Probing Interfacial Structure and Dynamics of Model and Natural Asphaltenes at Fluid-Fluid Interfaces

Probing the interfacial behaviors of interfacially active and non-active asphaltenes and their impact on emulsion stability

HYPOTHESIS

Asphaltenes subfractions with distinct interfacial behaviors may play different roles in stabilizing oil-water emulsions.

EXPERIMENTS

In this work, whole asphaltenes were separated into interfacially active asphaltenes (IAA) and interfacially non-active asphaltenes (INAA). Employing advanced nanomechanical techniques, we have explored the compositions, morphologies, sizes, adsorption, and interfacial behaviors of IAA and INAA.

FINDINGS

IAA exhibits a high and unevenly distributed oxygen content, distinguishing it from INAA. In toluene, the diameters of IAA and INAA are about 60 nm and 6 nm, respectively. When adsorbed irreversibly on mica surfaces, the thickness of the IAA and INAA film was measured at ∼5.5 nm or 1 nm, respectively; while in a toluene solution, the film thickness reached ∼46 nm and 3.1 nm for IAA and INAA, respectively. IAA demonstrates superior interfacial activity, and elastic/viscous moduli compared to INAA at the water-toluene interface. Quantified surface force measurements reveal that IAA stabilizes water droplets in toluene at a concentration of only 10 mg/L, while INAA requires a higher concentration of 100 mg/L. This work provides the first comprehensive investigation into the adsorption and interfacial behaviors of asphaltene subfractions and provides useful insights into the asphaltenes-stabilization mechanism of emulsions.

Effects of chemical dispersant on the surface properties of kaolin and aggregation with spilled oil

After oil spills occur, dispersed oil droplets can collide with suspended particles in the water column to form the oil-mineral aggregate (OMA) and settle to the seafloor. However, only a few studies have concerned the effect of chemical dispersant on this process. In this paper, the mechanism by which dispersant affects the surface properties of kaolin and the viscosity and oil-seawater interfacial tension (IFT_ow) of Roncador crude oil were separately investigated by small-scale tests. The results indicated that the presence of dispersant impairs the zeta potential and enhances the hydrophobicity of kaolin. The viscosity of Roncador crude oil rose slightly as the dosage of dispersant increased, while IFT_ow decreased significantly. Furthermore, the oil dispersion and OMA formation at different dispersant-to-oil ratio (DOR) were evaluated in a wave tank. When DOR was less than 1:40, the effect of dispersant on the dispersion of spilled oil was not obvious. With the increasing DOR, the effect became more pronounced, and the adhesion between oil droplets and kaolin was inhibited. The size ratio between oil droplets and particles is the significant factor for OMA formation. The closer the oil-mineral size ratio is to 1, the more difficultly the OMA forms.

Effect of Oil-Displacing Agent Composition on Oil/Water Interface Stability of the Asphaltene-Rich ASP Flooding-Produced Water

In this work, the effect of oil-displacing agent composition on oil/water interface stability of the asphaltene-rich alkali-surfactant-polymer (ASP) flooding-produced water was systematically investigated, especially from the perspective of the interaction between oil displacement agents and asphaltene at the oil/water interface. Primarily, adsorption behavior of the artificial and natural interfacial substances (oil displacement surfactant and asphaltenes) on the oil/water interface was investigated by molecular dynamics simulation. The oil displacement surfactant and asphaltenes formed a cross-linked and compact interfacial film structure, which significantly enhanced the interface stability; the more the oil displacement surfactants adsorbed on the interface, the more stable is the cross-linked structure formed between them and asphaltenes. Then, the interfacial property variations that are originating from the interactions differences between oil displacement agents and asphaltenes were monitored via interfacial tension, zeta potential, and interfacial film rheology tests. Moreover, the effect of oil displacement agent concentrations on the interfacial film thinning and rupture kinetic behavior was further investigated. Finally, cream experiments were conducted to verify the effect of oil displacement agent composition on the oil/water separation efficiencies of asphaltene-rich ASP flooding-produced water. When 5% asphaltenes was added, the creaming oil removal rate reduced from 90.0 to 85.3% at 19 h. The interactions between asphaltenes and oil displacement agents immensely enhance the oil/water interfacial film strength and impede the oil/water separation process.

Deviation from Equilibrium Thermodynamics of an Asphaltene Model Compound during Compression-Expansion Experiments at Fluid-Fluid Interfaces

Asphaltenes play a crucial role in crude oil behavior, and model compounds are often used to capture, mimic, and predict certain interfacial properties. In previous works, sorption of an asphaltene model compound (C5PeC11) was studied using surface pressure isotherms, where a deviation from the expected thermodynamic behavior of the interface during decane-water and air-water compression experiments was observed but not explained. In this work, the interfacial behavior of C5PeC11 was assessed at the decane-water and the air-water interfaces using a multiscale approach that includes: compression-expansion experiments on rectangular and radial Langmuir troughs, dynamic interfacial stress relaxation, and fluorescence microscopy imaging. Connections between molecular and microscopic phenomena strongly suggest that the nonthermodynamic response can be explained through a dynamic effect whose origin lies in the predominance of intermolecular forces in C5PeC11 molecules over the mechanical compression force applied. When aggregation begins at the air-water interface, stable structures are formed, and the nonthermodynamic phenomenon is not observed in subsequent compressions. However, at the decane-water interface, the initial aggregation is not consolidated due to the effect of the oil phase on the free energy of the interface allowing the high reproducibility of the dynamic effect in subsequent compression cycles. These results highlight the need to probe interfacial systems at various length scales to adequately separate equilibrium thermodynamics from dynamic responses.

Assessing the Interfacial Activity of Insoluble Asphaltene Layers: Interfacial Rheology versus Interfacial Tension

Asphaltenes have been suggested to play an important role in the remarkable stability of some water-in-crude oil emulsions, although the precise mechanisms by which they act are not yet fully understood. Being one of the more polar fractions in crude oils, asphaltenes are surface active and strongly adsorb at the oil/water interface, and as the interface becomes densely packed, solid-like mechanical properties emerge, which influence many typical interfacial experiments. The present work focuses on purposefully measuring the rheology in the limit of an insoluble, spread Langmuir monolayer in the absence of adsorption/desorption phenomena. Moreover, the changes in surface tension are deconvoluted from the purely mechanical contribution to the surface stress by experiments with precise interfacial kinematics. Compression "isotherms" are combined with the measurement of both shear and dilatational rheological properties to evaluate the relative contributions of mechanical versus thermodynamic aspects, i.e., to evaluate the "interfacial rheological" versus the standard interfacial activity. The experimental results suggest that asphaltene nanoaggregates are not very efficient in lowering interfacial tension but rather impart significant mechanical stresses. Interestingly, physical aging effects are not observed in the spread layers, contrary to results for adsorbed layers. By further studying asphaltene fractions of different polarity, we investigate whether mere packing effects or strong interactions determine the mechanical response of the dense asphaltene systems as either soft glassy or gel-like responses have been reported. The compressional and rheological data reflect the dense packing, and the behavior is captured well by the soft glassy rheology model, but a more complicated multilayer structure may develop as coverage is increased. Potential implications of the experimental observations on these model and insoluble interfaces for water-in-crude oil emulsion stability are briefly discussed.