Self-Assembly of a Hydrophobically Modified Naphthalene-Labeled Poly(acrylic acid) Polyelectrolyte in Water:Organic Solvent Mixtures Followed by Steady-State and Time-Resolved Fluorescence

Association of a hydrophobically modified polyelectrolyte and a block copolymer followed by fluorescence techniques

By using absorption and fluorescence (steady-state and time-resolved) techniques, the interaction between a poly(acrylic acid) (PAA), randomly grafted with pyrene (Py) units (PAAMePy55), and a triblock copolymer of poly(ethylene oxide) and poly(propylene oxide) (EO(20)PO(68)EO(20), P123) was investigated. From the fluorescence data, it is shown that upon addition of P123 a decrease of the (pyrene-pyrene, Py-Py) intramolecular association, i.e., a decrease of dynamic and static excimer formation, is observed. Time-resolved fluorescence data reveal the existence of two types of monomers (monomers that are able to form excimer, MAGRE, and isolated monomers) and two excimers. Addition of P123 causes also an increase of the amount of isolated Py monomers. The overall fluorescence data suggest that the PAAMePy55 and the P123 block copolymer associate strongly at low pH, leading to the formation of P123 micelles surrounded by one PAAMePy55 chain, where the pyrene groups are located at the PPO/PEO interface of the P123 micelles. Steady-state fluorescence results also showed that an excess of P123 micelles in solution is required for the association to occur. At high pH (pH 9 and above) the situation is less clear. The steady-state (particularly in the I(1)/I(3) ratio) and time-resolved fluorescence results indicate a contact between the pyrene groups and PEO, which then would imply that there may be an interaction, but much weaker than at low pH.

Solvent-Driven Multiply Configurable On/Off Fluorescent Indicator of the pH Window: A Diethylenetriamine Bearing Two End Pyrene Fragments

Fluorescence behaviors of a simple-structured molecule (L), a diethylenetriamine bearing two end pyrene fragments, have been investigated in water. Effects of adding a less-polar organic solvent (acetonitrile: MeCN) on the emission behaviors have been studied by means of steady-state and time-resolved fluorescence measurements. L dissolved in water shows dual-mode fluorescence consisting of monomer and excimer emissions. The monomer emission shows an "on-off" intensity profile against the pH window (pH 2-12), whereas the excimer emission shows an "off-on" profile. Upon MeCN addition, the monomer emission maintains the "on-off" profile. In contrast, the "off-on" profile of the excimer emission is drastically changed: L shows two more types of profiles, "off-on-off-on" and "off-on-off", along with the MeCN concentration increase, thus behaving as a multiply configurable fluorescent indicator of the pH window. The MeCN-driven excimer emission switching of L is triggered by (i) the decrease in stability of the intramolecular ground-state dimer (GSD) formed between the end pyrene fragments, which suppresses the direct photoexcitation of GSD (suppression of the "static" excimer formation), leading to a decrease in the excimer emission intensity at basic pH; and (ii) the decrease in polarity of solution, which allows formation of a "dynamic" excimer via a monomer-to-excimer transition, resulting in an enhancement of the excimer emission intensity at acidic-neutral pH.

Dynamics of short as compared with long poly(acrylic acid) chains hydrophobically modified with pyrene, as followed by fluorescence techniques

New low and high molecular weight poly(acrylic acid), PAA, 2000 g mol(-1) and 450,000 g mol(-1), respectively, were tagged with pyrene (low and high contents of probe) and its behaviour in solution was investigated using absorption and fluorescence (steady-state and time-resolved) techniques. Fluorescence data shows that the degree and level of intramolecular association strongly depends on the molecular weight. With the short pyrene-labeled PAA chains in aqueous solution, the excimer-to-monomer fluorescence ratio I(E)/I(M) decreases with the increase of pH, oppositely to the increase in the I(E)/I(M) ratio with the increase in pH previously observed with the long chain PAA. Time-resolved data suggest that excimer formation with the short pyrene-labeled PAA polymers (ca. 28 acrylic acid monomers per chain) in water is largely due to excitation of Ground State Dimers, GSD. The increment of pH, and the consequent gradual ionization of the carboxylic groups in the chain, initially increases the fraction of GSD, possibly due to the occurrence of special micelle-like chain conformations, inside which the pyrene units are accommodated. A further increase of the pH above the pK(a) values, resulting in the full ionization of carboxylic groups, apparently destabilizes such chain conformations, which leads to a pH effect on the photophysical properties identical to that of the long chain polymers. In water, the dynamic data shows the existence of two excimers coexisting with two monomer classes. In methanol and dioxane (good solvents for the pyrene probe) at room temperature, where one excimer and two monomers are present, all rate constants could be obtained, as well as the fractions of ground-state species. It is thus shown that different types of interactions are produced with small- and long-sized PAA polymers, i.e., the size of the polymer matters.

Stability and Electronic Properties of Nitrogen Nanoneedles and Nanotubes

The electronic structures and stability of nitrogen nanostructures, nanotubes, and fiberlike nanoneedles of various diameters, formed by units N2m (m = 2-6), were studied by quantum chemistry computational modeling methods. The geometrical structures with various cross-sections and terminal units, their energetic stability, and their rather peculiar electron density distributions were investigated. The tightest nitrogen nanoneedle (NNN) studied theoretically in this work is the structure (N4n with D2h symmetry, whereas the nitrogen nanotube (NNT) with the largest diameter discussed here is the structure (N12)n with D2 symmetry. These families of NNNs and NNTs can be considered as nanostructures not only for potential applications as devices in nanotechnology or as possible scaffold structures but also as ligands in synthetic chemistry and high-energy density materials (HEDMs). As a consequence of the lone-pair electrons present around the walls of these NNNs and NNTs, these nitrogen nanostructures and the nitrogen nano-bundles (NNB) formed by aligning and combining them using intermediate carbon atoms, can have highly variable electronic properties controlled by the changing charge environment. In particular, for extended systems based on the units studied here, the band gaps of each of these systems can be affected greatly by the local charge of the environment.

Dynamics and Energetics of the Self-Assembly of a Hydrophobically Modified Polyelectrolyte: Naphthalene-Labeled Poly(Acrylic Acid)

Steady-state and time-resolved fluorescence studies were performed on aqueous solutions of poly(acrylic acid) hydrophobically modified with two very different levels of naphthalene (Np). It is demonstrated that unique information on association phenomena involving hydrophobe-modifed polymers can be obtained from an extended fluorescence study by using data for a less-modified polymer as a reference. For the more highly modified polymer, the presence of excited-state (as well as ground-state) dimers in addition to monomer emission due to locally excited naphthalene gives evidence for hydrophobic association between naphthalene groups. This association becomes, as expected, much less important at higher pH due to the electrostatic repulsion between different chain segments. However, it is noted that even at high pH there is a significant self-association. The coexistence of static and dynamic quenching phenomena of the Np monomer label was also revealed in the time-resolved fluorescence data. The data are compatible with the existence of two types of monomers and one excimer and suggest that the essential contribution to the monomer emission comes from isolated chromophores, whereas excimer formation arises from both a dynamic route (excited Np chromophores able to produce a dynamic excimer) and a static route (excitation of ground-state Np dimers). At room temperature, the dissociative reaction, excimer-to-monomer, can be neglected, and thus the rate constant for excimer formation and decay could be obtained with and without considering the influence of preformed dimers. Temperature has shown to induce different behavior in the polymer photophysics. In the case of the less-labeled polymer, the decays were found to be single-exponential with the fluorescence lifetime decreasing with increasing temperature. From the temperature dependence of the steady-state fluorescence data, the activation energy for excimer formation and the binding energy of the excimer were evaluated at different pH values, through the Stevens-Ban-type plots of the excimer-to-monomer intensity ratio. With the time-resolved data, measured in the temperature range of 5-60 degrees C, it was possible to extract the intrinsic activation energies for excimer formation. The thermodynamic driving force for the intrapolymeric association was found to be dependent on a balance between hydrophobic and electrostatic interactions, which are dependent on the pH, temperature, and hydrophobic content of the polymer.