Oxygen Reduction Reaction on N-Doped Graphene: Effect of Positions and Scaling Relations of Adsorption Energies

Two-Dimensional Covalent Framework Derived Nonprecious Transition Metal Single-Atomic-Site Electrocatalyst toward High-Efficiency Oxygen Reduction

Designing an active, stable, and nonprecious metal catalyst substitute for Pt in the oxygen reduction reaction (ORR) is highly demanded for energy-efficient and cost-effective prototype devices. Single-atomic-site catalysts (SASCs) have been widely concerning because of their maximum atomic utilization and precise structural regulation. Despite being challenging, the controllable synthesis of SASCs is crucial for optimizing ORR activity. Here, we demonstrate an ultrathin organometallic framework template-assisted pyrolysis strategy to synthesize SASCs with a unique two-dimensional (2D) architecture. Electrochemical measurements revealed that Fe-SASCs displayed an excellent ORR activity in an alkaline media, having a half-wave potential and a diffusion-limited current density comparable to those of commercial Pt/C. Remarkably, the durability and methanol tolerance of Fe-SASCs were even superior to those of Pt/C. Furthermore, Fe-SASCs displayed a maximum power density of 142 mW cm^-2 with a current density of 235 mA cm^-2 as a cathode catalyst in a zinc-air battery, showing its great potential for practical applications.

Nitrogen doped carbonaceous materials as platinum free cathode electrocatalysts for oxygen reduction reaction (ORR)

Comparison of physicochemical properties and electrocatalytic behavior of different N-doped carbonaceous materials as potential catalysts for oxygen reduction reaction (ORR) was attended. Ball-milling of graphite with melamine and solvothermal treatment of graphite oxide, graphene nanoplatelets (GNP) with ammonia were used as preparation methods. Elemental analysis and N2 physisorption measurements revealed the synthesis of N-doped materials with strongly different morphological parameters. Contact angle measurements proved that all three samples had good wettability properties. According to analysis of XRD data and Raman spectra a higher nitrogen concentration corresponded to a smaller size of crystallites of the N-doped carbonaceous material. Surface total N content determined by XPS and bulk N content assessed by elemental analysis were close, indicating homogenous inclusion of N in all samples. Rotating disc electrode tests showed that these N-doped materials weremuch less active in acidic medium than in an alkaline environment. Although the presence of in-plane N species is regarded to be advantageous for the ORR activity, no particular correlation was found in these systems with any type of N species. According to Koutecky–Levich analysis, both the N-containing carbonaceous materials and the reference Pt/C catalyst displayed a typical one-step, four-electron ORR route. Both ball-milled sample with high N-content but with low SSA and solvothermally synthesized N-GNP with high SSA but low N content showed significant ORR activity. It could be concluded that beside the total N content other parameters such as SSA, pore structure, structural defects, wettability were also essential for achieving high ORR activity.

Origin of the Rarely Reported High Performance of Mn-doped Carbon-based Oxygen Reduction Catalysts

Recent efforts to develop durable high-performance platinum-group metal (PGM)-free oxygen reduction reaction (ORR) electrocatalysts have focused on Fe- and Co-based molecular and pyrolyzed catalysts. While Mn-based catalysts have advantages of lower toxicity and higher durability, their activity has been generally poor. Nevertheless, several examples of high-performance Mn-based catalysts have been reported. Thus, it is necessary to understand why Mn-based materials much more rarely show high catalytic ORR performance and to determine the factors that can lead to the achievement of such high performance in these rare cases. We have studied the effects of the changes in the macrocycle structure, axial ligand, distance between the active sites, interactions with the dopant N atoms and the presence of an extended carbon network on the ORR catalysis of various Mn-, Fe-, and Co-based systems through the comparison of the adsorption energies of the ORR intermediates. We find that the sensitivity to the local environment changes is the largest for Mn and is the smallest for Co, with Fe between Mn and Co. Our results showed that the strong binding of OH by Mn and the strong sensitivity of the Mn to the modification of its environment necessitate a precise combination of local environment changes to achieve a high onset potential (V_onset ) in Mn-based catalysts. By contrast, the weaker binding of OH by Fe and Co and their weaker sensitivity to local environment changes lead to a wide variety of local environments with favorable catalytic activity (V_onset >0.7 V) for Co- and Fe-based systems. This explains the scarcity of reported Mn-based pyrolyzed catalysts and suggests that precise material synthesis and engineering of the active site can achieve high-performance Mn-based ORR electrocatalysts with high activity and durability.

Magnéli TiO2 as a High Durability Support for the Proton Exchange Membrane (PEM) Fuel Cell Catalysts

Proton exchange membrane fuel cells (PEMFCs) cathode catalysts’ robustness is one of the primary factors determining its long-term performance and durability. This work presented a new class of corrosion-resistant catalyst, Magnél TiO2 supported Pt (Pt/Ti9O17) composite, synthesized. The durability of a Pt/Ti9O17 cathode under the PEMFC operating protocol was evaluated and compared with the state-of-the-art Pt/C catalyst. Like Pt/C, Pt/Ti9O17 exhibited exclusively 4e− oxygen reduction reaction (ORR) in the acidic solution. The accelerated stress tests (AST) were performed using Pt/Ti9O17 and Pt/C catalysts in an O2-saturated 0.5 M H2SO4 solution using the potential-steps cycling experiments from 0.95 V to 0.6 V for 12,000 cycles. The results indicated that the electrochemical surface area (ECSA) of the Pt/Ti9O17 is significantly more stable than that of the state-of-the-art Pt/C, and the ECSA loss after 12,000 potential cycles is only 10 ± 2% for Pt/Ti9O17 composite versus 50 ± 5% for Pt/C. Furthermore, the current density and onset potential at the ORR polarization curve at Pt/C were significantly affected by the AST test. In contrast, the same remained almost constant at the modified electrode, Pt/Ti9O17. This demonstrated the excellent stability of Pt nanoparticles supported on Ti9O17.

Systematic Study of Effective Hydrothermal Synthesis to Fabricate Nb-Incorporated TiO2 for Oxygen Reduction Reaction

Fuel cells are expected to serve as next-generation energy conversion devices owing to their high energy density, high power, and long life performance. The oxygen reduction reaction (ORR) is important for determining the performance of fuel cells; therefore, using catalysts to promote the ORR is essential for realizing the practical applications of fuel cells. Herein, we propose Nb-incorporated TiO₂ as a suitable alternative to conventional Pt-based catalysts, because Nb doping has been reported to improve the conductivity and electron transfer number of TiO₂. In addition, Nb-incorporated TiO₂ can induce the electrocatalytic activity for the ORR. In this paper, we report the synthesis method for Nb-incorporated TiO₂ through a hydrothermal process with and without additional load pressures. The electrocatalytic activity of the synthesized samples for the ORR was also demonstrated. In this process, the samples obtained under various load pressures exceeding the saturated vapor pressure featured a high content of Nb and crystalline TiNb₂O₇, resulting in an ellipsoidal morphology. X-ray diffraction results also revealed that, on increasing the Nb doping amounts, the diffraction peak of the anatase TiO₂ shifted to a lower angle and the full width at half maximum decreased. This implies that the Ti atom is exchanged with the Nb atom during this process, resulting in a decrease in TiO₂ crystallinity. At a doping level of 10%, Nb-incorporated TiO₂ exhibited the best electrocatalytic activity in terms of the oxygen reduction current (i_ORR) and onset potential for the ORR (E_ORR); this suggests that 10% Nb-doped samples have the potential for enhancing electrocatalytic activity.

Size Optimization of a N-Doped Graphene Nanocluster for the Oxygen Reduction Reaction

N-Doped graphene nanoclusters (N-GNCs) are promising electrocatalysts for the oxygen reduction reaction (ORR) at the cathode of fuel cells. In this study, the dependence of the ORR activity on the size of N-GNCs was investigated using first-principles calculations based on density functional theory. The maximum electrode potential (U _Max) was estimated from the free energy of the reaction intermediates of the ORR. U _Max was predicted to show a volcanic trend with respect to the cluster size. The results suggest that C₂₁₅H₃₆N with a radius of 13.6 Å is the best candidate for ORRs and is better than platinum in terms of U _Max. The volcano-shaped plot of U _Max is attributed to the switch of the reaction step that determines U _Max, which is caused by the destabilization of reaction intermediates. Such changes in the stability of the intermediates can be explained by the decrease in the local density of states at the reaction site, which is due to the development of the so-called edge state at the zigzag edge. The establishment of experimental techniques to control the cluster size and doping position will be the key to superior catalyst preparation in the future.