Hydrogen Adsorption at the Au/TiO2 Interface: Quantitative Determination and Spectroscopic Signature of the Reactive Interface Hydroxyl Groups at the Active Site

Does H2 Temperature-Programmed Reduction Always Probe Solid-State Redox Chemistry? The Case of Pt/CeO2

Redox reactions on the surface of transition metal oxides are of broad interest in thermo, photo, and electrocatalysis. H2 temperature-programmed reduction (H2-TPR) is commonly used to probe oxide reducibility by measuring the rate of H2 consumption during temperature ramps, assuming that this rate is controlled by oxide reduction. However, oxide reduction involves several elementary steps, such as H2 dissociation and H-spillover, before surface reduction and H2O formation occur. In this study, we evaluated the kinetics of H2 consumption over CeO2 and Pt/CeO2 with varying Pt loadings and structures to identify the elementary steps probed by H2-TPR. Literature often attributes changes in H2-TPR characteristics with Pt addition to increased CeO2 reducibility. However, our analysis revealed that the H2 consumption rate is measurement of the rate of H-spillover at Pt-CeO2 interfaces and is determined by the concentration of Pt species on Pt nanoclusters that dissociate H2. Therefore, lower temperature H2 consumption observed with Pt addition does not indicate higher CeO2 reducibility. Measurements on samples with mixtures of Pt single-atoms and nanoclusters demonstrated that H2-TPR can effectively quantify dilute Pt nanocluster concentrations, suggesting caution in directly linking H2-TPR characteristics to oxide reducibility while highlighting alternative material insights that can be gleaned.

Upside-Down Adsorption: The Counterintuitive Influences of Surface Entropy and Surface Hydroxyl Density on Hydrogen Spillover

Although hydrogen spillover is often invoked to explain anomalies in catalysis, spillover remains a poorly understood phenomenon. Hydrogen spillover (H*) is best described as highly mobile H atom equivalents that arise when H2 migrates from a metal nanoparticle to an oxide or carbon support. In the 60 years since its discovery, few methods have become available to quantify or characterize H*-support interactions. We recently showed in situ infrared spectroscopy and volumetric chemisorption can quantify reversible H2 adsorption on Au/TiO2 catalysts, where adsorbed hydrogen exists as H* and interacts with titania surface hydroxyl (TiOH) groups. Here, we report parallel thermogravimetric analysis and Fourier transform infrared spectroscopy methods for systematically manipulating the surface TiOH density. We examine the role of surface hydroxylation on spillover thermodynamics using van't Hoff studies to determine apparent adsorption enthalpies and entropies at constant H* coverage, which is necessary to maintain constant H* translational entropy. Although surface TiOH groups are the likely adsorption sites, the data show removing hydroxyl groups increases spillover. This surprising finding─that adsorption increases as the adsorption site density decreases─is associated with improved thermodynamics on dehydroxylated surfaces. A strong adsorption enthalpy-entropy correlation implicates the changing surface entropy of the titania support itself (i.e., an initial state effect) is deeply intertwined with the H* configurational entropy. These effects are surprising and should apply to all low-coverage adsorbates where entropy terms dominate more traditional enthalpic considerations. Moreover, this study points toward a kinetic test for invoking spillover in a reaction mechanism: namely, in situ dehydroxylation should enhance spillover processes.

Sustainable photocatalytic hydrogen peroxide production over octonary high-entropy oxide

The direct utilization of solar energy for the artificial photosynthesis of hydrogen peroxide (H2O2) provides a reliable approach for producing this high-value green oxidant. Here we report on the utility of high-entropy oxide (HEO) semiconductor as an all-in-one photocatalyst for visible light-driven H2O2 production directly from H2O and atmospheric O2 without the need of any additional cocatalysts or sacrificial agents. This high-entropy photocatalyst contains eight earth-abundant metal elements (Ti/V/Cr/Nb/Mo/W/Al/Cu) homogeneously arranged within a single rutile phase, and the intrinsic chemical complexity along with the presence of a high density of oxygen vacancies endow high-entropy photocatalyst with distinct broadband light harvesting capability. An efficient H2O2 production rate with an apparent quantum yield of 38.8% at 550 nm can be achieved. The high-entropy photocatalyst can be readily assembled into floating artificial leaves for sustained on-site production of H2O2 from open water resources under natural sunlight irradiation.

Surface Hydroxyl Chemistry of Titania- and Alumina-Based Supports: Quantitative Titration and Temperature Dependence of Surface Brønsted Acid-Base Parameters

Surface hydroxyl groups on metal oxides play significant roles in catalyst synthesis and catalytic reactions. Despite the importance of surface hydroxyls in broader material applications, quantitative measurements of surface acid-base properties are not regularly reported. Here, we describe direct methods to quantify fundamental properties of surface hydroxyls on several titania- and alumina-based supports. Comparing commercially available anatase, rutile, P25, and P90 titania, thermogravimetric analysis (TGA) indicated that the total surface hydroxyl density varied by a factor of 2, and each surface hydroxyl is associated with approximately one weakly adsorbed water molecule. Proton-exchange site densities, determined at 25 °C with slurry acid-base titrations, led to several conclusions: (i) the intrinsic acidity/basicity of surface hydroxyls were similar regardless of the titania source; (ii) differences in the surface isoelectric point (IEP) were primarily attributable to differences in the surface concentration of acid and base sites; (iii) rutile has a higher surface concentration of basic hydroxyls, leading to a higher IEP; and (iv) P25 and P90 titania have slightly higher surface concentrationsof acidic hydroxyls relative to anatase or rutile. Temperature effects on surface acid-base properties are rarely reported yet are significant: from 5 to 65 °C, IEP values change by roughly one pH unit. The IEP changes were associated with large changes to the intrinsic acid-base equilibrium constants over this temperature range, rather than changes in the composition or concentration of the surface sites.

Electronic modulation of metal-support interactions improves polypropylene hydrogenolysis over ruthenium catalysts

Ruthenium (Ru) is the one of the most promising catalysts for polyolefin hydrogenolysis. Its performance varies widely with the support, but the reasons remain unknown. Here, we introduce a simple synthetic strategy (using ammonia as a modulator) to tune metal-support interactions and apply it to Ru deposited on titania (TiO₂). We demonstrate that combining deuterium nuclear magnetic resonance spectroscopy with temperature variation and density functional theory can reveal the complex nature, binding strength, and H amount. H₂ activation occurs heterolytically, leading to a hydride on Ru, an H⁺ on the nearest oxygen, and a partially positively charged Ru. This leads to partial reduction of TiO₂ and high coverages of H for spillover, showcasing a threefold increase in hydrogenolysis rates. This result points to the key role of the surface hydrogen coverage in improving hydrogenolysis catalyst performance.

Catalytic pathways of plastic waste valorization to lubricants are attractive avenues to foster circular economy. Tuning of catalyst electronic properties allows to significantly improve its activity due to boosted hydrogen storage on the surface.

Synthesis of γ-Pyrones and N-Methyl-4-pyridones via the Au Nanoparticle-Catalyzed Cyclization of Skipped Diynones in the Presence of Water or Aqueous Methylamine

Supported Au nanoparticles on TiO₂ catalyze the hydration/6-endo cyclization of skipped diynones to γ-pyrones in aqueous dioxane, via triple bond activation. The isomeric 3(2H)-furanones which could be formed through a competing and often prevailing 5-exo cyclization pathway using homogeneous ionic Au(I) catalysts were not seen. The reaction does not proceed via the initial 1,3-transposition of the skipped diynones to their corresponding conjugated 1,3-diynone isomers. If aqueous methylamine is added, N-methyl-4-pyridones are exclusively formed in 69-79% yields via an analogous hydroamination/Au-catalyzed 6-endo cyclization pathway.