Tailored Design of Differently Modified Mesoporous Materials To Deeply Understand the Adsorption Mechanism for Polycyclic Aromatic Hydrocarbons

Sub-THz Vibrational Dynamics in Ordered Mesoporous Silica Nanoparticles

The vibrational dynamics in the sub-THz range of mesoporous silica nanoparticles (MSNs) having ordered cylindrical mesopores was investigated. MCM-41 and SBA-15 particles were synthesized, and their structure was determined using scanning electron microscopy (SEM), low-angle X-ray diffraction (XRD), N₂ physisorption analyses, and Raman scattering. Brillouin scattering measurements are reported and enabled determining the stiffness of the silica walls (speed of sound) using finite element calculations for the ordered mesoporous structure. The relevance of this approach is discussed based on the comparison between the numerical and experimental results and previous works reported in the literature.

Contributions of partition and adsorption to polycyclic aromatic hydrocarbons sorption by fractionated soil at different particle sizes

Partition and adsorption of polycyclic aromatic hydrocarbons (PAHs) are critical mechanisms determining their fate at the solid-liquid interface. The complexity of soil composition makes it difficult to distinguish between partition and adsorption, and bates the accuracy of the research results. This study found that the composition and structure of the soil particles (SAs) of varying particle sizes were significantly different. Partition contributed significantly to phenanthrene (Phe) sorption in SAs over 0.002 mm. However, PAHs had the highest sorption coefficient (K_d) in SA less than 0.002 mm (SA-3), and the lower aqueous phase equilibrium concentration of Phe, the greater the adsorption effect. According to morphology and structural analysis, Fourier transform infrared (FTIR) and X-ray photoelectron spectroscopy (XPS), interactions of micropores, soil organic matter (SOM) and minerals enhanced the sorption of PAHs. Additionally, thermogravimetry and mass spectrometry (TG-MS) results proved that SOM could inhibit the release of PAHs adsorbed in SAs during heating process. We observed that the Log Koc of PAHs was the most important factor in determining the K_d in SAs applying principal component analyses (PCA), and they have significant linear relationships (R² = 0.79-0.93). These findings provide new understandings on interface reactivity of PAHs sorption to soils and the development of interface model.

Adsorption of polycyclic aromatic hydrocarbons from wastewater using graphene-based nanomaterials synthesized by conventional chemistry and green synthesis: A critical review

Polycyclic aromatic hydrocarbons (PAHs) are organic pollutants formed mainly by the incomplete combustion of organic matter, such as oil, gas and coal. The presence of PAHs can cause irreparable damage to the environment and living beings, which has generated a global concern with the short and long term risks that the emission of these pollutants can cause. Many technologies have been developed in the last decades aiming at the identification and treatment of these compounds, mainly, the PAHs from wastewater. This review features an overview of studies on the main methods of PAHs remediation from wastewater, highlighting the adsorption processes, through the application of different adsorbent nanomaterials, with a main focus on graphene-based nanomaterials, synthesized by conventional and green routes. Batch and fixed-bed adsorptive processes were evaluated, as well as, the mechanisms associated with such processes, based on kinetic, equilibrium and thermodynamic studies. Based on the studies analyzed in this review, green nanomaterials showed higher efficiency in removing PAHs than the conventional nanomaterials. As perspectives for future research, the use of green nanomaterials has shown to be sustainable and promising for PAHs remediation, so that further studies are needed to overcome the possible challenges and limitations of green synthesis methodologies.

An Overview and Evaluation of Highly Porous Adsorbent Materials for Polycyclic Aromatic Hydrocarbons and Phenols Removal from Wastewater

Polycyclic aromatic hydrocarbons (PAHs) and phenolic compounds had been widely recognized as priority organic pollutants in wastewater with toxic effects on both plants and animals. Thus, the remediation of these pollutants has been an active area of research in the field of environmental science and engineering. This review highlighted the advantage of adsorption technology in the removal of PAHs and phenols in wastewater. The literature presented on the applications of various porous carbon materials such as biochar, activated carbon (AC), carbon nanotubes (CNTs), and graphene as potential adsorbents for these pollutants has been critically reviewed and analyzed. Under similar conditions, the use of porous polymers such as Chitosan and molecularly imprinted polymers (MIPs) have been well presented. The high adsorption capacities of advanced porous materials such as mesoporous silica and metal-organic frameworks have been considered and evaluated. The preference of these materials, higher adsorption efficiencies, mechanism of adsorptions, and possible challenges have been discussed. Recommendations have been proposed for commercialization, pilot, and industrial-scale applications of the studied adsorbents towards persistent organic pollutants (POPs) removal from wastewater.

Enhanced fluoride removal from water by rare earth (La and Ce) modified alumina: Adsorption isotherms, kinetics, thermodynamics and mechanism

The removal of F^- from aqueous solution using lanthanum and cerium modified mesoporous alumina (La/MA and Ce/MA) was studied, and characteration of the adsorbents by XRD, BET, XRF, FTIR, TEM, XPS and the pH_ZPC measurements were carried out. The adsorption was investigated in both batch and column adsorption systems. Batch experimental results showed that adsorption capacities of adsorbents were recorded in the following order: La/MA > Ce/MA > mesoporous alumina (MA). Besides, adsorption datas were fitted well by Sips isotherm model and Elovich kinetics model, and the maximum adsorption capacity of La/MA was 26.45 mg·g^-1 in Sips model at the dosage of 2.0 g·L^-1 and near neutral condition (pH = 6.0 ± 0.1). Moreover, thermodynamic parameters were illustrated that adsorption process of fluoride ion over La/MA was spontaneous and endothermic. In the adsorption process, the interaction between metal and fluoride, the adsorption capacity was increased due to form the bond of M···F (M = La or Ce). Furthermore, the influence of coexisted anions on F^- removal was investigated, and it was indicated that removal efficiency was slightly affected by the presence of Cl^- and NO₃^-, while SO₄^2- and CO₃^2- caused a sharp fall in removal efficiency. Column experiments results were indicated that time of break-through of La/MA was twice as much as that of MA.