Eco-Friendly Synthesis, Crystal Chemistry, and Magnetic Properties of Manganese-Substituted CoFe2O4 Nanoparticles

Tuning the magnetic properties of hard-soft Ba0.5Sr0.5Fe10Al2O19and Ni0.1Co0.9Fe2O4nanocomposites via one pot sol-gel auto combustion method for permanent magnet applications

Permanent magnets generate magnetic fields that can be sustained when a reverse field is supplied. These permanent magnets are effective in a wide range of applications. However, strategic rare-earth element demand has increased interest in replacing them with huge energy product (BH)max. Exchange-coupled hard/soft ferrite nanocomposites have the potential to replace a portion of extravagant rare earth element-based magnets. In the present, we have reported the facile auto combustion synthesis of exchange-coupled Ba0.5Sr0.5Fe10Al2O19and Ni0.1Co0.9Fe2O4nanocomposites by increasing the content of soft ferrite over the hard fromx= 0.1 to 0.4 wt%. The XRD combined with Rietveld analysis reflected the presence of hexaferrite and spinel ferrite without the existence of secondary phases. The absorption bands from the Fourier transform infrared spectrum analysis proved the presence of M-O bonds in tetrahedral sites and octahedral sites. Rod and non-spherical images from TEM represent the hexaferrite and spinel ferrite. The smoothM-Hcurve and a single peak of the switching field distribution curve prove that the material has undergone a good exchange coupling. The nanopowders displayed an increase in saturation magnetization and a decrease in coercivity with the increases in the spinel content. The prepared nanocomposites were showing higher energy products. The composite with the ratiox= 0.2 displayed a higher value of (BH)maxof 13.16 kJ m-3.

Mercury remediation from wastewater through its spontaneous adsorption on non-functionalized inverse spinel magnetic ferrite nanoparticles

In this study, inverse spinel cubic ferrites MFe2O4 (M = Fe2+, and Co2+) have been fabricated for the high-capacity adsorptive removal of Hg(II) ions. The PXRD analysis confirmed ferrites with the presence of residual NaCl. The surface area of Fe3O4 (Fe-F) and CoFe2O4 (Co-F) material was 69.1 and 45.2 m2 g-1, respectively. The Co-F and Fe-F showed the maximum Hg(II) adsorption capacity of 459 and 436 mg g-1 at pH 6. The kinetic and isotherms models suggested a spontaneous adsorption process involving chemical forces over the ferrite adsorbents. The Hg(II) adsorption process, probed by X-ray photoelectron spectroscopy (XPS), confirmed the interaction of Hg(II) ions with the surface hydroxyl groups via a complexation mechanism instead of proton exchange at pH 6 with the involvement of chloride ions. Thus, this study demonstrates a viable and cost-effective solution for the efficient remediation of Hg ions from wastewater using non-functionalized ferrite adsorbents. This study also systematically investigates the kinetics and isotherm mechanism of Hg(II) adsorption onto ferrites and reports one of the highest Hg(II) adsorption capacities among other ferrite-based adsorbents.

An advanced photo-oxidation process for pharmaceuticals using plasmon-assisted Ag-CoFe2O4 photocatalysts

The discharge of amoxicillin (AMX) from pharmaceutical intermediates has adverse effects on aquatic ecosystems. The elimination of AMX requires advanced oxidation processes (AOPs) that utilize high-performance photocatalysts. Furthermore, the design of highly visible light photocatalysts for AOPs demands both cost-effectiveness and efficiency. In this work, a plasmon-assisted visible light photocatalyst of 2D Ag-CoFe2O4 nanohybrids was successfully synthesized and characterized with several analytical tools to degrade AMX in aqueous solutions through advanced AOPs. The results showed that the Ag-CoFe2O4 nanohybrids had excellent photocatalytic activity and stability, which could efficiently reduce the AMX concentration by 99% within 70 min under visible light irradiation. In particular, CoFe2O4 and Ag have an interfacial contact that prevents electron-hole pair recombination more effectively than pure CoFe2O4, which results in electrons in its conduction band (CB) migrating to metallic Ag sites. Thus, charge transfers between the two materials are more efficient, leading to higher photocatalytic oxidation of AMX. Furthermore, the surface plasmon of Ag nanoparticles are excited by their plasmonic resonance, which increases the absorption of visible light. The plasmon-assisted visible light photocatalyst could replace expensive and energy-intensive advanced oxidation processes (AOPs). AOPs pathways associated with AMX have been discussed in detail. The HPLC chromatogram clearly showed AMX was oxidized by four-membered B-lactam ring opening and hydroxylation with •OH. 2D Ag-CoFe2O4 heterostructure was found to be efficient, selective, and cost-effective for the degradation of several pharmaceutical compounds. Additionally, it was found to be eco-friendly and sustainable, making it a viable alternative to AOPs.

Effective aqueous chromate treatment using triethanolamine anacardate coated magnetic nanoparticles

Low-cost adsorbents derived from agricultural by-products incorporated magnetic nanoparticles (NPs) are promising for wastewater treatment. They are always preferred due to their great performance and easy separation. This study reports cobalt superparamagnetic (CoFe₂O₄) nanoparticles (NPs) incorporated with triethanolamine (TEA) based surfactants from cashew nut shell liquid, namely TEA-CoFe₂O₄, for the removal of chromium (VI) ions from aqueous solutions. To have detailed characteristics of the morphology and structural properties, scanning electron microscopy (SEM), X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FT-IR) and vibrating sample magnetometry (VSM) were employed. The fabricated TEA-CoFe₂O₄ particles exhibit soft and superparamagnetic properties, which make the nanoparticles easily recycled by using a magnet. Chromate adsorption on the TEA-CoFe₂O₄ nanomaterials reached an optimal efficiency of 84.3% at pH = 3 with the initial adsorbent dose of 10 g/L and chromium (VI) concentration of 40 mg/L. The TEA-CoFe₂O₄ nanoparticles can maintain the effective adsorption of chromium (VI) ion (by 29% of efficiency loss) and retain the magnetic separation using a magnet up to three cycles of the regeneration, which promise a high potential of this low-cost adsorbent for long-term treatment of heavy metal ions from polluted waters.

Towards hard-magnetic behavior of CoFe2O4 nanoparticles: a detailed study of crystalline and electronic structures, and magnetic properties

We have used the coprecipitation and mechanical-milling methods to fabricate CoFe₂O₄ nanoparticles with an average crystallite size (d) varying from 81 to ∼12 nm when changing the milling time (t _m) up to 180 min. X-ray diffraction and Raman-scattering studies have proved the samples crystalizing in the spinel structure. Both the lattice constant and residual strain tend to increase when t _m(d) increases (decreases). The analysis of magnetization data has revealed a change in the coercivity (H _c) towards the hard-magnetic properties. Specifically, the maximum H _c is about 2.2 kOe when t _m = 10 min corresponding to d ≈ 29 nm; beyond this t _m(d) value, H _c gradually decreases. Meanwhile, the increase of t _m always reduces the saturation magnetization (M _s) from ∼69 emu g^-1 for t _m = 0 to 35 emu g^-1 for t _m = 180 min. The results collected as analyzing X-ray absorption data have indicated a mixed valence state of Fe^2+,3+ and Co²⁺ ions. We think that the migration and redistribution of these cations between the tetrahedral and octahedral sites together with lattice distortions and defects induced by the milling process have impacted the magnetic properties of the CoFe₂O₄ nanoparticles.

Effect of Oleylamine on the Surface Chemistry, Morphology, Electronic Structure, and Magnetic Properties of Cobalt Ferrite Nanoparticles

The influence of oleylamine (OLA) concentration on the crystallography, morphology, surface chemistry, chemical bonding, and magnetic properties of solvothermal synthesized CoFe₂O₄ (CFO) nanoparticles (NPs) has been thoroughly investigated. Varying OLA concentration (0.01-0.1 M) resulted in the formation of cubic spinel-structured CoFe₂O₄ NPs in the size-range of 20-14 (±1) nm. The Fourier transform spectroscopic analyses performed confirmed the OLA binding to the CFO NPs. The thermogravimetric measurements revealed monolayer and multilayer coating of OLA on CFO NPs, which were further supported by the small-angle X-ray scattering measurements. The magnetic measurements indicated that the maximum saturation (M_S) and remanent (M_r) magnetization decreased with increasing OLA concentration. The ratio of maximum dipolar field (H_dip), coercivity (H_C), and exchanged bias field (H_ex) (at 10 K) to the average crystallite size (D_xrd), i.e., (H_dip/D_xrd), (H_C/D_xrd), and (H_ex/D_xrd), increased linearly with OLA concentration, indicating that OLA concurrently controls the particle size and interparticle interaction among the CFO NPs. The results and analyses demonstrate that the OLA-mediated synthesis allowed for modification of the structural and magnetic properties of CFO NPs, which could readily find potential application in electronics and biomedicine.

Synthesis and characterization of CoxFe1-xFe2O4 nanoparticles by anionic, cationic, and non-ionic surfactant templates via co-precipitation

The cobalt ferrite nanoparticles (Co_xFe_1-xFe₂O₄) were synthesized by the surfactant templated co-precipitation method using various surfactants namely sodium dodecyl sulfate (SDS), hexadecyltrimethylammonium bromide (CTAB), and Tween20. Under the substitution, the Co_xFe_1-xFe₂O₄ particles were synthesized at various Co²⁺ and Fe²⁺ mole ratios (x = 1, 0.6, 0.2, and 0) with the SDS. The cobalt ferrite nanoparticles were characterized for their morphology, structure, magnetic, and electrical properties. All Co_xFe_1-xFe₂O₄ nanoparticles showed the nanoparticle sizes varying from 16 to 43 nm. In the synthesis of CoFe₂O₄, the SDS template provided the smallest particle size, whereas the saturated magnetization (M_s) of CoFe₂O₄ was reduced by using CTAB, SDS, and Tween20. For the Co_xFe_1-xFe₂O₄ as synthesized by the SDS template at 1.2 CMC, the M_s increased with increasing Fe²⁺ mole ratio. The highest M_s of 100.4 emu/g was obtained from the Fe₃O₄ using the SDS template. The Fe₃O₄ nanoparticle is potential to be used in various actuator and biomedical devices.

A controllable one-pot hydrothermal synthesis of spherical cobalt ferrite nanoparticles: synthesis, characterization, and optical properties

We herein report the controllable synthesis of spherical cobalt ferrite nanoparticles with average crystallite size in the range of 3.6–12.9 nm using a facile, eco-friendly, hydrothermal method. The hydrothermal treatment was carried out by utilizing cobalt nitrate, ferric nitrate, and ammonium hydroxide in the presence and absence of Arabic gum as a surfactant agent. The purity and crystallinity of the products were tuned by varying reaction conditions such as reaction time (0.5–8 h), reaction temperature (120–180 °C), percentage of ethylene glycol (0–100% (v/v)), pH (8–9.6), and amount of Arabic gum (0–2 g). We characterized the prepared products using X-ray diffraction (XRD), field-emission scanning electron microscopy (FE-SEM), Fourier transform infrared spectroscopy (FT-IR), high-resolution transmission electron microscopy (HR-TEM), energy-dispersive X-ray spectroscopy analysis (EDS), selected area electron diffraction (SAED) patterns, and UV-visible diffuse reflectance spectra (DRS). The optimal hydrothermal treatment was performed at 180 °C and pH 9.6 for 4 h in aqueous media. The results also revealed that the as-prepared spinel cobalt ferrite nanoparticles have an estimated optical band gap energy in the range of ca. 1.6–1.9 eV, indicating the semiconducting characteristics of the products.

A controllable synthesis of spherical cobalt ferrite nanoparticles with average crystallite size in the range of 3.6–12.9 nm using a facile, eco-friendly, hydrothermal method.

Fast and Efficient Removal of Uranium onto a Magnetic Hydroxyapatite Composite: Mechanism and Process Evaluation

The exploration and rational design of easily separable and highly efficient sorbents with satisfactory capability of extracting radioactive uranium (U)-containing compound(s) are of paramount significance. In this study, a novel magnetic hydroxyapatite (HAP) composite (HAP@ CoFe2O4), which was coupled with cobalt ferrite (CoFe2O4), was rationally designed for uranium(VI) removal through a facile hydrothermal process. The U(VI) ions were rapidly removed using HAP@ CoFe2O4 within a short time (i.e., 10 min), and a maximum U(VI) removal efficiency of 93.7% was achieved. The maximum adsorption capacity (Qmax) of the HAP@CoFe2O4 was 338 mg/g, which demonstrated the potential of as-prepared HAP@CoFe2O4 in the purification of U(VI) ions from nuclear effluents. Autunite [Ca(UO2)2(PO4)2(H2O)6] was the main crystalline phase to retain uranium, wherein U(VI) was effectively extracted and immobilized in terms of a relatively stable mineral. Furthermore, the reacted HAP@CoFe2O4 can be magnetically recycled. The results of this study reveal that the suggested process using HAP@CoFe2O4 is a promising approach for the removal and immobilization of U(VI) released from nuclear effluents.

CoFe2O4 supported g-C3N4 nanocomposite for the sensitive electrochemical detection of dopamine

The CoFe2O4@g-CN modified electrode has been applied for the real-time detection of DA in human biological samples with appreciable recovery results.

Coercivity dependence of cation distribution in Co-based spinel: correlating theory and experiments

The inversion degree of a spinel-type nanomaterial is an essential parameter to understand the magnetic and electronic properties of ferrites. By micromagnetic simulations, we were able to connect DFT calculations and experiments for CoFe₂O₄ NPs.