Fluorescence Ratiometry of Monomer/Excimer Emissions in a Space-Through PET System

Boosting CO2 photoreduction by π-π-induced preassembly between a Cu(I) sensitizer and a pyrene-appended Co(II) catalyst

The design of a highly efficient system for CO2 photoreduction fully based on earth-abundant elements presents a challenge, which may be overcome by installing suitable interactions between photosensitizer and catalyst to expedite the intermolecular electron transfer. Herein, we have designed a pyrene-decorated Cu(I) complex with a rare dual emission behavior, aiming at additional π-interaction with a pyrene-appended Co(II) catalyst for visible light-driven CO2-to-CO conversion. The results of 1H NMR titration, time-resolved fluorescence/absorption spectroscopies, quantum chemical simulations, and photocatalytic experiments clearly demonstrate that the dynamic π-π interaction between sensitizer and catalyst is highly advantageous in photocatalysis by accelerating the intermolecular electron transfer rate up to 6.9 × 105 s-1, thus achieving a notable apparent quantum yield of 19% at 425 nm with near-unity selectivity. While comparable to most earth-abundant molecular systems, this value is over three times of the pyrene-free system (6.0%) and far surpassing the benchmarking Ru(II) tris(bipyridine) (0.3%) and Ir(III) tris(2-phenylpyridine) (1.4%) photosensitizers under parallel conditions.

Excimer formation and dual fluorescence emission of a hydroxyquinoline based macrocyclic tripod: existence of intra and intermolecular π-stacking

The excited state reaction of 1,4,7-tris-(5-methylene-8-hydroxyquinoline)-1,4,7-triazacyclononane was studied in solution. The intramolecular-π-stacked tripod shows pH-dependent eximer emission and dual fluorescence due to intermolecular π-stacking.

Aggregation enhanced excimer emission (AEEE) with efficient blue emission based on pyrene dendrimers

A series of fluorescent dendrimers with pyrene moieties exhibited aggregation enhanced excimer emission (AEEE). Increases in the dendrimer generation caused emission at 480 nm with a high excimer/monomer emission intensity ratio.

Fluorescent metal ion chemosensors via cation exchange reactions of complexes, quantum dots, and metal–organic frameworks

Overview of a new paradigm in the design of fluorescent chemosensors for detecting metal ions via cation exchange reactions of complexes, quantum dots, and metal–organic frameworks.

Novel ortho-OPE metallofoldamers: binding-induced folding promoted by nucleating Ag(i)–alkyne interactions

Ag(i)–alkyne interactions induce the folding of o-OPE foldamers, yielding a new class of metallofoldamers.

A pyrene thiazole conjugate as a ratiometric chemosensor with high selectivity and sensitivity for tin (Sn4+) and its application in imaging live cells

A new pyrene thiazole-conjugate amine based fluoroionophore, PTC was developed for ratiometric detection of Sn⁴⁺ ion in organo-aqueous medium.

Further insight into the photostability of the pyrene fluorophore in halogenated solvents

Pyrene fluorophores of pyrene-functionalized CdSe quantum dots (QD@Py), as well as alkylpyrene and pyrene itself (Py), undergo fast degradation in aerated chloroform under ultraviolet-A (UV-A, 316<λ<400 nm) illumination. Steady-state fluorescence studies of irradiated chloroform solutions of QD@Py show formation of new bands, red-shifted compared to that of the pyrene moiety. Similar behaviour is observed for pyrene and the alkylpyrene system. Column chromatography of the pyrene photolysate in chloroform allowed us to isolate photoproducts arising from pyrene degradation, and to obtain information on the structure of the photoproducts responsible for the emission bands. The most predominant photoproducts were those originating from the reaction of pyrene with dichloromethyl radicals. The phototransformation of QD@Py and the alkylpyrene involves mainly detachment of the alkyl chain from the aromatic ring, induced also by dichloromethyl radicals, and oxidation of the alkyl chain at the benzylic position was detected as well. By contrast, these pyrene systems show a high photostability in aerated dichloromethane. Transient absorption measurements showed formation of both pyrene triplet and pyrene radical cation for all pyrene systems in these halogenated solvents. The yield of pyrene radical cations for Py is higher than for QD@Py and the alkylpyrene. In addition, pyrene radical cations were longer-lived in dichloromethane than in chloroform. The reason for the pyrene photostability in dichloromethane is the different reactivity of chloromethyl and dichloromethyl radicals towards pyrene and oxygen. These studies show that the use of dichloromethane can be a suitable alternative to chloroform when the good solubility properties of these halogenated solvents are needed to dissolve pyrene when this chromophore is used as a fluorescent probe.

Ratiometric fluorescent receptors for both Zn2+ and H2PO4(-) ions based on a pyrenyl-linked triazole-modified homooxacalix[3]arene: a potential molecular traffic signal with an R-S latch logic circuit

A ratiometric fluorescent receptor with a C(3) symmetric structure based on a pyrene-linked triazole-modified homooxacalix[3]arene (L) was synthesized and characterized. This system exhibited an interesting ratiometric detection signal output for targeting cations and anions through switching the excimer emission of pyrene from the "on-off" to the "off-on" type in neutral solution. (1)H NMR titration results suggested that the Zn(2+) center of receptor L·Zn(2+) provided an excellent pathway of organizing anion binding groups for optimal host-guest interactions. It is thus believed that this receptor has potential application in sensing, detection, and recognition of both Zn(2+) and H(2)PO(4)(-) ions with different optical signals. In addition, the fluorescence emission changes by the inputs of Zn(2+) and H(2)PO(4)(-) ions can be viewed as a combinational R-S latch logic circuit at the molecular level.

Supramolecular chemical sensors based on pyrene monomer-excimer dual luminescence

The past ten years have seen a spectacular development of chemical sensors based on the monomer-excimer dual luminescence of aromatic systems, such as pyrene. Either in the form of integrated or multicomponent molecular devices these chemosensors have been attracting a high interest above all because of their unique ratiometric properties. This review will focus on the latter systems, which can be classified into two classes: Firstly, the assembly of receptor-effector conjugates is triggerred by the analyte of interest. As a result, the sensor shows monomer to excimer fluorescence switching upon substrate binding. Secondly, the supramolecular assembly that constitutes the sensor is perturbed by interaction with the analyte. This induces a conformational change or the exchange of a component of the system, which is the cause of the luminescence switch effect.

Donor-acceptor substituted phenylethynyltriphenylenes - excited state intramolecular charge transfer, solvatochromic absorption and fluorescence emission

Several 2-(phenylethynyl)triphenylene derivatives bearing electron donor and acceptor substituents on the phenyl rings have been synthesized. The absorption and fluorescence emission properties of these molecules have been studied in solvents of different polarity. For a given derivative, solvent polarity had minimal effect on the absorption maxima. However, for a given solvent the absorption maxima red shifted with increasing conjugation of the substituent. The fluorescence emission of these derivatives was very sensitive to solvent polarity. In the presence of strongly electron withdrawing (-CN) and strongly electron donating (-NMe₂) substituents large Stokes shifts (up to 130 nm, 7828 cm⁻¹) were observed in DMSO. In the presence of carbonyl substituents (-COMe and -COPh), the largest Stokes shift (140 nm, 8163 cm⁻¹) was observed in ethanol. Linear correlation was observed for the Stokes shifts in a Lippert-Mataga plot. Linear correlation of Stokes shift was also observed with E(T)(30) scale for protic and aprotic solvents but with different slopes. These results indicate that the fluorescence emission arises from excited state intramolecular charge transfer in these molecules where the triphenylene chromophore acts either as a donor or as an acceptor depending upon the nature of the substituent on the phenyl ring. HOMO-LUMO energy gaps have been estimated from the electrochemical and spectral data for these derivatives. The HOMO and LUMO surfaces were obtained from DFT calculations.

A new fluorescent sensor based on 1H-pyrazolo[3,4-b]quinoline skeleton. Part 2

A novel fluorescent dye bis-(pyridin-2-yl-methyl)-(1,3,4-triphenyl-1H-pyrazolo[3,4-b]quinolin-6-ylmethyl)-amine (P1) has been synthesized and investigated by means of steady state and time-resolved fluorescence techniques. This compound acts as sensor for fluorescence detection of small inorganic cations (lithium, sodium, barium, magnesium, calcium, and zinc) in highly polar solvents such as acetonitrile. The mechanism which allows application of this compound as sensor is an electron transfer from the electron-donative part of molecule (amine) to the acceptor part (pyrazoloquinoline derivative), which is retarded upon complexation of the electro-donative part by inorganic cations. The binding constants are strongly dependent on the charge density of the analyzed cations. The 2/1 complexes of P1 with Zn⁺⁺ and Mg⁺⁺ cations posses large binding constants. Moreover, in the presence of these cations a significant bathochromic shift of fluorescence is observed. The most probable explanation of such behaviour is the formation of intramolecular excimer. This is partially supported by the quantum chemical calculations.

Novel Synthesis and Characterisation of N-Substituted-Calix[4](aza)Crown Derivatives

A novel series of calix[4](aza)crown derivatives is prepared by the reaction between calix[4](aza)crown and 4-bromoacetamido-N-alkyl-1, 8-naphthalimide derivatives. They may be useful fluorescent chemosensors, and have been structurally characterised by IR, 1H NMR, 13C NMR, MS and elemental analyses. From the analytical data, it was found those compounds adopted a cone conformation.