Tailoring Photophysical Processes of Perylene-Based Light Harvesting Antenna Systems with Molecular Structure and Solvent Polarity

Bioinspired Self-Assembly of Metalloporphyrins and Polyelectrolytes into Hierarchical Supramolecular Nanostructures for Enhanced Photocatalytic H2 Production in Water

Polypeptides, as natural polyelectrolytes, are assembled into tailored proteins to integrate chromophores and catalytic sites for photosynthesis. Mimicking nature to create the water-soluble nanoassemblies from synthetic polyelectrolytes and photocatalytic molecular species for artificial photosynthesis is still rare. Here, we report the enhancement of the full-spectrum solar-light-driven H2 production within a supramolecular system built by the co-assembly of anionic metalloporphyrins with cationic polyelectrolytes in water. This supramolecular photocatalytic system achieves a H2 production rate of 793 and 685 μmol h-1  g-1 over 24 h with a combination of Mg or Zn porphyrin as photosensitizers and Cu porphyrin as a catalyst, which is more than 23 times higher than that of free molecular controls. With a photosensitizer to catalyst ratio of 10000 : 1, the highest H2 production rate of >51,700 μmol h-1  g-1 with a turnover number (TON) of >1,290 per molecular catalyst was achieved over 24 h irradiation. The hierarchical self-assembly not only enhances photostability through forming ordered stackings of the metalloporphyrins but also facilitates both energy and electron transfer from antenna molecules to catalysts, and therefore promotes the photocatalysis. This study provides structural and mechanistic insights into the self-assembly enhanced photostability and catalytic performance of supramolecular photocatalytic systems.

Efficient Energy Transfer in a Rylene Imide-Based Heterodimer: The Role of Intramolecular Electronic Coupling

The development of antenna molecules with simplified structures can effectively avoid the complex exciton dynamics resulting from conformational mobility. Two distinct heterodimers TP and TBP comprising a perylenediimide (PDI) donor and terrylenediimide (TDI) acting as an energy sink were investigated. Tuned by varying functionalization positions, the bay-to-bay-linked TP offers a strong chromophore coupling, while the bay-to-N-linked TBP exhibits a weak chromophore coupling. Using transient absorption spectroscopy, we found that TP underwent ultrafast vibrational relaxation (τ_VR < 400 fs) from upper vibrational energy levels of the singlet states after pumping at 490 nm, and followed by electron transfer (ET, τ_ET = 2.5 ps) from TDI to PDI. TBP exhibited ultrafast excitation energy transfer (EET, τ_EET = 0.48 ± 0.1 ps) from the excited PDI donor to TDI acceptor, and the subsequent charge transfer (CT) process was almost quenched. This result provides insight into designing novel small molecules capable of efficient energy transfer.

An electron donor-acceptor organic photoactive composite with Schottky heterojunction induced photoelectrochemical immunoassay

A signal enhancement photoelectrochemical (PEC) immunoassay system induced by the composite (PTCs@Au) of electron donor-acceptor with Schottky heterojunction was designed. Carcinoembryonic antigen (CEA) was selected as a model target. Initially, the capture anibody (Ab1) was linked to gold nanoparticles electrodeposited on glassy carbon electrode and sealed by bovine serum albumin. Meanwhile, the organic semiconductor (PTCs) with the structure of electron donor-acceptor was synthetized from perylene tetracarboxylic dianhydride (acceptor) and dopamine (donor) via amidation reaction. Then PTCs@Au composite with Schottky heterojunction was formed through gold nanoparticles in situ reduction and functionalization with PTCs. Next, the detection antibody was labeled by PTCs@Au composite (Ab2-PTCs@Au) as an immuno-probe. The PTCs@Au was introduced via sandwich immune reaction leading to enhancement PEC signal without additional electron donor nor acceptor for achieving quantitative detection of CEA under external light. The proposed immunoelectrode showed dynamic ranges of 0.5 fg mL^-1 to 10 pg mL^-1 and 10 pg mL^-1 to 1 μg mL^-1 with the detection limit of 0.17 fg mL^-1. In addition, this PEC strategy with acceptable selectivity and stability can be potentially applied to detect other targets by choosing appropriate target recognition unit.

Excited state dynamics of BODIPY-based acceptor-donor-acceptor systems: a combined experimental and computational study

Donor-bridge-acceptor systems based on boron dipyrromethene (BODIPY) are attractive candidates for bio-imagining and sensing applications because of their sensitivity to temperature, micro-viscosity and solvent polarity. The optimization of the properties of such molecular sensors requires a detailed knowledge of the relation between the structure and the photophysical behavior in different environments. In this work we have investigated the excited-state dynamics of three acceptor-donor-acceptor molecules based on benzodithiophene and BODIPY in solvents of different polarities using a combination of ultrafast spectroscopy and DFT-based electronic structure calculations. Transient absorption spectra show that upon photoexcitation an initial excited species with an induced absorption band in the near-infrared regime is formed independent of the solvent polarity. The subsequent photophysical processes strongly depend on the solvent polarity. In non-polar toluene this initial excited state undergoes a structural relaxation leading to a delocalized state with partial charge transfer character, while in the more polar tetrahydrofuran a fully charge separated state is formed. The results clearly show how factors such as donor-acceptor distance and restricted rotational motion by steric hindrance can be used to tune the excited state photophysics to optimize such systems for specific applications.

Artificial light-harvesting systems (LHSs) based on boron-difluoride (BF2) hydrazone complexes (BODIHYs)

The hydrazone based BF₂–complexes (BODIHYs; B1–B2) have been synthesized and their photophysical and aggregation behavior have been established. These BODIHYs have been showed light harvesting properties in presence of RhB as acceptor.

Directing charge transfer in perylene based light-harvesting antenna molecules

Directing energy and charge transfer processes in light-harvesting antenna systems is quintessential for optimizing the efficiency of molecular devices for artificial photosynthesis. In this work, we report a novel synthetic method to construct two regioisomeric antenna molecules (1-D2A2 and 7-D2A2), in which the 4-(n-butylamino)naphthalene monoimide energy and electron donor is attached to the perylene monoimide diester (PMIDE) acceptor at the 1- and 7-bay positions, respectively. The non-symmetric structure of PMIDE renders a polarized distribution of the frontier molecular orbitals along the long axis of this acceptor moiety, which differentiates the electron coupling between the donor, attached at either the 1- or the 7-position, and the acceptor. We demonstrate that directional control of the photo-driven charge transfer process has been obtained by engineering the molecular structure of the light-harvesting antenna molecules.

Fine-Tuning the Electronic Properties of Azo Chromophore-Incorporated Perylene Bisimide Dyads

Perylene bisimide (PBI) and azo-compounds are fascinating molecules with interesting optical properties. Here, we combine the two chromophores to prepare nonconjugated and conjugated stable azo-PBI dyes. The detailed structural characterization, comparison of properties, and solid-state self-assembly of the compounds are discussed. The incorporation of azo groups at the bay side of PBI led to significant changes in optical properties as compared to the model PBIs (M₁ and M₂). All new azo-PBIs showed photoinduced isomerization, which caused disaggregation and enhancement in fluorescence. The amine-incorporated azo-PBIs (3 and 6) reduced chloroauric acid into gold nanoparticles. The current study offers a simple synthetic strategy and comparison of the properties of conjugated and nonconjugated azo-PBIs, which could be useful in photoelectronic devices.

Efficacious elimination of intramolecular charge transfer in perylene imide based light-harvesting antenna molecules

Two light-harvesting antenna molecules were obtained by positioning naphthalene monoimide energy donors at the imide position, instead of the bay positions, of perylene imide energy acceptors. Such rational design resulted in a complete suppression of parasitic intramolecular charge transfer without compromising the desired ultrafast rates of excitation energy transfer.

Bridge-Mediated Charge Separation in Isomeric N-Annulated Perylene Diimide Dimers

The possibility and rate of charge separation (CS) in donor-bridge-acceptor molecules mainly depend on two factors: electronic coupling and solvent effects. The question of how CS occurred in two identical chromophores is fundamental, as it is particularly interesting for potential molecular electronics applications and the photosynthetic reaction centers (RCs). Conjugated bridge definitely plays a crucial role in electronic coupling. To determine the bridge-mediated charge separation dynamics between the two identical chromophores, the isomeric N-annulated perylene diimide dimers (para-BDNP and meta-BDNP) with different conjugated bridge structures have been comparatively investigated in different solvents using femtosecond transient absorption spectra (fs-TA). It is found that the charge separation is disfavored in weak polar solvent, whereas direct spectroscopic signatures of radicals are observed in polar solvents, and the rate of charge separation increases as the solvent polarity increasing. To our surprise, the rate of charge separation in m-BDNP is more than an order of magnitude slower than that in p-BDNP, although there is a larger negative ΔG_CS in m-BDNP. The slow CS rate that occurred in m-BDNP mainly results from the intrinsic destructive interference of the wave function through the meta-substituted bridge. The roles of solvent effects in free energy and electronic coupling for charge separation are further identified with quantum calculations.