Antisurfactant (Autophobic) Behavior of Superspreader Surfactant Solutions

Coal-Based Branched Vicinal Diol Ethoxylates Versus Guerbet Alcohol Ethoxylates: Role of Tertiary Hydroxyl Groups

Branched surfactants exhibit a lower surface tension, excellent low defoaming performance, and better wetting ability compared with linear surfactants, making them promising for applications in industrial cleaning. In this study, 2-hexyl-1-decene (C8 olefin dimer), obtained from the dimerization of 1-octene, was used as the hydrophobe to synthesize branched nonionic surfactants via hydroxylation and ethoxylation. The hydroxylation of the C8 olefin dimer to synthesize 2-hexyldecane-1,2-diol (C8 BD) using H2O2 and HCOOH was investigated systematically. Under the optimal reaction conditions (H2O2/C8 olefin dimer molar ratio: 1.5, HCOOH/C8 olefin dimer molar ratio: 4.0, reaction time: 10 h, reaction temperature: 50 °C), the conversion of the C8 olefin dimer and selectivity toward C8 BD were found to reach 99.96 and 79.89%, respectively. Further, branched nonionic surfactants (C8 BDEn) were synthesized via ethoxylation of C8 BD with ethylene oxide and characterized using FTIR, LCMS, 1H NMR, and 13C NMR techniques. The presence of a tertiary hydroxyl group in C8 BD increases the reactivity of the primary hydroxyl group, leading to a narrower range of products and lower residual substrate content. The physicochemical properties and surface properties of C8 BDEn with different degrees of ethoxylation at various concentrations were investigated and compared with those of commercially available Guerbet alcohol polyoxyethylene ethers (C8 GAEO9 and C6 GAEO9). The results show that, compared with C8 GAEO9 and C6 GAEO9, C8 BDE6 displayed a higher surface activity with a lower equilibrium surface tension (27.14 mN·m-1), superior wettability with a smaller contact angle (39.2°), better emulsification performance with a longer emulsification time of 548 s, and excellent foaming properties (initial foam volume of 11.6 mL). This strategy of utilizing coal-based α-olefins for the synthesis of branched nonionic surfactants presents a route to prepare value-added fine chemicals from coal-based resources.

Effect of surfactant on urease-producing flora from waste activated sludge using microbially induced calcite precipitation technology to suppress coal dust

The wettability of microbially induced calcite precipitation (MICP) is a challenge in dust suppression. Herein, the tolerance of urease-producing flora to surfactants was investigated. The optimal tolerance concentrations of the urease-producing flora to sodium dodecylbenzene sulfonate (SDBS, anionic surfactant), alkyl polyglycoside (APG, non-ionic surfactant), and cocamidopropyl betaine (CAB, zwitterionic surfactant), and were 0.2%, 0.1%, and 0.05%. The cetyltrimethylammonium bromide (CTAB, cationic surfactant) inhibited urease production by urease-producing flora. The mineralization products of SDBS, APG, and CAB treatments were all transformed into calcite. The wind resistance test showed that the mass loss of all samples is less than 0.1%. The rain resistance and hardness tests showed that 0.2% SBDS had the best effect, followed by 0.1% APG and 0.05% CAB, and finally, No surfactants. Microbiome analysis showed that the abundance of Sporosarcina and Unclassified_bacillaceae reduced, and the intense competition between Paenalcaligenes and Sporosarcina are essential reasons for reducing urease activity. SDBS and APG could reduce the pathogenic risk of microbial dust suppressants. This study will facilitate the practical application of microbial dust suppressants.

Tuning Contact Angles of Aqueous Droplets on Hydrophilic and Hydrophobic Surfaces by Surfactants

Adsorption of small amphiphilic molecules occurs in various biological and technological processes, sometimes desired while other times unwanted (e.g., contamination). Surface-active molecules preferentially bind to interfaces and affect their wetting properties. We use molecular dynamics simulations to study the adsorption of short-chained alcohols (simple surfactants) to the water–vapor interface and solid surfaces of various polarities. With a theoretical analysis, we derive an equation for the adsorption coefficient, which scales exponentially with the molecular surface area and the surface wetting coefficient and is in good agreement with the simulation results. We apply the outcomes to aqueous sessile droplets containing surfactants, where the competition of surfactant adsorptions to both interfaces alters the contact angle in a nontrivial way. The influence of surfactants is the strongest on very hydrophilic and hydrophobic surfaces, whereas droplets on moderately hydrophilic surfaces are less affected.

Adsorption of CTAB on Sapphire-c at High pH: Surface and Zeta Potential Measurements Combined with Sum-Frequency and Second-Harmonic Generation

The adsorption of cetyltrimethylammonium bromide (CTA⁺Br^-) on sapphire-c surfaces was studied at pH 10 below the surfactants' critical micelle concentration. The evolution of interfacial potentials as a function of CTAB concentration was characterized by surface and zeta potential measurements and complemented by molecular dynamic (MD) simulations as well as by second-harmonic (SHG) and vibrational sum-frequency generation (SFG) spectroscopy. The changes in interfacial potentials suggest that the negative interfacial charge due to deprotonated surface aluminols groups is neutralized and can be even overcompensated by the presence of CTA⁺ cations at the interface. However, SFG intensities from strongly hydrogen-bonded interfacial water molecules as well as SHG intensities decrease with both increasing CTAB concentration and the magnitude of the surface potential. They do not suggest a charge reversal at the interface, while the change in zeta potential is actually consistent with an apparent charge inversion. This can be qualitatively explained by results from MD simulation, which reveal adsorbed CTA⁺ cations outside a first strongly bound hydration layer of water molecules, where they can locally distort the structural order and replace some of the interfacial water molecules adjacent to the first layer. This is proposed to be the origin for the significant loss in SFG and SHG intensities with increasing CTAB concentration. Moreover, we propose that CTA⁺ can act as a counterion and enhance the occurrence of deprotonated surface aluminols that is consistent with the decrease in surface potential.