Interior and Interfacial Aqueous Solvation of Benzene Dicarboxylate Dianions and Their Methylated Analogues: A Combined Molecular Dynamics and Photoelectron Spectroscopy Study

Preferential Solvation Study of Rosuvastatin in the {PEG400 (1) + Water (2)} Cosolvent Mixture and GastroPlus Software-Based In Vivo Predictions

Rosuvastatin (RST) is a poorly water-soluble drug responsible for limited in vivo dissolution and subsequently low oral systemic absorption (poor bioavailability). The mole fraction solubility values of RST in various ratios of binary mixtures "{PEG400 (1) + water (2)}" at 298.15 K were employed to investigate the preferential solvation (PS) of RST (3) by the binary components. Moreover, the GastroPlus program predicted the drug dissolution/absorption rates, plasma drug concentration, and compartmental regional drug absorbed from a conventional tablet as compared to the RST-loaded (PEG400 + water) mixture (at x ₁ = 0.5) in healthy subjects (considering the fast condition). Fedors' method was adopted to estimate the values of molar volume (314.8 cm³·mol^-1) and Hildebrand solubility parameter (28.08 MPa^1/2) of RST. The results of inverse Kirkwood-Buff integrals showed the PS of RST by PEG400 as observed in all studied ratios of the binary mixture. The highest PS value (δx _1,3 = 1.65 × 10^-2) for RST by PEG400 was attained at x ₁ = 0.5. Finally, the GastroPlus program predicted the maximum dissolution rate [20 mg within 15 min as compared to pure RST (1.5 mg within 15 min)]. Moreover, the program predicted increased in vivo oral absorption (1.2 μg/mL) and enhanced regional absorption (95.3%) of RST from upper segments of the gastrointestinal tract for the RST-loaded PEG400 + water mixture in humans as compared to conventional tablets (87.5% as total regional absorption and 0.88 μg/mL as in vivo absorption). Hence, the present binary system ferrying RST can be a promising strategy to control systemic dyslipidemia after oral or subcutaneous administration.

Imaging Ion Pairs Forming Structural Arrangements in Interfacial Regions

A technique to image ion pairs in solution is reported. We investigated structural and dynamic properties of ion-pair distributions deposited on highly oriented pyrolytic graphite (HOPG) surfaces in electrolyte solutions. Atomic force microscopy images of HOPG immersed in NaCl and KCl solutions display regular arrangements on top of the hexagonal carbon rings forming the HOPG atomic structure. These arrangements are the result of the low value of the aqueous interfacial dielectric constant (ε_r ≈ 3-11). The measured ion-pair radius is a function of the salt present in the solution; for KCl, the ion-pair radius is equal or smaller than 0.42 nm; for NaCl, the ion-pair radius is 0.36 nm. A comparison of these values with their crystalline lattice dimensions indicates that both KCl and NaCl ion pairs in solution at the HOPG/solution interfacial region exist as tight contact ion pairs in quasistationary distributions. The NaCl ion-pair distribution forms an aligned arrangement, and the KCl distribution is formed by intercalated pairs.

Solvent-mediated folding of dicarboxylate dianions: aliphatic chain length dependence and origin of the IR intensity quenching

We combine infrared photodissociation spectroscopy with quantum chemical calculations to characterize the hydration behavior of microsolvated dicarboxylate dianions, (CH2)m(COO(-))2·(H2O)n, as a function of the aliphatic chain length m. We find evidence for solvent-mediated folding transitions, signaled by the intensity quenching of the symmetric carboxylate stretching modes, for all three species studied (m = 2, 4, 8). The number of water molecules required to induce folding increases monotonically with the chain length and is n = 9-12, n = 13, and n = 18-19 for succinate (m = 2), adipate (m = 4), and sebacate (m = 8), respectively. In the special case of succinate, the structural transition is complicated by the possibility of bridging water molecules that bind to both carboxylates with merely minimal chain deformation. On the basis of vibrational calculations on a set of model systems, we identify the factors responsible for intensity quenching. In particular, we find that the effect of hydrogen bonds on the carboxylate stretching mode intensities is strongly orientation dependent.

Effects of nonadditive interactions on ion solvation at the water/vapor interface: a molecular dynamics study

The solvation of halide ions at the water/vapor interface is investigated by using molecular dynamics simulations with nonpolarizable molecular mechanical (MM), polarizable MM, and quantum mechanical (QM)/MM methods. The free energy profile of the ion solvation is decomposed into the energy and the entropic contributions along the ion displacement from inside to the surface of water. It is found that the surface affinity of the ion, relative to the bulk value, is determined by a subtle balance between the energetic destabilization and the entropic stabilization with the ion displacement. The amount of energetic destabilization is found to be reduced when nonadditive interactions are included, as in the polarizable MM and QM/MM models. The structure of water around the ion at the interface is also largely modified when the higher order effects are considered. For example, the induced dipole effect enhances the solvation structure around the ion at the interface significantly and thus reduces the amount of entropic stabilization at the interface, relative to in the bulk. It is found that this induced dipole effect causes the slowing in the ion-water hydrogen bond dynamics at the interface. On the other hand, the higher order induced multipole effects in the QM/MM method suppress both the excessive enhancement of the solvation structure and the slowing of the ion-water hydrogen bond dynamics at the interface. The present study demonstrates that not only the induced dipole moment but also the higher order induced multipole moments, which are neglected in standard empirical models, are essential for the correct description of the ion solvation at the water/vapor interface.

Interaction of benzene with amorphous solid water adsorbed on polycrystalline Ag

The interaction of benzene with polycrystalline Ag and amorphous solid water (D(2)O) deposited thereupon at 124 K was investigated. Metastable impact electron spectroscopy, Reflection-absorption infrared spectroscopy, and temperature programmed desorption were utilized to obtain information on the electronic structure and the relative contribution to the bonding properties of the aromatic molecules among themselves and with D(2)O. On Ag, the benzene molecular plane is oriented parallel to the surface in the first layer. The second layer is tilted with respect to the first one. A total work function decrease of 0.8 eV takes place during the buildup of the first two layers. On amorphous solid water, the orientational distribution of the benzene molecular planes is initially peaked at an angle parallel to the water surface. During the completion of the first adlayer a coverage-induced reorientation takes place, inducing a tilt of the benzene molecules of the first adlayer. Still larger benzene exposures appear to lead to the formation of three-dimensional benzene clusters. Films produced by codepositing benzene and D(2)O or by postdepositing D(2)O layers on benzene films display "volcano like" benzene desorption during ice crystallization.

Water mediated attraction between repulsive ions: A cluster-based simulation approach

Could two like ions be attractive to each other in the presence of water? To address this question and to further interrogate the intriguing solvent effects at a molecular level on multiply charged species, a "bottom-up" simulation approach was formulated, from which the inter-ionic potential of mean force and other properties were monitored closely with the gradual addition of the water molecules. This approach was first tested on a commonly studied ion pair (namely, Na+ and Cl-), where excellent agreement with the published bulk-phase data was found. Further application of this approach to the like-ion pair indicated that an attractive interaction between two anions or two cations can be induced by the addition of an appropriate number of water molecules. This result corroborates a recent experimental report of an intriguing folding of a dianionic polymer into a more compact structure with the addition of water molecules in gas phase as well as previous theoretical findings of possible attraction between like-ion pairs in bulk aqueous phases.