Ultralow voltage irreversible electrowetting dynamics of an aqueous drop on a stainless steel surface

Transition of interfacial capacitors in electrowetting on a graphite surface by ion intercalation

The low voltage electrowetting response of a LiCl aqueous solution on a freshly cleaved surface of highly oriented pyrolytic graphite (HOPG) is presented. For applied voltages below 1 V, the energy stored in the electrical double layer (EDL) is insufficient to drive the spreading of the drop due to the pinning of the three phase contact line at the step edges. Electrochemical impedance spectroscopy shows a dramatic increase in capacitance above 1 V, which provides a sufficient electrowetting force for depinning the contact line, resulting in a subsequent decrease of the contact angle. The transition of the interfacial capacitance from the EDL to the many-fold high capacitance of the pseudocapacitor drives the electrowetting transition on the HOPG surface. The observed changes in the capacitances above 1 V are correlated with the cyclic voltammetry and atomic force microscopy results, which show that the Cl- ions intercalate into the graphite galleries upon acquiring sufficient energy to overcome the van der Waals attraction between the graphene layers through the side of the step edge of the basal planes. To the best of our knowledge, this is the first study on the voltage dependent intercalation mediated transition of interfacial capacitance driving the spreading of an aqueous electrolyte drop on the HOPG surface, which provides a fundamental understanding of the mechanism and opens up potential applications in microfluidics and charge storage technologies.

Electrowetting on conductors: anatomy of the phenomenon

We have recently reported that reversible electrowetting can be observed on the basal plane of graphite, without the presence of a dielectric layer, in both liquid/air and liquid/liquid configurations. The influence of carbon structure on the wetting phenomenon is investigated in more detail here. Specifically, it is shown that the adsorption of adventitious impurities on the graphite surface markedly suppresses the electrowetting response. Similarly, the use of pyrolysed carbon films, although exhibiting a roughness below the threshold previously identified as the barrier to wetting on basal plane graphite, does not give a noticeable electrowetting response, which leads us to conclude that specific interactions at the water–graphite interface as well as graphite crystallinity are responsible for the reversible response seen in the latter case. Preliminary experiments on mechanically exfoliated and chemical vapour deposition grown graphene are also reported.

Low-Voltage Voltammetric Electrowetting of Graphite Surfaces by Ion Intercalation/Deintercalation

We demonstrate low-voltage electrowetting at the surface of freshly cleaved highly oriented pyrolytic graphite (HOPG). Using cyclic voltammetry (CV), electrowetting of a droplet of a sodium perchlorate solution is observed at moderately positive potentials on high-quality (low step edge coverage) HOPG, leading to significant changes in the contact angle and relative contact diameter that are comparable to the results of the widely studied electrowetting on dielectric (EWOD) system, but over a much lower voltage range. The electrowetting behavior is found to be reasonably fast, reversible, and repeatable for at least 20 cyclic scans (maximum tested). In contrast to classical electrowetting, e.g., EWOD, the electrowetting of the droplet on HOPG occurs with the intercalation/deintercalation of anions between the graphene layers of graphite, driven by the applied potential, observed in the CV response, and detected by X-ray photoelectron spectroscopy. The electrowetting behavior is strongly influenced by those factors that affect the extent of the intercalation/deintercalation of ions on graphite, such as potential range scan rate, potential polarity, quality of the HOPG substrate (step edge density and step height), and type of anion in the solution. In addition to perchlorate, sulfate salts also promote electrowetting, but some other salts do not. Our findings suggest a new mechanism for electrowetting based on ion intercalation, and the results are important to fundamental electrochemistry as well as to diversifying the means by which electrowetting can be controlled and applied.