The Preparation of CuInS2-ZnS-Glutathione Quantum Dots and Their Application on the Sensitive Determination of Cytochrome c and Imaging of HeLa Cells

A novel fluorescent sensor for selective rifampicin detection based on the bio-inspired molecularly imprinted polymer-AgInS2/ZnS quantum dots

A fluorescent sensing material based on the ternary core-shell quantum dots with outstanding optical properties and a bio-inspired molecularly imprinted polymer (MIP) as a recognition element has been prepared for selective detection of rifampicin (RFP). Firstly, AgInS2/ZnS core/shell quantum dots (ZAIS QDs) were prepared by a hydrothermal process. Then, the fluorescent sensor was prepared by coating these QDs by a dopamine-based MIP layer. The fluorescence of MIP@ZAIS QDs was quenched by RFP probably due to the photoinduced electron transfer process. The quenching constant was much higher for MIP@ZAIS QDs than the non-imprinted polymer@QDs, indicating that MIP@ZAIS QDs could selectively recognize RFP. Under the optimized conditions, the sensor had a good linear relationship at the RFP concentration range of 5.0 to 300 nM and the limit of detection was 1.25 nM. The respond time of the MIP@ZAIS QDs was 5 min, and the imprinting factor was 6.3. It also showed good recoveries ranging from 98 to 101%, for analysis of human plasma samples. The method is simple and effective for the detection of RFP and offers a practical application for the rapid analysis of human plasma samples.

Development of a fluorometric and colorimetric dual-mode sensing platform for acid phosphatase assay based on Fe3+ functionalized CuInS2/ZnS quantum dots

BACKGROUND

The spectral dual-mode response towards analyte has been attracted much attention, benefiting from the higher detection accuracy of such strategy in comparison to single signal readout. However, the currently reported dual-mode sensors for acid phosphatase (ACP) activity are still limited, and most of them more or less exist some deficiencies, such as complicated construction procedure, high-cost, poor biocompatibility, aggregation-caused quenching and limited emission capacity.

RESULTS

Herein, we employed Fe3+ functionalized CuInS2/ZnS quantum dots (CIS/ZnS QDs) as nanosensor to develop a novel fluorometric and colorimetric dual-mode assay for ACP activity, combing with ACP-triggered hydrolysis of ascorbic acid 2-phosphate (AAP) into ascorbic acid (AA). The Fe3+ binding to CIS/ZnS QDs can be reduced into Fe2+ during the determination, resulting in the dramatically weakened photoinduced electron transfer (PET) effect and the disappearance of competition absorption. Thus, a highly sensitive ACP assay in the range of 0.22-12.5 U L-1 through fluorescence "turn-on" mode has been achieved with a detection of limit (LOD) of 0.064 U L-1. Meanwhile, the ACP activity can also be quantified by spectrophotometry based on the chromogenic reaction of the formed Fe2+ with 1,10-phenanthroline (Phen). Moreover, the designed nanosensor with good biocompatibility was successfully applied to image and monitor the ACP levels in living cells.

SIGNIFICANCE

We believe that the proposed method has remarkable advantages and potential application for ACP assay in terms of the high accuracy, simplicity, low cost, as well as its adequate sensitivity.

Enzyme immobilized on magnetic fluorescent bifunctional nanoparticles for α-glucosidase inhibitors virtual screening from Agrimonia pilosa Ledeb extracts accompanied with molecular modeling

Agrimonia pilosa Ledeb (APL) is a significant source of inhibitors for α-glucosidase, which is an essential target enzyme for the treatment of type 2 diabetes, cancer and acquired immune deficiency syndrome. Ligand fishing is a suitable approach for the highly selective screening of bioactive substances in complex mixtures. Yet it is unable to conduct biomedical imaging screening, which is crucial for real-time identification. In this case, a bioanalytical platform combining magnetic fluorescent ligand fishing and in-situ imaging technique was established for the screening and identification of α-glucosidase inhibitors (AGIs) from APL crude extract, utilizing α-glucosidase coated CuInS2/ZnS-Fe3O4@SiO2 (AG-CIZSFS) nanocomposites as extracting material and fluorescent tracer. The AG-CIZSFS nanocomposites prepared through solvothermal and crosslinking methods displayed fast magnetic separation, excellent fluorescence performance and high enzyme activity. The tolerance of immobilized enzyme to temperature and pH was stronger than that of free enzyme. Prior to proof-of-concept with APL crude extract, a number essential parameters (glutaraldehyde concentration, immobilized time, enzyme amount, reaction solution pH, incubation temperature, incubation time, percentage of methanol in eluen, elution times and eluent volume) were optimized using an artificial test mixture. The fished ligands were identified by UPLC-MS/MS and their biological activities were preliminarily evaluated by real-time cellular morphological imaging of human colon carcinoma (HCT-116) cells based on confocal laser scanning microscope (CLSM). Their α-glucosidase inhibitory activities were further verified and studied by classical pNPG method and molecular docking. The isolated compounds exhibited significant α-glucosidase inhibitory activities with a IC50 value of 11.57 µg·mL-1. Six potential AGIs including tribuloside, ivorengenin A, tormentic acid, 1β, 2β, 3β, 19α-Tetra hydroxyurs-12-en-28-oic acid, corosolic acid and pomolic acid were ultimately screened out and identified from APL crude extracts. The proposed approach, which combined highly specific screening with in-situ visual imaging, provided a powerful platform for discovering bioactive components from multi-component and multi-target traditional Chinese medicine (TCM).

Temperature- and Size-Dependent Photoluminescence of CuInS2 Quantum Dots

We present the results of a temperature-dependent photoluminescence (PL) spectroscopy study on CuInS2 quantum dots (QDs). In order to elucidate the influence of QD size on PL temperature dependence, size-selective precipitation was used to obtain several nanoparticle fractions. Additionally, the nanoparticles' morphology and chemical composition were studied using transmission electron microscopy, X-ray diffraction, and X-ray photoelectron spectroscopy. The obtained QDs showed luminescence in the visible-near infrared range. The PL energy, linewidth, and intensity were studied within an 11-300 K interval. For all fractions, a temperature decrease led to a shift in the emission maximum to higher energies and pronounced growth of the PL intensity down to 75-100 K. It was found that for large particle fractions, the PL intensity started to decrease, with temperature decreasing below 75 K, while the PL intensity of small nanoparticles remained stable.

A Review on Multiple I-III-VI Quantum Dots: Preparation and Enhanced Luminescence Properties

I-III-VI type QDs have unique optoelectronic properties such as low toxicity, tunable bandgaps, large Stokes shifts and a long photoluminescence lifetime, and their emission range can be continuously tuned in the visible to near-infrared light region by changing their chemical composition. Moreover, they can avoid the use of heavy metal elements such as Cd, Hg and Pb and highly toxic anions, i.e., Se, Te, P and As. These advantages make them promising candidates to replace traditional binary QDs in applications such as light-emitting diodes, solar cells, photodetectors, bioimaging fields, etc. Compared with binary QDs, multiple QDs contain many different types of metal ions. Therefore, the problem of different reaction rates between the metal ions arises, causing more defects inside the crystal and poor fluorescence properties of QDs, which can be effectively improved by doping metal ions (Zn²⁺, Mn²⁺ and Cu⁺) or surface coating. In this review, the luminous mechanism of I-III-VI type QDs based on their structure and composition is introduced. Meanwhile, we focus on the various synthesis methods and improvement strategies like metal ion doping and surface coating from recent years. The primary applications in the field of optoelectronics are also summarized. Finally, a perspective on the challenges and future perspectives of I-III-VI type QDs is proposed as well.

A turn-off fluorimetric -aptasensor for early detection of apoptosis inside the cells

To detect cytochrome c (Cyt c) as an important biomarker of apoptosis inside the cells, a simple, label-free, fluorometric detection method has been presented. For this purpose, an aptamer/gold nanocluster probe (Aptamer@AuNCs) was produced which could specifically bind to Cyt c leading to fluorescence quenching of AuNCs. The developed aptasensor showed two linear ranges of 1-80 μM and 100-1000 μM and a detection limit of 0.77 μM and 297.5 μM, respectively. This platform was successfully used to assay Cyt c release inside the apoptotic cells and their cell lysate. Aptamer@AuNC due to its enzyme-like properties could replace antibodies in Cyt c detection by conventional blotting techniques.

Luminescent Quantum Dots: Synthesis, Optical Properties, Bioimaging and Toxicity

Luminescent nanomaterials such as semiconductor nanocrystals (NCs) and quantum dots (QDs) attract much attention to optical detectors, LEDs, photovoltaics, displays, biosensing, and bioimaging. These materials include metal chalcogenide QDs and metal halide perovskite NCs. Since the introduction of cadmium chalcogenide QDs to biolabeling and bioimaging, various metal nanoparticles (NPs), atomically precise metal nanoclusters, carbon QDs, graphene QDs, silicon QDs, and other chalcogenide QDs have been infiltrating the nano-bio interface as imaging and therapeutic agents. Nanobioconjugates prepared from luminescent QDs form a new class of imaging probes for cellular and in vivo imaging with single-molecule, super-resolution, and 3D resolutions. Surface modified and bioconjugated core-only and core-shell QDs of metal chalcogenides (MX; M = Cd/Pb/Hg/Ag, and X = S/Se/Te,), binary metal chalcogenides (MInX₂; M = Cu/Ag, and X = S/Se/Te), indium compounds (InAs and InP), metal NPs (Ag, Au, and Pt), pure or mixed precision nanoclusters (Ag, Au, Pt), carbon nanomaterials (graphene QDs, graphene nanosheets, carbon NPs, and nanodiamond), silica NPs, silicon QDs, etc. have become prevalent in biosensing, bioimaging, and phototherapy. While heavy metal-based QDs are limited to in vitro bioanalysis or clinical testing due to their potential metal ion-induced toxicity, carbon (nanodiamond and graphene) and silicon QDs, gold and silica nanoparticles, and metal nanoclusters continue their in vivo voyage towards clinical imaging and therapeutic applications. This review summarizes the synthesis, chemical modifications, optical properties, and bioimaging applications of semiconductor QDs with particular references to metal chalcogenide QDs and bimetallic chalcogenide QDs. Also, this review highlights the toxicity and pharmacokinetics of QD bioconjugates.

Review of Mn-Doped Semiconductor Nanocrystals for Time-Resolved Luminescence Biosensing/Imaging

Colloidal semiconductor nanocrystals (NCs) have been developed for decades and are widely applied in biosensing/imaging. However, their biosensing/imaging applications are mainly based on luminescence-intensity measurement, which suffers from autofluorescence in complex biological samples and thus limits the biosensing/imaging sensitivities. It is expected for these NCs to be further developed to gain luminescence features that can overcome sample autofluorescence. On the other hand, time-resolved luminescence measurement utilizing long-lived-luminescence probes is an efficient technique to eliminate short-lived autofluorescence of samples while recording time-resolved luminescence of the probes for signal measurement after pulsed excitation from a light source. Despite time-resolved measurement being very sensitive, the optical limitations of many of the current long-lived-luminescence probes cause time-resolved measurement to be generally performed in laboratories with bulky and costly instruments. In order to apply highly sensitive time-resolved measurement for in-field or point-of-care (POC) testing, it is essential to develop probes possessing high brightness, low-energy (visible-light) excitation, and long lifetimes of up to milliseconds. Such desired optical features can significantly simplify the design criteria of time-resolved measurement instruments and facilitate the development of low-cost, compact, sensitive instruments for in-field or POC testing. Mn-doped NCs have recently been in rapid development and provide a strategy to solve the challenges faced by both colloidal semiconductor NCs and time-resolved luminescence measurement. In this review, we outline the major achievements in the development of Mn-doped binary and multinary NCs, with emphasis on their synthesis approaches and luminescence mechanisms. Specifically, we demonstrate how researchers approached these obstacles to achieve the aforementioned desired optical properties on the basis of the progressive understanding of Mn emission mechanisms. Afterward, we review representative applications of Mn-doped NCs in time-resolved luminescence biosensing/imaging and present the potential of Mn-doped NCs in advancing time-resolved luminescence biosensing/imaging for in-field or POC testing.

Modulation of bovine serum albumin aggregation by glutathione functionalized MoS2 quantum dots

In present study, a novel glutathione functionalized MoS₂ quantum dots (GSH-MoS₂ QDs) was synthesized from sodium molybdate dehydrate and glutathione by using a one-pot hydrothermal method. After they were characterized, the influence of GSH-MoS₂ QDs on amyloid aggregation of bovine serum albumin (BSA) was investigated by various analytical methods including thioflavin T fluorescence assay, circular dichroism and transmission electron microscope. Moreover, the effect of GSH-MoS₂ QDs on cytotoxicity induced by BSA amyloid fibrils and cell penetration were evaluated by MTT assay and confocal fluorescence imaging, respectively. The results indicated that the GSH-MoS₂ QDs not only had good water solubility, excellent biocompatibility and low cytotoxicity, but also could obviously inhibit the aggregation of BSA and depolymerize the formed BSA aggregates. The data obtained from this work demonstrated that the GSH-MoS₂ QDs is expected to become a candidate drug for the treatment of amyloid-related diseases.

Live-cell visualization of cytochrome c: a tool to explore apoptosis

Apoptosis dysfunction is associated with several malignancies, including cancer and autoimmune diseases. Apoptosis restoration could be an attractive therapeutic approach to those diseases. Mitochondrial outer membrane permeabilization is regarded as the point of no return in the 'classical' apoptosis triggering pathway. Cytoplasmic release of cytochrome c (cyt c), a mitochondrial electron transporter, is a prominent indicator of such critical step. Therefore, visualizing cyt c efflux in living cells is a convenient approach to address apoptosis triggering and monitor performance of apoptosis restoration strategies. Recent years have been prolific in the development of biosensors to visualize cyt c mitochondrial efflux in living cells, by fluorescence microscopy. These biosensors specifically detect endogenous, untagged cyt c, while showing efficient cellular uptake and reduced cell toxicity. A common aspect is their fluorescence quenching in the absence or presence of bound cyt c, resulting in two main biosensor types: 'turn ON' and 'turn OFF'. In some of these systems, fluorescence intensity of fluorophore-bound aptamers is enhanced upon cyt c binding. In others, cyt c binding to quantum dots quenches their fluorescence. In the present minireview, I describe these biosensors and briefly introduce some hypotheses that could be addressed using these novel tools.