Pincer-Supported Carbonyl Complexes of Cobalt(I)

Synthesis and catalytic activity of well-defined Co(I) complexes based on NHC-phosphane pincer ligands

A new methodology for the preparation of Co(I)-NHC (NHC = N-heterocyclic carbene) complexes, namely, [Co(PCNHCP)(CO)2][Co(CO)4] (1) and [Co(PCNHCP)(CO)2]BF4 (2), has been developed (PCNHCP = 1,3-bis(2-(diphenylphosphanyl)ethyl)-imidazol-2-ylidene). Both complexes can be straightforwardly prepared by direct reaction of their parent imidazolium salts with the Co(0) complex Co2(CO)8. Complex 1 efficiently catalyses the reductive amination of furfural and levulinic acid employing silanes as reducing agents under mild conditions. Furfural has been converted into a variety of secondary and tertiary amines employing dimethyl carbonate as the solvent, while levulinic acid has been converted into pyrrolidines under solventless conditions. Dehydrocoupling of the silane to give polysilanes has been observed to occur as a side reaction of the hydrosilylation process.

Solvothermal synthesis of cobalt PCP pincer complexes from [Co2(CO)8]

Treatment of [Co2(CO)8] with the ipso-substituted P(C-X)PY ligands (X = Br, Cl; R = iPr, tBu) bearing Y = NH and CH2 linkers under solvothermal conditions affords the five-coordinate Co(I) and Co(III) complexes [CoI(PCPY-R)(CO)2] and [CoIII(PCPY-R)X2]. The later are paramagnetic exhibiting a solution magnetic moment in the range of 3.0-3.3 μB which is consistent with a d6 intermediate spin system corresponding to two unpaired electrons. In the case of P(C-X)PY ligands (X = Br, Cl; R = tBu; Y = NH) the formation of the square planar Co(II) complex [Co(PCPNH-tBu)X] was favored. This complex gives rise to a magnetic moment of 1.8 μB being consistent with a d7 low spin system corresponding to one unpaired electron. All complexes are characterized by means of spectroscopic techniques (NMR, IR), HR-MS. Representative complexes were also characterized by X-ray crystallography.

Graphical abstract

Supplementary Information

The online version contains supplementary material available at 10.1007/s00706-023-03123-x.

Photo-Initiated Cobalt-Catalyzed Radical Olefin Hydrogenation

Outer-sphere radical hydrogenation of olefins proceeds via stepwise hydrogen atom transfer (HAT) from transition metal hydride species to the substrate. Typical catalysts exhibit M-H bonds that are either too weak to efficiently activate H2 or too strong to reduce unactivated olefins. This contribution evaluates an alternative approach, that starts from a square-planar cobalt(II) hydride complex. Photoactivation results in Co-H bond homolysis. The three-coordinate cobalt(I) photoproduct binds H2 to give a dihydrogen complex, which is a strong hydrogen atom donor, enabling the stepwise hydrogenation of both styrenes and unactivated aliphatic olefins with H2 via HAT.

Synthesis and Catalytic Reactivity of Cobalt Pincer Nitrosyl Hydride Complexes

The synthesis, characterization, and catalytic activity of low-spin {CoNO}⁸ pincer complexes of the type [Co(PCP)(NO)(H)] are described. These compounds are obtained either by reacting [Co(PCP)(κ²-BH₄)] with NO and Et₃N or, alternatively, by reacting [Co(PCP)(NO)]⁺ with boranes, such as NH₃·BH₃ in solution. The five-coordinate, diamagnetic Co(III) complex [Co(PCP^NMe-iPr)(NO)(H)] was found to be the active species in the hydroboration of alkenes with anti-Markovnikov selectivity. A range of aromatic and aliphatic alkenes were efficiently converted with pinacolborane (HBpin) under mild conditions in good to excellent yield. Mechanistic insight into the catalytic reaction is provided by means of isotope labeling, NMR spectroscopy, and APCI/ESI-MS as well as DFT calculations.

Reactivity of a T-shaped cobalt(I) pincer-complex

The reactivity of a paramagnetic T-shaped cobalt(i) complex, [(iPrboxmi)Co], stabilised by a monoanionic bis(oxazolinylmethylidene)-isoindolate (boxmi) NNN pincer ligand is described. The exposure to carbon monoxide as an additional neutral ligand resulted in the square-planar species [(iPrboxmi)Co(CO)], accompanied by a change in the electronic spin state from S = 1 to S = 0. In contrast, upon treatment with trimethylphosphine the formation of the distorted tetrahedral complex [(iPrboxmi)Co(PMe3)] was observed (S = 1). Reacting [(iPrboxmi)Co] with iodine (I2), organic peroxides (tBu2O2, (SiMe3)2O2) and diphenyldisulphide (Ph2S2) yielded the tetracoordinated complexes [(iPrboxmi)CoI], [(iPrboxmi)Co(OtBu)], [(iPrboxmi)Co(OSiMe3)] and [(iPrboxmi)Co(SPh)], respectively, demonstrating the capability of the boxmi-supported cobalt(i) complex to homolytically cleave bonds and thus its distinct one-electron reactivity. Furthermore, a square-planar cobalt(ii) alkynyl complex [(iPrboxmi)Co(CCArF)] was identified as the main product in the reaction between [(iPrboxmi)Co] and a terminal alkyne, 4-fluoro-1-ethynylbenzene. Putting such species in the context of the previously investigated hydroboration catalysis, its stoichiometric reaction with pinacolborane revealed its potential conversion into a cobalt(ii) hydride complex, thus confirming its original attribution as off-cycle species.

Electrocatalytic Proton Reduction by a Cobalt(III) Hydride Complex with Phosphinopyridine PN Ligands

Cobalt complexes with 2-(diisopropylphosphinomethyl)pyridine (PN) ligands have been synthesized with the aim of demonstrating electrocatalytic proton reduction to dihydrogen with a well-defined hydride complex of an Earth-abundant metal. Reactions of simple cobalt precursors with 2-(diisopropylphosphino-methyl)pyridine (PN) yield [Co^II(PN)₂(MeCN)][BF₄]₂ 1, [Co^III(PN)₂(H)(MeCN)][PF₆]₂ 2, and [Co^III(PN)₂(H)(Cl)][PF₆] 3. Complexes 1 and 3 have been characterized crystallographically. Unusually for a bidentate PN ligand, all three exhibit geometries with mutually trans phosphorus and nitrogen ligands. Complex 1 exhibits a distorted square-pyramidal geometry with an axial MeCN ligand in a low-spin electronic state. In complexes 2 and 3, the PN ligands lie in a plane leaving the hydride trans to MeCN or chloride, respectively. The redox behavior of the three complexes has been studied by cyclic voltammetry at variable scan rates and by spectroelectrochemistry. A catalytic wave is observed in the presence of trifluoroacetic acid (TFA) at an applied potential close to the Co(II/I) couple of 1. Bulk electrolysis of 1, 2, or 3 at a potential of ca. -1.4 V vs E(Fc⁺/Fc) in the presence of TFA yields H₂ with Faradaic yields close to 100%. A catalytic mechanism is proposed in which the pyridine moiety of a PN ligand acts as a pendant proton donor following opening of the chelate ring. Additional mechanisms may also operate, especially in the presence of high acid concentration where speciation changes.

Reaction Pathways and Redox States in α-Selective Cobalt-Catalyzed Hydroborations of Alkynes

Cobalt(II) alkyl complexes supported by a monoanionic NNN pincer ligand are pre‐catalysts for the regioselective hydroboration of terminal alkynes, yielding the Markovnikov products with α:β‐(E) ratios of up to 97:3. A cobalt(II) hydride and a cobalt(II) vinyl complex appear to determine the main reaction pathway. In a background reaction the highly reactive hydrido species specifically converts to a coordinatively unsaturated cobalt(I) complex which was found to re‐enter the main catalytic cycle.

Concerted aryl-sulfur reductive elimination from PNP pincer-supported Co(iii) and subsequent Co(i)/Co(iii) comproportionation

This report discloses a combined experimental and computational study aimed at understanding C-S reductive elimination from Co(iii) supported by a diarylamido/bis(phosphine) PNP pincer ligand. Divalent (PNP)Co-aryl complexes could be easily oxidized to five-coordinate Co(iii) derivatives, and anion metathesis provided five-coordinate (PNP)Co(Ar)(SAr') complexes of Co(iii). In contrast to their previously described (POCOP)Co(Ar)(SAr') analogs, but similarly to the (PNP)Rh(Ar)(SAr') and (POCOP)Rh(Ar)(SAr') analogs, (PNP)Co(Ar)(SAr') undergo C-S reductive elimination with the formation of the desired diarylsulfide product ArSAr'. DFT studies and experimental observations are consistent with a concerted process. However, in contrast to the Rh analogs, the immediate product of such reductive elimination, the unobserved Co(i) complex (PNP)Co, un-dergoes rapid comproportionation with the (PNP)Co(Ar)(SAr') starting material to give Co(ii) compounds (PNP)Co-Ar and (PNP)Co-SAr'.

The role of neutral Rh(PONOP)H, free NMe2H, boronium and ammonium salts in the dehydrocoupling of dimethylamine-borane using the cationic pincer [Rh(PONOP)(η2-H2)]+ catalyst

The σ-amine-borane pincer complex [Rh(PONOP)(η1-H3B·NMe3)][BArF4] [2, PONOP = κ3-NC5H3-2,6-(OPtBu2)2] is prepared by addition of H3B·NMe3 to the dihydrogen precursor [Rh(PONOP)(η2-H2)][BArF4], 1. In a similar way the related H3B·NMe2H complex [Rh(PONOP)(η1-H3B·NMe2H)][BArF4], 3, can be made in situ, but this undergoes dehydrocoupling to reform 1 and give the aminoborane dimer [H2BNMe2]2. NMR studies on this system reveal an intermediate neutral hydride forms, Rh(PONOP)H, 4, that has been prepared independently. 1 is a competent catalyst (2 mol%, ∼30 min) for the dehydrocoupling of H3B·Me2H. Kinetic, mechanistic and computational studies point to the role of NMe2H in both forming the neutral hydride, via deprotonation of a σ-amine-borane complex and formation of aminoborane, and closing the catalytic cycle by reprotonation of the hydride by the thus-formed dimethyl ammonium [NMe2H2]+. Competitive processes involving the generation of boronium [H2B(NMe2H)2]+ are also discussed, but shown to be higher in energy. Off-cycle adducts between [NMe2H2]+ or [H2B(NMe2H)2]+ and amine-boranes are also discussed that act to modify the kinetics of dehydrocoupling.

H2 addition to (Me4PCP)Ir(CO): studies of the isomerization mechanism

Reduced steric demand of the Me4PCP pincer ligand (PCP = κ3-C6H4-1,3-[CH2PR2]2, R = Me), allows for a more open metal center. This is evident through structure and reactivity comparisons between (Me4PCP)Ir derivatives and other (R4PCP)Ir complexes (R = tBu, iPr, CF3). In particular, isomerization from cis-(R4PCP)Ir(H)2(CO) to trans-(R4PCP)Ir(H)2(CO) is more facile when R = Me than when R = iPr. Deuterium incorporation in the hydride ligands from solvent C6D6 was observed during this isomerization when R = Me. This deuterium exchange has not been observed for other analogous R4PCP iridium complexes. A kinetic study of the cis/trans isomerization combined with computational studies suggests that the cis/trans isomerization proceeds through a migratory-insertion pathway involving a formyl intermediate.

Preparation and reactivity of a square-planar PNP cobalt(ii)–hydrido complex: isolation of the first {Co–NO}8–hydride

The synthesis of a square-planar cobalt(ii) hydrido complex supported by a pyrrole-based PNP ligand has been reinvestigated and its reactivity with various small molecules examined.