Carbon- and oxygen-free Cu(InGa)(SSe)₂ solar cell with a 4.63% conversion efficiency by electrostatic spray deposition

A deep look into the spray coating process in real-time-the crucial role of x-rays

Tailoring functional thin films and coating by rapid solvent-based processes is the basis for the fabrication of large scale high-end applications in nanotechnology. Due to solvent loss of the solution or dispersion inherent in the installation of functional thin films and multilayers the spraying and drying processes are strongly governed by non-equilibrium kinetics, often passing through transient states, until the final structure is installed. Therefore, the challenge is to observe the structural build-up during these coating processes in a spatially and time-resolved manner on multiple time and length scales, from the nanostructure to macroscopic length scales. During installation, the interaction of solid-fluid interfaces and between the different layers, the flow and evaporation themselves determine the structure of the coating. Advanced x-ray scattering methods open a powerful pathway for observing the involved processes in situ, from the spray to the coating, and allow for gaining deep insight in the nanostructuring processes. This review first provides an overview over these rapidly evolving methods, with main focus on functional coatings, organic photovoltaics and organic electronics. Secondly the role and decisive advantage of x-rays is outlined. Thirdly, focusing on spray deposition as a rapidly emerging method, recent advances in investigations of spray deposition of functional materials and devices via advanced x-ray scattering methods are presented.

Enhanced Photoelectrochemical Solar Water Splitting Using a Platinum-Decorated CIGS/CdS/ZnO Photocathode

A Cu(InGa)Se2 film was modified with CdS/ZnO for application to solar water splitting. Platinum was electrodeposited on the ZnO layer as a hydrogen evolution catalyst. The effects of the electroplating time and acidity level of the electrolyte on the photocurrent density were studied. The highest photocurrent density of -32.5 mA/cm(2) under 1.5 AM illumination was achieved with an electroplating time of 30 min at a pH of 9. This photocurrent density is higher than those reported in previous studies. The markedly high performance of the CIGS/CdS/ZnO photocathode was rationalized in terms of its type II cascade structure that facilitated efficient charge separation at the interface junction.

Jalpaite Ag3CuS2: a novel promising ternary sulfide absorber material for solar cells

A novel promising Ag₃CuS₂ absorber material for tertiary generation solar cells.