Aliphatic Chain Modification of Collagen Type I: Development of Elastomeric, Compliant, and Suturable Scaffolds

Development of Enzymatic-Resistant and Compliant Decellularized Extracellular Matrixes via Aliphatic Chain Modification for Bladder Tissue Engineering

Here, we report the design and development of highly stretchable, compliant, and enzymatic-resistant transiently cross-linked decellularized extracellular matrixes (dECMs) (e.g., porcine small intestine submucosa/dSIS, urinary bladder matrix/dUBM, bovine pericardium/dBP, bovine dermis/dBD, and human dermis/dHD). Specifically, these dECMs were modified with long aliphatic chains (C9, C14, and C18). Upon modification, dECMs became significantly resistant to enzymatic degradation for extended periods, showed increased water contact angle (>20%-90%), and stretched >200% than their control counterparts. Modified dECMs are compliant, undergoing 100% elongation at only 0.3-0.5 MPa of applied tensile stress (∼10%-25% of their control counterparts), similar to the control bladder tissue. Furthermore, modified dECMs remain structurally stable at the physiological temperature with increased storage and loss modulus values but decreased tan δ values compared to their control counterparts. Although modification reduces cell adhesion, the gene expressions in polarized macrophages remain unchanged (e.g., TGFβ, CD163, and CD86), except for the modified bovine pericardium (dBP) where a significant decrease in TNFα gene expression is observed. When implanted in the rat subcutaneous model, modified dECMs degraded relatively slowly and did not cause significant fibrotic tissue formation. The numbers of pro-regenerative macrophages increased to several folds in a later time point of evaluation. Modified dECM also supported the bladder wall regeneration with formations of the urothelium, lamina propria, blood vessels, and muscle bundles and reduced the occurrence of calculi formation by 50% in a rat bladder augmentation model. We anticipate that the enhanced stretchability, compliance, and physiological stability of dECMs indicate their suitability for urologic tissue regeneration.

Efficient and ecological leather processing: replacement of lime and sulphide with dispase assisted by 1-allyl-3-methylimidazolium chloride

Leather is a collagen-based biomass prepared from raw skins or hides by a series of unit operations, in which the unhairing and fiber opening are extremely important operations. However, the conventional Na2S/Ca(OH)2 system used in unhairing and fiber opening has given rise to the pollution to the environment. It is necessary to develop substitute technology for the Na2S/Ca(OH)2. In the present study, 1-allyl-3-methylimidazolium chloride ([AMIm]Cl) was used to cooperate with dispase for cycle unhairing and one-pot beamhouse to recycle waste bovine hides and compared with conventional processing. During those processes, the mechanism of [AMIm]Cl-dispase synergistic unhairing and collagen fibers opening were studied. Besides, plant hazard, organic matter and [AMIm]Cl of wastewater from [AMIm]Cl-dispase process were respectively investigated and separated to evaluate the environmental and economic benefits of the [AMIm]Cl-dispase process. As a result, enzyme activity after unhairing by [AMIm]Cl-diapase system for using 5 times is higher than that by KCl-dispase system, and needs lower unhairing time, which is because of rapid penetration of [AMIm]Cl-dispase solution in bovine hides. For this reason, the tensile strength and elastic modulus of tanned leather from [AMIm]Cl-dispase process are higher than those from the KCl-diapase and conventional processes, and its hydrothermal shrinkage temperature is comparable to that of the conventional one. Because of the 58.13% lower wastewater discharge (WD), 66.60% lower total solids (TS), 97.23% lower ammonia nitrogen (NH3-N), non-toxic wastewater and organic matter recovery in wastewater are reached from [AMIm]Cl-dispase process, which is expected to be an alternative to the conventional process to reduce environmental pollution and realize the sustainable development of technology for leather manufacturing.

Graphical abstract

Adhesive and biodegradable membranes made of sustainable catechol-functionalized marine collagen and chitosan

We describe bioadhesive membranes developed from marine renewable biomaterials, namely chitosan and collagen extracted from fish skins. Collagen was functionalized with catechol groups (Coll-Cat) to provide the membranes with superior adhesive properties in a wet environment and blended with chitosan to improve the mechanical properties. The blended membranes were compared to chitosan and chitosan blended with unmodified collagen in terms of surface morphology, wettability, weight loss, water uptake, mechanical and adhesive properties. The metabolic activity, the viability and the morphology of L929 fibroblastic cells seeded on these membranes were also assessed. Our results show that the functionalization with catechol groups improves the adhesive and mechanical properties of the membranes and enhances cell attachment and proliferation. These data suggest that the developed marine origin-raw membranes present a potential towards the restoration of the structural and functional properties of damaged soft tissues.