Layer-by-Layer Solution-Processed Organic Solar Cells with Perylene Diimides as Acceptors

Improving the Stability of Non-fullerene-Based Organic Photovoltaics through Sequential Deposition and Utilization of a Quasi-orthogonal Solvent

The development of organic photovoltaic (OPV) devices based on non-fullerene acceptors (NFAs) has led to a rapid improvement in their efficiency. Despite these improvements, significant performance degradation in the early stages of operation, known as burn-in, remains a challenge for NFA-based OPVs. To address this challenge, this study demonstrates a stable NFA-based OPV fabricated using sequential deposition (SqD) and a quasi-orthogonal solvent. The quasi-orthogonal solvent, which is prepared by incorporating 1-chloronaphthalene (1-CN) into dichloromethane (DCM), reduces the vapor pressure of the solvent and allows for the efficient dissolution and penetration of the Y6 (one of efficient NFAs) into a PM6 polymer-donor layer without damaging the latter. The resulting bulk heterojunction (BHJ) is characterized by a higher degree of crystallinity in the PM6 domains than that prepared using a conventional single-step deposition (SD) process. The OPV fabricated using the SqD process exhibits a PCE of 14.1% and demonstrates superior thermal stability to the SD-processed OPV. This study conclusively reveals that the formation of a thermally stable interface between the photoactive layer and the electron-transport layer (ETL) is the primary factor contributing to the high thermal stability observed in the SqD-processed OPV.

Chemical doping of unsubstituted perylene diimide to create radical anions with enhanced stability and tunable photothermal conversion efficiency

N-doping of perylene diimides (PDIs) to create stable radical anions is significant for harvesting photothermal energy due to their intensive absorption in the near-infrared (NIR) region and non-fluorescence. In this work, a facile and straightforward method has been developed to control the doping of perylene diimide to create radical anions using organic polymer polyethyleneimine (PEI) as a dopant. It was demonstrated that PEI is an effective polymer-reducing agent for the n-doping of PDI toward the controllable generation of radical anions. In addition to the doping process, PEI could suppress the self-assembly aggregation and improve the stability of PDI radical anions. Tunable NIR photothermal conversion efficiency (maximum 47.9%) was also obtained from the radical-anion-rich PDI-PEI composites. This research provides a new strategy to tune the doping level of unsubstituted semiconductor molecules for varying yields of radical anions, suppressing aggregation, improving stability, and obtaining the highest radical anion-based performance.

Recent Advances in Nonfullerene Acceptor-Based Layer-by-Layer Organic Solar Cells Using a Solution Process

Recently, sequential layer-by-layer (LbL) organic solar cells (OSCs) have attracted significant attention owing to their favorable p-i-n vertical phase separation, efficient charge transport/extraction, and potential for lab-to-fab large-scale production, achieving high power conversion efficiencies (PCEs) of over 18%. This review first summarizes recent studies on various approaches to obtain ideal vertical D/A phase separation in nonfullerene acceptor (NFAs)-based LbL OSCs by proper solvent selection, processing additives, protecting solvent treatment, ternary blends, etc. Additionally, the longer exciton diffusion length of NFAs compared with fullerene derivatives, which provides a new scope for further improvement in the performance of LbL OSCs, is been discussed. Large-area device/module production by LbL techniques and device stability issues, including thermal and mechanical stability, are also reviewed. Finally, the current challenges and prospects for further progress toward their eventual commercialization are discussed.