal and powder X-ray diffraction, Raman spectroscopy, infrared spectroscopy (FTIR), electrospray ionization mass spectrometry (ESI-MS), nuclear magnetic resonance spectroscopy (NMR), and thermogravimetric analysis (TG). Density functional theory (DFT) calculations were also performed to analyze the spectral features of the complex. 1 crystallizes in the triclinic system (P-1) with a Z of 1. The trans-[Pt(CO3)2(OH)2]2- anion has axial hydroxo ligands and κ2-CO3 ligands, which form an equatorial plane. This anionic complex exhibits notable stability in aqueous solutions, while the axial hydroxo ligand can be readily modified, as exemplified by the acylation of the trans-[Pt(CO3)2(OH)2]2- into trans-[Pt(CO3)2(OAc)2]2- anion. Furthermore, it has been shown that rigid and glittering platinum coatings can be electrochemically deposited from an aqueous solution of 1 without the addition of surfactants.

Synthesis of Berberis aristate rhizome extract stabilized magnesium nanoparticles using green chemistry: rhizome characterization, in vitro antimicrobial and anti-inflammatory activity

In the present study, magnesium nanoparticles (Mg NPs) were synthesized utilizing an aqueous extract of Berberis aristate rhizome and evaluated for antimicrobial and anti-inflammatory activity. Technofunctional properties of rhizome powder were evaluated and during thermal stability evaluation four stages of decomposition with a maximum delta Y value of 76.04 % was observed. Optimization of Mg NPs was carried out by employing eight different concentrations (C1-C8)   and the C4 showed maximum absorbance at 330 nm confirming the NPs synthesis. The Mg NPs showed the particle size of 62 nm, zeta potential of -24.7 mV and hexagonal mprphology. Potential inhibition against S. aureus and E. coli (76.78 ± 0.05% and 74.62 ± 0.17%)and anti-inflammatory activity ranging from 42.43 ± 0.07-82.92 ± 0.04% was observed for Mg NPs. Therefore, green synthesis of Mg NPs is a promising approach for the development ofbiological active NPs to cure microbial infections.

Fine-Tuning of Pt Dispersion on Al2O3 and Understanding the Nature of Active Pt Sites for Efficient CO and NH3 Oxidation Reactions

Fine-tuning the dispersion of active metal species on widely used supports is a research hotspot in the catalysis community, which is vital for achieving a balance between the atomic utilization efficiency and the intrinsic activity of active sites. In this work, using bayerite Al(OH)3 as support directly or after precalcination at 200 or 550 °C, Pt/Al2O3 catalysts with distinct Pt dispersions from single atoms to clusters (ca. 2 nm) were prepared and evaluated for CO and NH3 removal. Richer surface hydroxyl groups on AlOx(OH)y support were proved to better facilitate the dispersion of Pt. However, Pt/Al2O3 with relatively lower Pt dispersion could exhibit better activity in CO/NH3 oxidation reactions. Further reaction mechanism study revealed that the Pt sites on Pt/Al2O3 with lower Pt dispersion could be activated to Pt0 species much easier under the CO oxidation condition, on which a higher CO adsorption capacity and more efficient O2 activation were achieved simultaneously. Compared to Pt single atoms, PtOx clusters could also better activate NH3 into -NH2 and -HNO species. The higher CO adsorption capacity and the more efficient NH3/O2 activation ability on Pt/Al2O3 with relatively lower Pt dispersion well explained its higher CO/NH3 oxidation activity. This study emphasizes the importance of avoiding a singular pursuit of single-atom catalyst synthesis and instead focusing on achieving the most effective Pt species on Al2O3 support for targeted reactions. This approach avoids unnecessary limitations and enables a more practical and efficient strategy for Pt catalyst fabrication in emission control applications.

Photocatalysts Based on Graphite-like Carbon Nitride with a Low Content of Rhodium and Palladium for Hydrogen Production under Visible Light

In this study, we proposed photocatalysts based on graphite-like carbon nitride with a low content (0.01-0.5 wt.%) of noble metals (Pd, Rh) for hydrogen evolution under visible light irradiation. As precursors of rhodium and palladium, labile aqua and nitrato complexes [Rh2(H2O)8(μ-OH)2](NO3)4∙4H2O and (Et4N)2[Pd(NO3)4], respectively, were proposed. To obtain metallic particles, reduction was carried out in H2 at 400 °C. The synthesized photocatalysts were studied using X-ray diffraction, X-ray photoelectron spectroscopy, UV-Vis diffuse reflectance spectroscopy and high-resolution transmission electron microscopy. The activity of the photocatalysts was tested in the hydrogen evolution from aqueous and aqueous alkaline solutions of TEOA under visible light with a wavelength of 428 nm. It was shown that the activity for the 0.01-0.5% Rh/g-C3N4 series is higher than in the case of the 0.01-0.5% Pd/g-C3N4 photocatalysts. The 0.5% Rh/g-C3N4 sample showed the highest activity per gram of catalyst, equal to 3.9 mmol gcat-1 h-1, whereas the most efficient use of the metal particles was found over the 0.1% Rh/g-C3N4 photocatalyst, with the activity of 2.4 mol per gram of Rh per hour. The data obtained are of interest and can serve for further research in the field of photocatalytic hydrogen evolution using noble metals as cocatalysts.

Comprehensive Review on g-C3N4-Based Photocatalysts for the Photocatalytic Hydrogen Production under Visible Light

Currently, the synthesis of active photocatalysts for the evolution of hydrogen, including photocatalysts based on graphite-like carbon nitride, is an acute issue. In this review, a comprehensive analysis of the state-of-the-art studies of graphic carbon nitride as a photocatalyst for hydrogen production under visible light is presented. In this review, various approaches to the synthesis of photocatalysts based on g-C₃N₄ reported in the literature were considered, including various methods for modifying and improving the structural and photocatalytic properties of this material. A thorough analysis of the literature has shown that the most commonly used methods for improving g-C₃N₄ properties are alterations of textural characteristics by introducing templates, pore formers or pre-treatment method, doping with heteroatoms, modification with metals, and the creation of composite photocatalysts. Next, the authors considered their own detailed study on the synthesis of graphitic carbon nitride with different pre-treatments and respective photocatalysts that demonstrate high efficiency and stability in photocatalytic production of hydrogen. Particular attention was paid to describing the effect of the state of the platinum cocatalyst on the activity of the resulting photocatalyst. The decisive factors leading to the creation of active materials were discussed.