Superior Interfacial Contact Yields Efficient Electron Transfer Rate and Enhanced Solar Photocatalytic Hydrogen Generation in M/C3N4 Schottky Junctions

Pd(II) coordination molecule modified g-C3N4 for boosting photocatalytic hydrogen production

The photocatalytic H2 production activity of polymer carbon nitride (g-C3N4) is limited by the rapid recombination of photoelectron-hole pairs and slow surface reduction dynamic process. Here, a supramolecular complex (named R-TAP-Pd(II)) was fabricated via self-assembly of (R)-N-(1-phenylethyl)-4-(4-(pyridin-2-yl)-1H-1,2,3-triazol-1-yl)benzamide (R-TAP) with Pd(II) and used to modify g-C3N4. In the R-TAP-Pd(II)@g-C3N4 composite photocatalyst, the spin polarization of R-TAP-Pd(II) can promote charge transfer and inhibit photogenerated carrier recombination, as confirmed by spectral tests and photoelectrochemical performance tests. Electrochemical tests and in situ X-ray photoelectron spectroscopy (XPS) tests proved that the Pd(II) ion in the R-TAP-Pd(II) molecule can serve as active sites to accelerate H2 production. The R-TAP-Pd(II)@g-C3N4 presented a photocatalytic H2 generation rate of 1085 μmol g-1 h-1 when exposed to visible light, which was a about 278-fold increase compared with g-C3N4. This work finds a new approach to boost the photocatalytic efficiency of g-C3N4 via supramolecular self-assembly.

Interfacial Engineering over Pt-Calcium Ferrite/2D Carbon Nitride Nanosheet p-n Heterojunctions for Superior Photocatalytic Properties

The present study discloses the fabrication of efficient p-n heterojunctions using n-type polymeric bulk carbon nitride (b-CN, E g = 2.7 eV) or exfoliated nanosheets of carbon nitride (NSCN, E g = 2.9 eV) with p-type spinel ferrite CaFe2O4 (CFO, E g = 1.9 eV) for photocatalytic hydrogen generation. A series of p-n combinations were fabricated and characterized by various techniques. The oxide-carbon nitride interactions, light absorption, band alignment at the interface, and water/H3O+ adsorption capability were elucidated over heterojunctions and correlated with the photocatalytic hydrogen yield. The main developments in the present study are as follows: (1) All heterojunctions were more active than pure phases. (2) The photocatalytic activity trend validated an increase in the lifetime of charge carriers from TRPL. Pt(1 wt %)-CFO(1 wt %)/NSCN (481.5 μmol/h/g under ultraviolet (UV)-visible-simulated light, 147.5 μmol/h/g under CFL illumination for 20 h, τavg = 10.33 ns) > Pt-NSCN > Pt-CFO/b-CN > CFO/NSCN > CFO/b-CN > NSCN > Pt/b-CN > mechanical mixture (MM) of 1 wt %CFO + NSCN-MM > 1 wt %CFO + b-CN-MM > CFO > b-CN (τavg = 4.5 ns). (3) Pt-CFO/NSCN was most active and exhibited 250 times enhanced photocatalytic activity as compared to parent bulk carbon nitride, 6.5 times more active than CFO/NSCN, and twice more active than Pt-NSCN. Thus, enhanced activity is attributed to the smooth channelizing of electrons across p-n junctions. (4) NSCN evidently offered improved characteristics as a support and photocatalyst over b-CN. The exfoliated NSCN occupied a superior few-layer morphology with 0.35 nm width as compared to parent b-CN. NSCN allowed 57% dispersion of 6 nm-sized CFO, while b-CN supported 14% dispersion of 7.8 nm-sized CFO particles, as revealed by small-angle X-ray scattering spectroscopy (SAXS). Sizes of 2-4 nm were observed for Pt nanoparticles in the 1 wt %Pt/1 wt % CFO/NSCN sample. A binding energy shift and an increase in the FWHM of X-ray photoelectron spectroscopy (XPS) core level peaks established charge transfer and enhanced band bending on p-n contact in Pt-CFO/NSCN. FsTAS revealed the decay of photogenerated electrons via trapping in shallow traps (τ1, τ2) and deep traps (τ3). Lifetimes τ1 (3.19 ps, 42%) and τ2 (187 ps, 31%) were higher in NSCN than those in b-CN (τ1 = 2.2 ps, 42%, τ2 = 30 ps, 31%), which verified that the recombination reaction rate was suppressed by 6 times in NSCN (k 2 = 0.53 × 1010 s-1) as compared to b-CN (k 2 = 3.33 × 1010 s-1). Deep traps lie below the H+/H2 reduction potential; thus, electrons in deep traps are not available for photocatalytic H2 generation. (5) The role of CFO in enhancing water adsorption capability was modeled by molecular dynamics. NSCN or b-CN both showed very poor interaction with water molecules; however, the CFO cluster adsorbed H3O+ ions very strongly through the electrostatic interaction between calcium and oxygen (of H3O+). Pt also showed a strong affinity for H2O but not for H3O+. Thus, both CFO and Pt facilitated NSCN to access water molecules, and CFO further sustained the adsorption of H3O+ molecules, crucial for the photocatalytic reduction of water molecules. (6) Band potentials of CFO and NSCN aligned suitably at the interface of CFO/NSCN, resulting in a type-II band structure. Valence band offset (VBO, ΔE VB) and conduction band offset (CBO, ΔE CB) were calculated at the interface, resulting in an effective band gap of 1.41 eV (2.9 - ΔE VB = 1.9 - ΔE CB), much lower than parent compounds. The interfacial band structure was efficient in driving photogenerated electrons from the CB of CFO to the CB of NSCN and holes from the VB of NSCN to the VB of CFO, thus successfully separating charge carriers, as supported by the increased lifetime of charge carriers and favorable photocatalytic H2 yield.

Recent progresses in synthesis and modification of g-C3N4 for improving visible-light-driven photocatalytic degradation of antibiotics

Graphitic carbon nitride (g-C3N4) is a widely studied visible-light-active photocatalyst for low cost, non-toxicity, and facile synthesis. Nonetheless, its photocatalytic efficiency is below par, due to fast recombination of charge carriers, low surface area, and insufficient visible light absorption. Thus, the research on the modification of g-C3N4 targeting at enhanced photocatalytic performance has attracted extensive interest. A considerable amount of review articles have been published on the modification of g-C3N4 for applications. However, limited effort has been specially contributed to providing an overview and comparison on available modification strategies for improved photocatalytic activity of g-C3N4-based catalysts in antibiotics removal. There has been no attempt on the comparison of photocatalytic performances in antibiotics removal between modified g-C3N4 and other known catalysts. To address these, our study reviewed strategies that have been reported to modify g-C3N4, including metal/non-metal doping, defect tuning, structural engineering, heterostructure formation, etc. as well as compared their performances for antibiotics removal. The heterostructure formation was the most widely studied and promising route to modify g-C3N4 with superior activity. As compared to other known photocatalysts, the heterojunction g-C3N4 showed competitive performances in degradation of selected antibiotics. Related mechanisms were discussed, and finally, we revealed current challenges in practical application.

Modulating band structure through introducing Cu0/CuxO composites for the improved visible light driven ammonia synthesis

The photocatalytic performance of ceria-based materials can be tuned by adjusting the surface structures with decorating the transition-metal, which are considered as the important active sites. Herein, cuprous oxide-metallic copper composite-doped ceria nanorods were assembled through a simple hydrothermal reduction method. The photocatalytic ammonia synthesis rates exhibit an inverted "V-shaped" trend with increasing Cu0/CuxO mole ratio. The best ammonia production rate, approximately 900 or 521 µmol·gcal-1·h-1 under full-spectra or visible light, can be achieved when the Cu0/CuxO ratio is approximately 0.16, and this value is 8 times greater than that of the original sample. The absorption edge of the as-prepared samples shifted towards visible wavelengths, and they also had appropriate ammonia synthesis levels. This research provides a strategy for designing noble metal-free photocatalysts through introducing the metal/metallic oxide compositesto the catalysts.

Progress on enhancing the charge separation efficiency of carbon nitride for robust photocatalytic H2 production

Solar-driven H2 production from water splitting with efficient photocatalysts is a sustainable strategy to meet the clean energy demand and alleviate the approaching environmental issues caused by fossil fuel consumption. Among various semiconductor-based photocatalysts, graphitic carbon nitride (g-C3N4) has attracted much attention due to its advantages of long term-stability, visible light response, low cost, and easy preparation. However, the intrinsic Coulombic attraction between charge carriers and the interlayer electrostatic barrier of bulk g-C3N4 result in severe charge recombination and low charge separation efficiency. This perspective summarizes the recent progress in the development of g-C3N4 photocatalytic systems, and focuses on three main modification strategies for promoting charge transfer and minimizing charge recombination, including structural modulation, heterojunction construction, and cocatalyst loading. Based on this progress, we provide conclusions regarding the current challenges of further improving photocatalytic efficiency to fulfill commercial requirements, and propose some recommendations for the design of novel and satisfactory g-C3N4 photocatalysts, which is expected to progress the solar-to-hydrogen conversion.