Stable Molybdenum(0) Carbonyl Complex for Upconversion and Photoredox Catalysis

Factors that Impact Photochemical Cage Escape Yields

The utilization of visible light to mediate chemical reactions in fluid solutions has applications that range from solar fuel production to medicine and organic synthesis. These reactions are typically initiated by electron transfer between a photoexcited dye molecule (a photosensitizer) and a redox-active quencher to yield radical pairs that are intimately associated within a solvent cage. Many of these radicals undergo rapid thermodynamically favored "geminate" recombination and do not diffuse out of the solvent cage that surrounds them. Those that do escape the cage are useful reagents that may undergo subsequent reactions important to the above-mentioned applications. The cage escape process and the factors that determine the yields remain poorly understood despite decades of research motivated by their practical and fundamental importance. Herein, state-of-the-art research on light-induced electron transfer and cage escape that has appeared since the seminal 1972 review by J. P. Lorand entitled "The Cage Effect" is reviewed. This review also provides some background for those new to the field and discusses the cage escape process of both homolytic bond photodissociation and bimolecular light induced electron transfer reactions. The review concludes with some key goals and directions for future research that promise to elevate this very vibrant field to even greater heights.

Electrochemiluminescence of a First-Row d6 Transition Metal Complex

We report the electrochemiluminescence (ECL) of a 3d6 Cr(0) complex ([Cr(LMes)3]; λem=735 nm) with comparable photophysical properties to those of ECL-active complexes of 4d6 or 5d6 precious metal ions. The electrochemical potentials of [Cr(LMes)3] are more negative than those of [Ir(ppy)3] and render the [Cr(LMes)3]* excited state inaccessible through conventional co-reactant ECL with tri-n-propylamine or oxalate. ECL can be obtained, however, through the annihilation route in which potentials sufficient to oxidise and reduce the luminophore are alternately applied. When combined with [Ir(ppy)3] (λem=520 nm), the annihilation ECL of [Cr(LMes)3] was greatly enhanced whereas that of [Ir(ppy)3] was diminished. Under appropriate conditions, the relative intensities of the two spectrally distinct emissions can be controlled through the applied potentials. From this starting point for ECL with 3d6 metal complexes, we discuss some directions for future development.

Red-Light-Promoted Radical Cascade Reaction to Access Tetralins and Dialins Enabled by Zinc(II)porphyrin, A Light-Flexible Catalyst

[5,15-Bis(pentafluorophenyl)-10,20-diphenylporphinato]zinc(II) (1), a metalloporphyrin derivative that was recently reported as an efficient photocatalyst driven by blue LEDs by our group, was found to catalyze a red-light-promoted (630 nm LEDs) radical cascade reaction of N-3-arylpropionyloxyphthalimides with radicophiles including electron-deficient alkenes and alkynes, providing access to a range of functionalized tetralin and dialin derivatives. The radical cascade reaction catalyzed by 1 took place via an oxidative quenching cycle in DMSO, where no sacrificial electron donor was required, uncovering a unique solvent effect capable of promoting the porphyrin catalysis.

Reversible Photoinduced Ligand Substitution in a Luminescent Chromium(0) Complex

Light-triggered dissociation of ligands forms the basis for many compounds of interest for photoactivated chemotherapy (PACT), in which medicinally active substances are released or "uncaged" from metal complexes upon illumination. Photoinduced ligand dissociation is usually irreversible, and many recent studies performed in the context of PACT focused on ruthenium(II) polypyridines and related heavy metal complexes. Herein, we report a first-row transition metal complex, in which photoinduced dissociation and spontaneous recoordination of a ligand unit occurs. Two scorpionate-type tridentate chelates provide an overall six-coordinate arylisocyanide environment for chromium(0). Photoexcitation causes decoordination of one of these six ligating units and coordination of a solvent molecule, at least in tetrahydrofuran and 1,4-dioxane solvents, but far less in toluene, and below detection limit in cyclohexane. Transient UV-vis absorption spectroscopy and quantum chemical simulations point to photoinduced ligand dissociation directly from an excited metal-to-ligand charge-transfer state. Owing to the tridentate chelate design and the substitution lability of the first-row transition metal, recoordination of the photodissociated arylisocyanide ligand unit can occur spontaneously on a millisecond time scale. This work provides insight into possible self-healing mechanisms counteracting unwanted photodegradation processes and seems furthermore relevant in the contexts of photoswitching and (photo)chemical information storage.

Luminescent and Photoredox-Active Molybdenum(0) Complexes Competitive with Isoelectronic Ruthenium(II) Polypyridines

Ruthenium(II) complexes with chelating polypyridine ligands are among the most frequently investigated compounds in photophysics and photochemistry, owing to their favorable luminescence and photoredox properties. Equally good photoluminescence performance and attractive photocatalytic behavior is now achievable with isoelectronic molybdenum(0) complexes. The zero-valent oxidation state of molybdenum is stabilized by carbonyl or isocyanide ligands, and metal-to-ligand charge transfer (MLCT) excited states analogous to those in ruthenium(II) complexes can be established. Microsecond MLCT excited-state lifetimes and photoluminescence quantum yields up to 0.2 have been achieved in solution at room temperature, and the emission wavelength has become tunable over a large range. The molybdenum(0) complexes are stronger photoreductants than ruthenium(II) polypyridines and can therefore perform more challenging chemical reductions. The triplet nature of their luminescent MLCT states allows sensitization of photon upconversion via triplet-triplet annihilation, to convert low-energy input radiation into higher-energy output fluorescence. This review summarizes the current state of the art concerning luminescent molybdenum(0) complexes and highlights their application potential. Molybdenum is roughly 140 times more abundant and far cheaper than ruthenium, hence this research is relevant in the greater context of finding more sustainable alternatives to using precious and rare transition metals in photophysics and photochemistry.

Phosphorescent fac-Bis(triarylisocyanide) W(0) and Mo(0) Complexes

Homoleptic W(0) and Mo(0) complexes containing bis(triarylisocyanide) ligands with bulky substituents were synthesized and spectroscopically characterized. Crystallographically determined structures revealed that these complexes are hourglass-like in shape with the tridentate ligands adopting a facial coordination mode to the metal center. These complexes luminesce in fluid solutions and in the solid state. Typically in toluene at 298 K, the two W(0) complexes display the emission maximum (lifetime and quantum yield) at 591 nm (0.83 μs and 0.35) and 628 nm (1.04 μs and 0.39), and similarly, the two Mo(0) complexes display it at 575 nm (0.54 μs and 0.15) and 617 nm (0.56 μs and 0.23). DFT and TDDFT calculations indicated that the low-energy absorption bands of the W(0) and Mo(0) complexes could be metal-to-ligand charge transfer (MLCT) transitions in nature. These complexes exhibited a reversible M+/0 redox couple at -0.70 and -0.63 V vs Fc+/0 for the W(0) complexes and -0.86 and -0.67 V for the Mo(0) complexes. The excited-state reduction potentials were hence estimated to be -2.91 and -2.74 V vs Fc+/0 for the W(0) complexes and -3.10 and -2.81 V vs Fc+/0 for the Mo(0) complexes, indicating that they are potentially strong photoreductants.

Coulomb interactions for mediator-enhanced sensitized triplet-triplet annihilation upconversion in solution

Sensitized triplet-triplet annihilation upconversion offers an attractive possibility to replace a high-energy photon by two photons with lower energy through the combination of a light-harvesting triplet sensitizer and an annihilator for the formation of a fluorescent singlet state. Typically, high annihilator concentrations are required to achieve an efficient initial energy transfer and as a direct consequence the most highly energetic emission is often not detectable due to intrinsic reabsorption by the annihilator itself. Herein, we demonstrate that the addition of a charge-adapted mediator drastically improves the energy transfer efficiency at low annihilator concentrations via an energy transfer cascade. Inspired by molecular dyads and recent developments in nanocrystal-sensitized upconversion, our system exploits a concept to minimize intrinsic filter effects, while boosting the upconversion quantum yield in solution. A sensitizer-annihilator combination consisting of a ruthenium-based complex and 9,10-diphenylanthracene (DPA) is explored as model system and a sulfonated pyrene serves as mediator. The impact of opposite charges between sensitizer and mediator - to induce coulombic attraction and subsequently result in accelerated energy transfer rate constants - is analyzed in detail by different spectroscopic methods. Ion pairing and the resulting static energy transfer in both directions is a minor process, resulting in an improved overall performance. Finally, the more intense upconverted emission in the presence of the mediator is used to drive two catalytic photoreactions in a two-chamber setup, illustrating the advantages of our approach, in particular for photoreactions requiring oxygen that would interfere with the upconversion system.

Improved transition metal photosensitizers to drive advances in photocatalysis

To function effectively in a photocatalytic application, a photosensitizer's light absorption, excited-state lifetime, and redox potentials, both in the ground state and excited state, are critically important. The absorption profile is particularly relevant to applications involving solar harvesting, whereas the redox potentials and excited-state lifetimes determine the thermodynamics, kinetics, and quantum yields of photoinduced redox processes. This perspective article focuses on synthetic inorganic and organometallic approaches to optimize these three characteristics of transition-metal based photosensitizers. We include our own work in these areas, which has focused extensively on exceptionally strong cyclometalated iridium photoreductants that enable challenging reductive photoredox transformations on organic substrates, and more recent work which has led to improved solar harvesting in charge-transfer copper(i) chromophores, an emerging class of earth-abundant compounds particularly relevant to solar-energy applications. We also extensively highlight many other complementary strategies for optimizing these parameters and highlight representative examples from the recent literature. It remains a significant challenge to simultaneously optimize all three of these parameters at once, since improvements in one often come at the detriment of the others. These inherent trade-offs and approaches to obviate or circumvent them are discussed throughout.