Antecedent growth conditions alter retention of environmental Escherichia coli isolates in transiently wetted porous media

Use of Molecular Markers to Compare Escherichia coli Transport with Traditional Groundwater Tracers in Epikarst

Bacterial contamination of karst aquifers is a global concern as water quality deteriorates in the face of decreasing water security. Traditional abiotic groundwater tracers, which do not exhibit surface properties similar to bacteria, may not be good proxies for risk assessment of bacterial transport in karst environments. This study examined the transport and attenuation of two isolates of in relation to traditional groundwater tracers (rhodamine WT dye and 1-μm-diam. latex microspheres) through ∼30 m of epikarst in western Kentucky. Differential movement of the four tracers was observed, with tracer behavior dependent on flow conditions. Dye arrived at the sampling site prior to particulates. Molecular biology techniques successfully detected bacteria in the cave and showed attenuation was greater for a bacterial isolate with high attachment efficiency compared with an isolate known to have low attachment efficiency. Microspheres were first detected simultaneously with the low-attachment isolate but attained maximum concentrations during increases in discharge >11 d post-injection. Bacteria were remobilized by storm events >60 d after injection, illustrating the storage capacity of epikarst with regard to potential contaminants. The two bacterial strains were not transported at the same rate within the epikarst, showing breakthroughs during differing storm events and illustrating the importance of cell surface chemistry in the prediction of microorganism movement. Moreover, this study has shown that molecular analysis can be successfully used to target, quantify, and track introduced microbial tracers in karst terrains.

Quantifying Attachment and Antibiotic Resistance of from Conventional and Organic Swine Manure

Broad-spectrum antibiotics are often administered to swine, contributing to the occurrence of antibiotic-resistant bacteria in their manure. During land application, the bacteria in swine manure preferentially attach to particles in the soil, affecting their transport in overland flow. However, a quantitative understanding of these attachment mechanisms is lacking, and their relationship to antibiotic resistance is unknown. The objective of this study is to examine the relationships between antibiotic resistance and attachment to very fine silica sand in collected from swine manure. A total of 556 isolates were collected from six farms, two organic and four conventional (antibiotics fed prophylactically). Antibiotic resistance was quantified using 13 antibiotics at three minimum inhibitory concentrations: resistant, intermediate, and susceptible. Of the 556 isolates used in the antibiotic resistance assays, 491 were subjected to an attachment assay. Results show that isolates from conventional systems were significantly more resistant to amoxicillin, ampicillin, chlortetracycline, erythromycin, kanamycin, neomycin, streptomycin, tetracycline, and tylosin ( < 0.001). Results also indicate that isolated from conventional systems attached to very fine silica sand at significantly higher levels than those from organic systems ( < 0.001). Statistical analysis showed that a significant relationship did not exist between antibiotic resistance levels and attachment in from conventional systems but did for organic systems ( < 0.001). Better quantification of these relationships is critical to understanding the behavior of in the environment and preventing exposure of human populations to antibiotic-resistant bacteria.

Transport of Escherichia coli strains isolated from natural spring water

We present a new methodology to scale up bacteria transport experiments carried out in the laboratory to practical field situations. The key component of the methodology is to characterize bacteria transport not by a constant sticking efficiency, but by a range of sticking efficiency values determined from laboratory column experiments. In this study, initially, we harvested six Escherichia coli strains from springs in Kampala, the capital of Uganda, and then we carried out a number of experiments with 1.5m high columns of quartz sand with various sampling ports in order to determine the fraction of bacteria as a function of sticking efficiency. Furthermore, we developed a simple mathematical formulation, based on the steady-state analytical solution for the transport of mass in the subsurface, to arrive at bacteria concentrations as a function of transport distance. The results of the quartz sand column experiments indicated that the fractional bacteria mass and sticking efficiency of most of the strains we harvested could be adequately described by a power law. When applying the power distributions to the field situation in Kampala, we found that the transport distance required to reduce bacteria concentrations with five log units ranged from 1.5 to 23m, and this was up to three times more than when using a constant sticking efficiency. The methodology we describe is simple, can be carried out in a spreadsheet, and in addition to parameters describing transport, like pore water flow velocity and dispersion, only two constants are required, which define the relation between sticking efficiency and percentage of bacteria mass.

Transport of Escherichia coli in 25 m quartz sand columns

To help improve the prediction of bacteria travel distances in aquifers laboratory experiments were conducted to measure the distant dependent sticking efficiencies of two low attaching Escherichia coli strains (UCFL-94 and UCFL-131). The experimental set up consisted of a 25 m long helical column with a diameter of 3.2 cm packed with 99.1% pure-quartz sand saturated with a solution of magnesium sulfate and calcium chloride. Bacteria mass breakthrough at sampling distances ranging from 6 to 25.65 m were observed to quantify bacteria attachment over total transport distances (α(L)) and sticking efficiencies at large intra-column segments (α(i)) (>5m). Fractions of cells retained (F(i)) in a column segment as a function of α(i) were fitted with a power-law distribution from which the minimum sticking efficiency defined as the sticking efficiency of 0.001% bacteria fraction of the total input mass retained that results in a 5 log removal were extrapolated. Low values of α(L) in the order 10(-4) and 10(-3) were obtained for UCFL-94 and UCFL-131 respectively, while α(i)-values ranged between 10(-6) to 10(-3) for UCFL-94 and 10(-5) to 10(-4) for UCFL-131. In addition, both α(L) and α(i) reduced with increasing transport distance, and high coefficients of determination (0.99) were obtained for power-law distributions ofα(i) for the two strains. Minimum sticking efficiencies extrapolated were 10(-7) and 10(-8) for UCFL-94 and UCFL-131, respectively. Fractions of cells exiting the column were 0.19 and 0.87 for UCFL-94 and UCL-131, respectively. We concluded that environmentally realistic sticking efficiency values in the order of 10(-4) and 10(-3) and much lower sticking efficiencies in the order 10(-5) are measurable in the laboratory, Also power-law distributions in sticking efficiencies commonly observed for limited intra-column distances (<2m) are applicable at large transport distances(>6m) in columns packed with quartz grains. High fractions of bacteria populations may possess the so-called minimum sticking efficiency, thus expressing their ability to be transported over distances longer than what might be predicted using measured sticking efficiencies from experiments with both short (<1m) and long columns (>25 m). Also variable values of sticking efficiencies within and among the strains show heterogeneities possibly due to variations in cell surface characteristics of the strains. The low sticking efficiency values measured express the importance of the long columns used in the experiments and the lower values of extrapolated minimum sticking efficiencies makes the method a valuable tool in delineating protection areas in real-world scenarios.

Association of quantum dot nanoparticles with Pseudomonas aeruginosa biofilm

Quantum dots (QDs) of two different surface chemistries (carboxyl [COOH] and polyethylene glycol [PEG] modified) were utilized to determine the impact of surface functionality on QD mobility and distribution in Pseudomonas aeruginosa PAO1 biofilms. Confocal laser scanning microscopy was utilized to evaluate QD association with biofilm components (proteins, cells, and polysaccharides). Quantum dots did not preferentially associate with cell surfaces compared but did colocalize with extracellular proteins in the biofilm matrix. Neither PEG nor COOH QDs were found to be internalized by individual bacterial cells. Neither QD functionality nor flow rate of QD application (0.3 mL min(-1) or 3.0 mL min(-1)) resulted in a marked difference in QD association with P. aeruginosa biofilms. However, center of density determinations indicated COOH QDs could more easily penetrate the biofilm matrix by diffusion than PEG QDs. Biofilms with PEG QDs associated had rougher polysaccharide layers and rougher cell distribution than biofilms with COOH QDs. This work suggests natural biofilms may serve as deposition locations in natural and engineered environmental systems, and biofilm structural parameters may change based on exposure to nanomaterials of varied physical characteristics.

Correlating transport behavior with cell properties for eight porcine Escherichia coli isolates

In this study we investigate how growth stage and depositional environment affect variability of cell properties and transport behavior of eight porcine E. coli isolates. We compared the surface properties for cells harvested during exponential and stationary growth phase and their transport behavior through columns packed with either uncoated or Fe-coated quartz sand. We then investigated correlations between measured cell properties and fitted bacterial attachment efficiencies. For both growth stages we found that bacterial attachment efficiencies in the uncoated quartz sand varied among the eight different isolates by over an order of magnitude whereas attachment efficiencies in the Fe-coated sands varied by a factor of less than two. With the exception of one isolate, growth condition had minimal impact on attachment efficiencies to the uncoated sands. A strong and statistically significant inverse relationship was observed between bacterial attachment efficiencies in the uncoated quartz sand columns and log-transformed zeta potential, whereas a mild yet statistically significant relationship between bacterial attachment efficiencies in the Fe-coated sands and cell width was observed. For the experimental conditions used in our study, we found that variability in E. coli transport was more dependent on the depositional environment than on growth conditions.