Zirconium Complex of an [OSSO]-Type Diphenolate Ligand Bearing trans-1,2-Cyclooctanediylbis(thio) Core: Synthesis, Structure, and Isospecific 1-Hexene Polymerization

Niobium Complexes Supported by Chalcogen-Bridged [OEO]-Type Bis(phenolate) Ligands (E = S, Se): Synthesis, Characterization, and Phenylacetylene Polymerization

Trichloro niobium(V) complexes 3 and 4 with the sulfur- or selenium-bridged [OEO]-type bis(phenolate) ligands (E = S, Se) were synthesized and fully characterized on the basis of their NMR spectroscopic data and X-ray crystallographic analysis. In the crystalline state of 4, the [OSeO]-core of the ligand was coordinated to the niobium center in a fac-fashion. The corresponding tribenzyl niobium(V) complexes 5 and 6 were also prepared by the reactions of 3 and 4 with 3 equivalents of PhCH2MgCl in toluene. The X-ray diffraction analysis of 6 revealed that the distorted six-coordinated niobium center incorporated in the [OSeO]-type ligand took a mer-fashion, and one benzyl ligand was coordinated to the niobium center by η2-fashion. Complexes 5 and 6 were tested for the phenylacetylene polymerization that produced poly(phenylacetylene)s (PPAs), oligomers, and triphenylbenzenes (TPBs) depending on the chalcogen atom in the [OEO]-type ligand.

NIS-promoted intermolecular bis-sulfenylation of allenamides via a two-step radical process: synthesis of 1,3-dithioethers

The first report of NIS-promoted two-step radical addition of thiols to allenamides to provide an efficient route for accessing 1,3-dithioethers.

Carbazolyl-Substituted [OSSO]-Type Zirconium(IV) Complex as a Precatalyst for the Oligomerization and Polymerization of α-Olefins

The dibenzyl zirconium(IV) complex (4) incorporating with a carbazolyl(Cbz)-substituted [OSSO]-type bis(phenolate) ligand was synthesized. Upon activation with dried modified methylaluminoxane (dMMAO), precatalyst 4 at relatively low catalyst loadings was found to promote the 1,2-regioselective oligomerization of 1-hexene to produce the corresponding vinylidene-ended oligomers with moderate turnover frequencies (TOFs) up to 2080 h−1. The 13C NMR analysis of the resulting oligomers revealed the formation of dimer-enriched oligo(1-hexene)s in 39–62% distributions. The precatalyst 4 with dried methylaluminoxane (dMAO) also exhibited good performance in the polymerization of styrene yielding isotactic polystyrenes ([mm] > 99%) with quite large molecular weights (Mw < 508,100 g mol−1) and relatively high catalytic activity (up to 2810 g mmol(4)−1 h−1).

Phenylene-Bridged OSSO-Type Titanium Complexes in the Polymerization of Ethylene and Propylene

The dichloro titanium complexes (OSSO tBu)TiCl2 (1) and (OSSOCum)TiCl2 (2) bearing o-phenylene-bridged OSSO-type ligands [OSSO tBu-H = 6,6'-((1,2-phenylenebis(sulfanediyl))bis(methylene))bis(2,4-di-tert-butyphenol) and OSSOCum-H = 6,6'-((1,2-phenylenebis(sulfanediyl))bis(methylene))bis(2,4-bis(2-phenylpropan-2-yl)phenol)] were prepared and characterized. The X-ray structure of 1 revealed that Ti atom has an octahedral coordination geometry with an fac-fac wrapping of the [OSSO] ligand. In solution at 25 °C, 1 mainly retains the C 2 symmetric structure, whereas 2 shows an equilibrium between C 2- and C 1-symmetric stereoisomers. Activation of 2 with (Ph3C)[B(C6F5)4] led to a highly active catalytic system with an activity of 238 kgPE·molcat -1·bar-1·h-1; linear polyethylene with a T m of 122 °C and M w of 107 kDa were obtained under these conditions. Catalyst 1 displayed the moderate activity of 59 kgPE·molcat -1·bar-1·h-1. Gel permeation chromatography analysis revealed the formation of high-molecular-weight polyethylenes with very large distributions of the molecular weights, indicating a low control of the polymerization process, probably becaue of the presence of different active species in solution. Density functional theory investigation provides a rational for the relative high-molecular-weight polymers obtained with these complexes. The precatalyst 2 was also active in propylene polymerization producing atactic oligomers terminated with unsaturated end groups.

Synthesis and structural characterization of zirconium complexes supported by tridentate pyrrolide-imino ligands with pendant N-, O- and S-donor groups and their application in ethylene polymerization

Zirconium complexes supported by pyrrolide-imino ligands been synthesized and their catalytic behavior in ethylene polymerization has been investigated.

Novel zirconium complexes with constrained cyclic β-enaminoketonato ligands: improved catalytic capability toward ethylene polymerization

Novel Zr(iv) and Hf(iv) complexes bearing two constrained bulky β-enaminoketonato ligands {[ArN[double bond, length as m-dash]CH-C8H3(CH2)n(R)O]2MBn2, M = Zr or Hf; n = 1, 2 or 3; R = H or C6H5; Ar = C6H5 or C6F5} were synthesized and clearly characterized. X-ray crystal structure analysis reveals that these complexes adopt a distorted octahedral geometry. Compared with non-constrained analogues, the Zr(iv) complexes with a cyclic skeleton exhibited high catalytic activities (up to 16.4 kgPE mmolZr(-1) h(-1)) toward ethylene polymerization at ambient pressure and elevated temperatures. Moreover, the catalytic properties of these complexes could be governed exquisitely by appropriate variation of the N-aryl substituents and the size of the benzocyclane. The Zr(iv) complexes bearing a non-fluorinated N-aryl group yielded oligomers, while the fluorinated analogues bearing a five-membered or six-membered cyclane group produced high molecular weight polyethylenes (33.4-306 kg mol(-1)) under similar conditions on account of the suppression effects on β-H elimination. The Zr(iv) complexes are more active toward ethylene polymerization than the Hf(iv) analogues, and the resulting polymers exhibited higher molecular weight and narrower molecular weight distribution.

Synthesis and Structural Characterization of Lithium and Titanium Complexes Bearing a Bulky Aryloxide Ligand Based on a Rigid Fused-Ring s-Hydrindacene Skeleton

The bulky aryl alcohols, (Rind)OH (1) [Rind = EMind (a) and Eind (b)], based on the rigid fused-ring 1,1,3,3,5,5,7,7-octa-R-substituted s-hydrindacene skeleton were prepared by the reaction of (Rind)Li with nitrobenzene followed by protonation. The treatment of 1 with (n)BuLi affords the lithium aryloxide dimers [(Rind)OLi(THF)]2 (2) or trimers [(Rind)OLi]3 (3), depending on the employed solvents (THF = tetrahydrofuran). The salt metathesis reaction of [(EMind)OLi(THF)]2 (2a) with TiCl4(THF)2 leads to the formation of the mononuclear diamagnetic mono- and bis(aryloxide) Ti(IV) complexes, [(EMind)O]TiCl3(THF) (4a) and [(EMind)O]2TiCl2 (5a). We also isolated a trace amount of the tris(aryloxide) Ti(IV) complex, [(EMind)O]3TiCl (6a). The reaction between 2a and TiCl3(THF)3 resulted in the isolation of the mononuclear paramagnetic mono- and bis(aryloxide) Ti(III) complexes, [(EMind)O]TiCl2(THF)2 (7a) and [(EMind)O]2TiCl(THF)2 (8a). The discrete monomeric structures of the titanium complexes 4a, 5a, 6a, 7a, and 8a were determined by X-ray crystallography.

Highly Isospecific Polymerization of Silyl-Protected ω-Alkenols Using an [OSSO]-Type Bis(phenolato) Dichloro Zirconium(IV) Precatalyst

The coordination polymerization of silyl-protected ω-alkenols such as ω-alken-α-oxytriisopropylsilanes 1 provides poly(ω-alkenyl-α-oxytriisopropylsilalne)s with a highly isospecific microstructure ([mmmm] > 95%) when a combination of [OSSO]-type bis(phenolato) dichloro zirconium(IV) complex 2 and dried methylaluminoxane is used as the precatalyst and activator, respectively. The resulting siloxy-substituted polymers could be efficiently transformed into the corresponding functionalized polyolefins, which contained up to 90% acetyl groups and ≈7% hydroxy groups in the terminal side chains.

Highly Active and Isospecific Styrene Polymerization Catalyzed by Zirconium Complexes Bearing Aryl-substituted [OSSO]-Type Bis(phenolate) Ligands

[OSSO]-type dibenzyl zirconium(IV) complexes 9 and 10 possessing aryl substituents ortho to the phenoxide moieties (ortho substituents, phenyl and 2,6-dimethylphenyl (Dmp)) were synthesized and characterized. Upon activation with dMAO (dried methylaluminoxane), complex 9 was found to promote highly isospecific styrene polymerizations ([mm] = 97.5%–99%) with high molecular weights M_w up to 181,000 g·mmol⁻¹. When the Dmp-substituted pre-catalyst 10/dMAO system was used, the highest activity, over 7700 g·mmol(10)⁻¹·h⁻¹, was recorded involving the formation of precisely isospecific polystyrenes of [mm] more than 99%.

Synthesis of Ti, Zr, and Hf complexes with a new tetra-azane ligand by one-pot HCl-elimination and their properties as catalysts for production of UHMWPE

The first example for the HCl-elimination reaction being applied in the attachment of an amido-containing ligand to Zr and Hf.

Extremely active α-olefin polymerization and copolymerization with ethylene catalyzed by a dMAO-activated zirconium(iv) dichloro complex having an [OSSO]-type ligand

We report here the polymerization of α-olefins and copolymerization of ethylene with 1-hexene catalyzed by a zirconium complex incorporating an [OSSO]-type ligand with dried methylaluminoxane (dMAO) as an activator.

Straightforward synthesis and catalytic applications of rigid N,O-type calixarene ligands

Here, we report a simple one-step access to new rigid N,O-calixarene ligands which is based on copper-catalized amination at the lower rim. We also present their main group and late transition metal complexes which show superior catalytic activity, in several organic transformations, compared with known metal calixarene complexes.

Polymerization of ethylene and propylene promoted by group 4 metal complexes bearing thioetherphenolate ligands

New group 4 complexes with OS ligands promote the polymerization of ethylene and propylene giving linear polyethylene and atactic polypropylene or oligopropene, respectively.

Addition of a phosphine ligand switches an N-heterocyclic carbene-zirconium catalyst from oligomerization to polymerization of 1-hexene

A catalyst for the oligomerization of 1-hexene, generated by the activation of a benzimidazolylidene zirconium dibenzyl complex, switches to a polymerization catalyst on addition of a trialkylphosphine.

Silica: An efficient catalyst for one-pot regioselective synthesis of dithioethers

The development of a silica-promoted highly selective synthesis of 1,2 or 1,3-dithioethers via solvent-free one-pot tandem reactions of an allyl bromide with excess thiol at room temperature is described. The choice of silica gel, either pre-calcined or moistened with water, exhibited notable regioselectivity in the formation of dithioethers. Plausible mechanistic routes were explored and postulated.