White-Light-Emitting AIE/Eu3+-Doped Ion Gel with Multistimuli-Responsive Properties

Light-Emitting Coordination Polymers: Stimuli-Responsive Gels, PMMA-Based Composite Films, and UV-Shielding

Lanthanide-based light-emitting coordination polymers (CPs) and CP gels (CPGs) have significance for applications in optical systems, image processing/multiplexing, and optical sensors. In this study, we report two new luminescent CPs (EuL-CP (1) and TbL-CP (2)) and CPGs (EuL-gel (5) and TbL-gel (6)) using lanthanide(III) ions (Ln(III) = Eu(III) and Tb(III)) and 4-(4-carboxyphenyl)-2,2:6,2-terpyridine ligand (L) capable of forming stable thermoreversible gels. Probable structures of EuL-CP (1) and TbL-CP (2) and the formations of EuL-gel (5) and TbL-gel (6) are proposed based on adequate computational studies. The CPGs are stimuli-responsive and could be utilized as invisible security inks for encryption. Further, poly(methyl methacrylate) (PMMA) polymer doped with respective CPs (0.75 wt %) is found to be suitable for forming composite films with UV-shielding properties.

A novel luminol-coordinated silver(I) organic gel with self-enhanced chemiluminescence applied for uric acid detection

A novel silver(I)-based metal-organic gel (AgMOG) consisting of luminol as the ligand was synthesized by a facile strategy, which was found to exhibit self-enhancing chemiluminescence (CL) property. Based on this, a new AgMOG-K₂S₂O₈ CL system without additional catalyst was established. According to the results of CL spectra, electron spin resonance (ESR) spectra as well as the influence of radical scavengers to AgMOG-K₂S₂O₈ system, the possible CL mechanism of this system was discussed. In this CL system, AgMOG exhibited the dual properties of catalysis and luminescence. On the one hand, AgMOG can catalyze K₂S₂O₈ to produce SO₄^•-. The generated SO₄^•- can be converted to hydroxyl radical (OH^•) under alkaline condition, and further converted to other radical oxygen species (ROS, such as ¹O₂ and O₂^•-). Furthermore, the reaction between the K₂S₂O₈ and H₂O can form H₂O₂, which also can be catalyzed by AgMOG to produce ROS. On the other hand, the AgMOG can be oxidized by ROS to emit strong CL signal. Then, based on the quenching effect of uric acid (UA) to this CL system, a method for UA detection was established with a good linearity over the range from 0.08 to 10 µmol·L^-1. In this work, a new CL luminant with catalytic property was synthesized by a simple method, and a self-enhancing AgMOG-K₂S₂O₈ CL system was developed for the first time, providing a novel direction for the application of MOG in the CL field.

Gelatinous lanthanide coordination polymer with aggregation-enhanced antenna effect for ratiometric detection of endogenous alkaline phosphatase

Aggregation-induced emission (AIE) and antenna effect (AE) are two significant behaviors that have attracted increasing attention. However, it is challenging to achieve the synergistic effect of AIE and AE in luminescent materials for more extensive applications. Here, four gelatinous Ln³⁺ coordination polymers (Ln-CPs) are synthesized by self-assembly of ciprofloxacin (CIP), adenosine monophosphate (AMP), and Ln³⁺ ions in aqueous medium. Encouragingly, a remarkable increase in the characteristic fluorescence of Ln³⁺ and a significant decrease in CIP are observed along with increasing concentration of Ln-CPs, which is attributed to the large aggregates formed by self-assembly that strictly constrain the intramolecular motions of antenna ligands, thereby achieving the aggregation-enhanced AE. More meaningfully, Eu-CP not only shows a rice-like morphology at high aggregation state, but also provides an opportunity for the selective detection of alkaline phosphatase (ALP). A new flower-like polymer is formed upon incubating Eu-CP with ALP, accompanied by the fluorescence quenching of Eu³⁺ and recovery of CIP, a ratiometric determination of ALP in the range of 0.1-6.0 U·L^-1 is thus achieved. Additionally, ALP assay in human serum and bioimaging in living cells have been successfully performed. This research opens a new horizon for the fabrication of Ln³⁺-based luminescent materials with promising applications.

Water-Soluble Cationic Eu3+-Metallopolymer with High Quantum Yield and Sensitivity for Intracellular Temperature Sensing

Lanthanide-based (Ln³⁺) luminescent materials are ideal candidates for use in fluorescence intracellular temperature sensing. However, it remains a great challenge to obtain a Ln³⁺-ratiometric fluorescence thermometer with high sensitivity and quantum yield in an aqueous environment. Herein, a cationic Eu³⁺-metallopolymer was synthesized via the coordination of Eu(TTA)₃·2H₂O with an AIE active amphipathic polymer backbone that contains APTMA ((3-acrylamidopropyl) trimethylammonium) and NIPAM (N-isopropylacrylamide) units, which can self-assemble into nanoparticles in water solution with APTMA and NIPAM as the hydrophilic shell. This polymer exhibited highly efficient dual-emissive white-light emission (Φ = 34.3%). Particularly, when the temperature rises, the NIPAM units will transform from hydrophilic to hydrophobic in the spherical core of the nanoparticle, while the VTPE units are moved from inside the nanoparticle to the shell, activating its nonradiative transition channel and thereby decreasing its energy transfer to Eu³⁺ centers, endowing the Eu³⁺-metallopolymer with an extremely high temperature sensing sensitivity within the physiological temperature range. Finally, the real-time monitoring of the intracellular temperature variation is further conducted.

Interfacial Self-Assembly of Organized Ultrathin Films of Tripodal Metal-Terpyridyl Coordination Polymers as Luminophores and Heterogeneous Catalysts for Photocatalytic CO2 Reduction

Metal-directed interfacial self-assembly of well-defined coordination polymer (CP) ultrathin films can control the metal complex arrangement and distribution at the molecular level, providing a convenient route for the design and fabrication of novel opto-electrical devices and heterogeneous catalysts. Here, we report the assembly of two series of CP multilayers with the transition-metal ions of Fe²⁺, Co²⁺, Zn²⁺ and Tb³⁺ as connectors and tripodal terpyridyl ligands of 4,4',4″-(1,3,5-triazine-2,4,6-triyl)tris(1-(4-([2,2':6',2″-terpyridin]-4'-yl)benzyl)pyridin-1-ium) (TerPyTa) and 4,4',4″-(benzene-1,3,5-triyl)tris(1-(4-([2,2':6',2″-terpyridin]-4'-yl)benzyl)pyridin-1-ium) (TerPyBen) as linkers at the air-water interface. The as-prepared Langmuir-Blodgett (LB) films display strong luminescence, with the emission wavelength and relative intensity dependent on both the metal ions and linkers; among them, the Zn-TerPyTa and Zn-TerPyBen CPs give off the strongest luminescent emission centered at about 370 nm with an emission lifetime of approximately 0.2-0.3 ns. The Tb-TerPyTa CPs can give off emission at approximately 490, 546, 586, and 622 nm, attributed to the ⁵D₄ to ⁷F_3-6 electron transitions of typical Tb³⁺ ions. Finally, these CP LB films can act as efficient heterogeneous photocatalysts for the CO₂ reduction to selectively produce CO. The catalytic efficiency can be optimized by adjusting the experimental conditions (light sensitizer, electron donor, and water content) and CP composition (metal ion and ligand) with an excellent yield of up to 248.1 mmol g^-1. In particular, it is revealed that, under the same conditions, the catalytic efficiency of the Fe-TerPyTa CP LB film is nearly 2 to 3 orders of magnitude higher than that of the other metalated complexes investigated in the homogeneous system. UV-vis spectroscopy and cyclic voltammetry studies demonstrated that the dual active sites of Fe-terpyridine and TerPyTa units contribute to the enhanced catalytic activity. This work provides an effective method to introduce the earth-abundant metal complexes into CP films to construct efficient noble-metal-free photocatalysts for the CO₂ reduction.

Highly Tough, Stretchable, and Recyclable Ionogels with Crosslink-Enhanced Emission Characteristics for Anti-Counterfeiting and Motion Detection

Traditional luminescent ionogels often suffer from poor mechanical properties and a lack of recyclability and regeneration, which limits their further application and sustainable development. Herein, a luminescent ionogel with strong mechanical properties and good recyclability has been designed and fabricated by introducing dynamic coordination bonds via in situ one-step crosslinking of acrylic acid in ionic liquid of 1-ethyl-3-methylimidazolium diethylphosphate by zinc dimethacrylate. Due to the special crosslinking of dynamic coordination bonds along with the hydrogen bond interaction, the as-prepared ionogel displays excellent stretchability and toughness, good self-adhesiveness, fast self-healability, and recyclability. Interestingly, the obtained ionogels exhibit tunable photoluminescence caused by the crosslink-enhanced emission (CEE) effect from the coordination bonds. Importantly, ionogels can be applied in information storage, information encryption, anti-counterfeiting due to their simple and in situ preparation method, and their special fluorescence performances. Moreover, an ionogel-based wearable sensor has rapid response time and a high gauge factor of 3.22 within a wide strain range from 1 to 700%, which can monitor various human movements accurately from subtle to large-scale motions. This paper offers a promising way to fabricate sustainable functional ionic liquid-based composites with CEE characteristics via an in situ one-step polymerization method.

Dual Lewis Acid- and Base-Responsive Terpyridine-Based Hydrogel: Programmable and Spatiotemporal Regulation of Fluorescence for Chemical-Based Information Security

A huge amount of data inundated in our daily life; there is an ever-increasing need to develop a new strategy of information encryption-decryption-erasing. Herein, a polymeric DCTpy/PAM hydrogel has been fabricated to store information via controllable Eu³⁺/Zn²⁺ ionoprinting for hierarchical and multidimensional information decryption. Eu³⁺ and Zn²⁺ have a competition and dynamic interaction toward DCTpy under NH₃ stimuli in the polymeric DCTpy/PAM hydrogel network. The Eu(III)/Zn(II)@DCTpy/PAM hydrogel exhibits light red fluorescence of Eu³⁺ due to the antenna effect. Upon the addition of NH₃, dissociation of the Eu³⁺-DCTpy complex takes place, and the Zn(II)/DCTpy/NH₃ complex is formed with both ICT (intramolecular charge-transfer) and PET (photo-induced electron-transfer) process characteristics that exhibits yellow emission color. Subsequently, HCl can quench the fluorescence of the resulting hydrogel. By integrating transparency, adhesiveness, and programmable stimuli responsiveness of the hydrogel blocks in to one system, complex, multistage, and time-controlled information storage-encryption-decryption-erasing in sequence with multidimensions is illustrated via the molecule diffusion method. This work provides a novel and representative strategy in fabricating information encryption-decryption-erasing materials with high capacity and complexity by a simple terpyridine-based hydrogel.

A review of recent advances in metal ion hydrogels: mechanism, properties and their biological applications

The mechanisms, common properties and biological applications of different types of metal ion hydrogels are summarized.

Functional Copolymers Married with Lanthanide(III) Ions: A Win-Win Pathway to Fabricate Rare Earth Fluorescent Materials with Multiple Applications

Lanthanide(III)-based luminescent materials have attracted great research interests due to their unique optical, electronic, and chemical characteristics. Up to now, how to extend these materials into large, broad application fields is still a great challenging task. In this contribution, we are intended to present a simple but facile strategy to enhance the luminescence from lanthanide ions and impart lanthanide(III)-based luminescent materials with more applicable properties, leading to meet the requirements from different purposes, such as being used as highly emissive powders, hydrogels, films, and sensitive probes under external stimuli. Herein, a water soluble, blue color emissive, temperature sensitive, and film-processable copolymer (Poly-ligand) was designed and synthesized. Upon complexing with Eu³⁺ and Tb³⁺ ions, the red color-emitting Poly-ligand-Eu and green color-emitting Poly-ligand-Tb were produced. After finely tuning the ratios between them, a standard white color emitting Poly-ligand-Eu₁:Tb₄ (CIE = 0.33 and 0.33) was obtained. Furthermore, the resulted materials not only possessed the emissive luminescent property but also inherited functions from the copolymer of Poly-ligand. Thus, these lanthanide(III)-based materials were used for fingerprint imaging, luminescent soft matters formation, colorful organic light-emitting diode device fabrication, and acid/alkali vapors detection.

White-light emission from the quadruple-stranded dinuclear Eu(iii) helicate decorated with pendent tetraphenylethylene (TPE)

The hybrid film doped with a quadruple-stranded Eu³⁺ helicate displayed tuneable emission and white light.