Microfluidic Devices Containing ZnO Nanorods with Tunable Surface Chemistry and Wetting-Independent Water Mobility

3D Printing Manufacturing of Polydimethyl-Siloxane/Zinc Oxide Micro-Optofluidic Device for Two-Phase Flows Control

Tailored ZnO surface functionalization was performed inside a polydimethyl-siloxane (PDMS) microchannel of a micro-optofluidic device (mofd) to modulate its surface hydrophobicity to develop a method for fine tuning the fluid dynamics inside a microchannel. The wetting behavior of the surface is of particular importance if two different phases are used for system operations. Therefore, the fluid dynamic behavior of two immiscible fluids, (i) air–water and (ii) air–glycerol/water in PDMS mofds and ZnO-PDMS mofds was investigated by using different experimental conditions. The results showed that air–glycerol/water fluid was always faster than air–water flow, despite the microchannel treatment: however, in the presence of ZnO microstructures, the velocity of the air–glycerol/water fluid decreased compared with that observed for the air–water fluid. This behavior was associated with the strong ability of glycerol to create an H-bond network with the exposed surface of the zinc oxide microparticles. The results presented in this paper allow an understanding of the role of ZnO functionalization, which allows control of the microfluidic two-phase flow using different liquids that undergo different chemical interactions with the surface chemical terminations of the microchannel. This chemical approach is proposed as a control strategy that is easily adaptable for any embedded micro-device.

Elastic-Modulus-Dependent Macroscopic Supramolecular Assembly of Poly(dimethylsiloxane) for Understanding Fast Interfacial Adhesion

Macroscopic supramolecular assembly (MSA) is a new concept of supramolecular science with an emphasis on noncovalent interactions between macroscopic building blocks with sizes exceeding 10 μm. Owing to a similar noncovalently interactive nature with the phenomena of bioadhesion, self-healing, etc. and flexible features in tailoring and designing modular building blocks, MSA has been developed as a simplified model to interpret interfacial phenomena and a facile method to fabricate supramolecular materials. However, at this early stage, MSA has always been limited to hydrogel materials, which provide flowability for high molecular mobility to the interfacial binding. The extension to a wide range of materials for MSA is desired. Herein, we have developed a strategy of adjusting intrinsic properties (e.g., elastic modulus) of nonhydrogel materials to realize MSA, which could broaden the material choices of MSA. Using the widely used elastomer of poly(dimethylsiloxane) (PDMS) as building blocks, we have demonstrated the elastic-modulus-dependent MSA of PDMS based on the host/guest molecular recognition between supramolecular groups of β-cyclodextrin and adamantane. In the varied elastic modulus range of 0.38 to 3.84 MPa, we obtained the trend of the MSA probability decreasing from 100% at 0.38 MPa to 0% at 3.84 MPa. Meanwhile, in situ measurements of interactive forces between PDMS building blocks have supported the observed assembly phenomena. The underlying reasons are interpreted with the low-modulus flexible surfaces favoring for high molecular mobility to achieve interactions between multiple sites at the interface based on the theory of multivalency. Taken together, we have demonstrated the feasibility of directly adjusting the modulus of bulk materials to realize MSA of nonhydrogel materials, which may provide clues to the fast wet adhesion and new solutions to the additive manufacture of elastomer materials.