Can Polymer Chains Cross Each Other and Still Be Entangled?

Microstructural Dynamics of Polymer Melts during Stretching: Radial Size Distribution

The transient elongational viscosity ηe(t) of the polymer melt is known to exhibit strain hardening, which depends on the strain rate ε˙. This phenomenon was elucidated by the difference of chain stretching in the entanglement network between extension and shear. However, to date, the microscopic evolution of polymer melt has not been fully statistically analyzed. In this work, the radial size distributions P(Rg,t) of linear polymers are explored by dissipative particle dynamics during the stretching processes. In uniaxial extensional flow, it is observed that the mean radius of gyration R¯g(t) and standard deviation σ(t) remain unchanged until the onset of strain hardening, corresponding to linear viscoelasticity. Both R¯g and σ rise rapidly in the non-linear regime, and bimodal size distribution can emerge. Moreover, the onset of strain hardening is found to be insensitive to the Hencky strain (ε˙Ht) and chain length (N).

Crystallization of semiflexible polymers in melts and solutions

We studied the crystallization of semiflexible polymer chains in melts and poor-solvent solutions with different concentrations using dissipative particle dynamics (DPD) computer simulation techniques. We used the coarse-grained polymer model to reveal the general principles and microscopic scenario of crystallization in such systems at large time and length scales. It covers both primary and secondary nucleation as well as crystallites' merging. The parameters of the DPD model were chosen appropriately to reproduce the entanglements of polymer chains. We started from an initial homogeneous disordered solution of Gaussian chains and observed the initial stages of crystallization process caused in our model by orientational ordering of polymer chains and polymer-solvent phase separation. We found that the overall crystalline fraction at the end of the crystallization process decreases with the increasing polymer volume fraction while the steady-state crystallization speed at later stages does not depend on the polymer volume fraction. The average crystallite size has a maximal value in the systems with a polymer volume fraction from 0.7 to 0.95. In our model, these polymer concentrations represent an optimal value in the sense of balance between the amount of polymer material available to increase the crystallite size and chain entanglements, that prevent crystallites' growth and merging. On large time scales, our model allows us to observe lamellar thickening linear in logarithmic time scale.