Clathrate Hydrate Inhibition by Polyisocyanate with Diethylammonium Group

Molecular Insights into the Dual Promotion-Inhibition Effects of NaCl at Various Concentrations on the CO2 Hydrate Growth: A Molecular Simulation Study

Hydrate-based CO2 storage in the ocean is considered a potential method for mitigating the greenhouse effect. Numerous studies demonstrated that NaCl exhibited the dual effects of promotion and inhibition in the nucleation and growth processes of CO2 hydrate, whose mechanisms remain unclear. In this study, the effects of NaCl at various concentrations on the CO2 hydrate growth and crystal are investigated. The independent gradient model based on Hirshfeld partition, electrostatic potential, and binding energy is conducted to study the interaction between ions and water molecules. The motion trajectories of ions are observed at the molecular level to reflect the impact of ion motion on hydrate growth. The results show that the influence of NaCl on hydrate growth depends on a delicate balance of dual promotion-inhibition effects. NaCl can combine more water molecules and provide a transport channel of CO2 to promote hydrate growth at low concentrations. Meanwhile, the promoting effects shift toward inhibition with increasing NaCl concentrations. In a word, this paper proposes a novel mechanism for the dual promotion-inhibition effects of NaCl on hydrate growth, which is significant for further research on hydrate-based CO2 storage in the ocean.

Interfacial Adhesion Forces of Hydrate Particles in the Presence of Hydrate Inhibitors

Hydrate inhibitors are traditionally utilized to prevent hydrate plugging. In this study, the adhesion forces of cyclopentane (CP) hydrates with thermodynamic inhibitors (ethanol, urea, and NaCl) and anti-agglomerant inhibitors [sorbitan monooleate (Span 80) and lecithin] were measured to understand the effects of hydrate inhibitors on the adhesion forces of hydrates. It was found that the thermodynamic inhibitors increased the early hydrate interparticle adhesion force due to the enhanced liquid bridge force. However, the liquid bridge acted as a lubricant layer to prevent the irreversible agglomeration of hydrate after long-term contact. The hydrate adhesion forces decreased by 90.5-93.0% and 76.6-92.7% with an increase in the concentration of Span 80 and lecithin, respectively, from 0.1 to 1 wt %. Both rough morphology and low interfacial tension contributed to the adhesion force decrease of hydrate after the addition of anti-agglomerant inhibitors. The results may be helpful for understanding the mechanism of influence and quantifying the impact of hydrate inhibitors on hydrate interparticle adhesion force.

Synthesis of Alternating Polyisocyanate Copolymers by Anionic Polymerization for Mimicking Amphiphilic Helical Peptides

The amphiphilic conformation of α-helical peptides has important biological functions, such as ion transport, antifreeze, and innate immunity, which can be mimicked by alternating polyisocyanate copolymers. We synthesized poly(allyl isocyanate-alt-(S)-(-)-α-methylbenzyl isocyanate (P(AIC-alt-SMBIC)) and ammonium-containing P(AIC-alt-SMBIC) (N-P(AIC-alt-SMBIC)), ensuring the amphiphilic helical conformation. The benzyl group of SMBIC plays an important role in alternating copolymerization with its steric and electron-withdrawing effects, while AIC provides an alkene group capable of introducing a customized functional group. The P(AIC-alt-SMBIC) with predominantly alternating sequence was acquired at f_SMBIC /f_AIC =8 with a controlled molecular weight and narrow dispersity. N-P(AIC-alt-SMBIC)s were synthesized from thiol-ene radical addition with P(AIC-alt-SMBIC).

Unraveling Amphiphilic Poly(N-vinylcaprolactam)/Water Interface by Nuclear Magnetic Resonance Relaxometry: Control of Clathrate Hydrate Formation Kinetics

Water-soluble amphiphilic polymers are vital chemicals in the oil and gas industry to retard crystal growth of hydrocarbon hydrate via surface adsorption and suppress nucleation of a pristine hydrate nucleus, thereby preventing formation of hydrate blockages in flow lines during oil and natural gas production. Apart from a few theoretical modeling studies, an experimental method to study the polymer/water interface in the crystal growth is critically needed. Here, water motions in the hydration shells of an exemplary kinetic inhibitor, poly(N-vinylcaprolactam), during hydrate formation from the tetrahydrofuran/water system are revealed via nuclear magnetic resonance relaxometry. Unequivocal experiments show that the pivotal interfacial water in the tightly bound state gradually freezes at rates depending on the polymer molecular weight (MW). This is supported by nonfreezable water analysis, which is correlated to the inhibition time. The polymers tune the kinetics of the hydration process via interaction with and perturbation of the water molecules. The free water component in the polymer solution crystallizes at a very slow rate when in partially restricted mobility, whereas the bound water component increases in the reaction, with the polymer/water interface serving as the reaction sites. The appropriate MW (including average MW and polydispersity values) of the inhibitive polymers can give rise to maximal retardation of the hydrate crystal growth. This work will help control other multiphase crystallization kinetic processes through the design of inhibitors or promoters functioning in the interface.

Effect of Thiouronium-Based Ionic Liquids on the Formation and Growth of CO2 (sI) and THF (sII) Hydrates

In this manuscript, two thiouronium-based ionic liquids (ILs), namely 2-ethylthiouronium bromide [C₂th][Br] and 2-(hydroxyethyl)thiouronium bromide [C₂OHth][Br], were tested at different concentrations (1 and 10 wt%) for their ability to affect CO₂ (sI) and tetrahydrofuran (THF) (sII) hydrate formation and growth. Two different methods were selected to perform a thermodynamic and kinetic screening of the CO₂ hydrates using a rocking cell apparatus: (i) an isochoric pressure search method to map the hydrate phase behavior and (ii) a constant ramping method to obtain the hydrate formation and dissociation onset temperatures. A THF hydrate crystal growth method was also used to determine the effectiveness of the ILs in altering the growth of type sII hydrates at atmospheric pressure. Hydrate–liquid–vapor equilibrium measurements revealed that both ILs act as thermodynamic inhibitors at 10 wt% and suppress the CO₂ hydrate equilibria ~1.2 °C. The constant ramping methodology provides interesting results and reveals that [C₂OHth][Br] suppresses the nucleation onset temperature and delays the decomposition onset temperatures of CO₂ hydrates at 1 wt%, whereas suppression by [C₂th][Br] was not statistically significant. Normalized pressure plots indicate that the presence of the ILs slowed down the growth as well as the decomposition rates of CO₂ hydrates due to the lower quantity of hydrate formed in the presence of 1 wt% ILs. The ILs were also found to be effective in inhibiting the growth of type sII THF hydrates without affecting their morphology. Therefore, the studied thiouronium ILs can be used as potential dual-function hydrate inhibitors. This work also emphasizes the importance of the methods and conditions used to screen an additive for altering hydrate formation and growth.

Kinetic Inhibition of Clathrate Hydrate by Copolymers Based on N-Vinylcaprolactam and N-Acryloylpyrrolidine: Optimization Effect of Interfacial Nonfreezable Water of Polymers

Amphiphilic polymers have now been designed to achieve an icephobic performance and have been used for ice adhesion prevention. They may function by forming a strongly bonded but nonfreezable water shell which serves as a self-lubricating interfacial layer that weakens the adhesion strength between ice and the surface. Here, an analogous concept is built to prevent the formation of clathrate hydrate compounds during oil and natural gas production, in which amphiphilic water-soluble polymers act as efficient kinetic hydrate inhibitors (KHIs). A novel group of copolymers with N-vinylcaprolactam and N-acryloylpyrrolidine structural units are investigated in this study. The relationships among the amphiphilicity, lower critical solution temperature, nonfreezable bound water, and kinetic hydrate inhibition time are analyzed in terms of the copolymer compositions. Low-field NMR relaxometry revealed the crucial interfacial water in tightly bound dynamic states which led to crystal growth rates changing with the copolymer compositions, in accord with the rotational rheometric analysis results. The nonfreezable bound water layer confirmed by a calorimetry analysis also changes with the polymer amphiphilicity. Therefore, in the interface between the KHI polymers and hydrate, water surrounding the polymers plays a critical role by helping to delay the nucleation and growth of embryonic ice/hydrates. Appropriate amphiphilicity of the copolymers can achieve the optimal interfacial properties for slowing down hydrate crystal growth.

Effect of the Ethylene Vinyl Acetate Copolymer on the Induction of Cyclopentane Hydrate in a Water-in-Waxy Oil Emulsion System

In this paper, the effect of the ethylene vinyl acetate (EVA) copolymer, commonly used in improving rheological behavior of waxy oil, is introduced to investigate its effect on the formation of cyclopentane hydrate in a water-in-waxy oil emulsion system. The wax content studied shows a negative effect on the formation of hydrate by elongating its induction time. Besides, the EVA copolymer is found to elongate the induction time of cyclopentane hydrate through the cocrystallization effect with wax molecules adjacent to the oil-water interface.