Effect of Water Content on Conversion of d-Cellobiose into 5-Hydroxymethyl-2-furaldehyde in a Dimethyl Sulfoxide–Water Mixture

Influence of Water-Miscible Organic Solvent on the Activity and Stability of Silica-Coated Ru Catalysts in the Selective Hydrolytic Hydrogenation of Cellobiose into Sorbitol

Ruthenium nanoparticles supported on carbon black were coated by mesoporous protective silica layers (Ru/CB@SiO2) with different textural properties (SBET: 280–390 m2/g, pore diameter: 3.4–5.0 nm) and were tested in the selective hydrogenation of glucose into sorbitol. The influence of key parameters such as the protective layer pore size and the solvent nature were investigated. X-ray photoelectron spectroscopy (XPS) analyses proved that the hydrothermal stability was highly improved in ethanolic solution with low water content (silica loss: 99% in water and 32% in ethanolic solution). In this work, the strong influence of the silica layer pore sizes on the selectivity of the reaction (shifting from 4% to 68% by increasing the pores sizes from 3.4 to 5 nm) was also highlighted. Finally, by adding acidic co-catalyst (CB–SO3H), sorbitol was obtained directly through the hydrolytic hydrogenation of cellobiose (used as a model molecule of cellulose), demonstrating the high potential of the present methodology to produce active catalysts in biomass transformations.

Valorization of food waste into hydroxymethylfurfural: Dual role of metal ions in successive conversion steps

This study aimed to transform food waste into a value-added chemical, hydroxymethylfurfural (HMF), and unravel the tangled effects induced by the metal catalysts on each single step of the successive conversion pathway. The results showed that using cooked rice and bread crust as surrogates of starch-rich food waste, yields of 8.1-9.5% HMF and 44.2-64.8% glucose were achieved over SnCl4 catalyst. Protons released from metal hydrolysis and acidic by-products rendered Brønsted acidity to catalyze fructose dehydration and hydrolysis of glycosidic bond. Lewis acid site of metals could facilitate both fructose dehydration and glucose isomerization via promoting the rate-limiting internal hydride shift, with the catalytic activity determined by its electronegativity, electron configuration, and charge density. Lewis acid site of a higher valence also enhanced hydrolysis of polysaccharide. However, the metals also catalyzed undesirable polymerization possibly by polarizing the carbonyl groups of sugars and derivatives, which should be minimized by process optimization.

Organic Carbonates: Efficient Extraction Solvents for the Synthesis of HMF in Aqueous Media with Cerium Phosphates as Catalysts

We describe a process for the selective conversion of C6 -polyols into 5-hydroxymethylfurfural (5-HMF) in biphasic systems of organic carbonate/water (OC/W), with cerium(IV) phosphates as catalysts. Different reaction parameters such as the OC/W ratio, catalyst loading, reaction time, and temperature, were investigated for the dehydration of fructose. Under the best reaction conditions, a yield of 67.7 % with a selectivity of 93.2 % was achieved at 423 K after 6 h of reaction using [(Ce(PO4)1.5 (H2 O)(H3 O)0.5 (H2 O)0.5)] as the catalyst. A maximum yield of 70 % with the same selectivity was achieved after 12 h. At the end of the reaction, the catalyst was removed by centrifugation, the organic phase was separated from water and evaporated in vacuo (with solvent recovery), and solid 5-HMF was isolated (purity >99 %). The recovery and reuse of the catalyst and the relationship between the structure of the OC and the efficiency of the extraction are discussed. The OC/W system influences the lifetime of the catalysts positively compared to only water.

A novel route towards high yield 5-hydroxymethylfurfural from fructose catalyzed by a mixture of Lewis and Brönsted acids

The formed fructose-phosphate-AlCl₃ complex dehydrates along the pathway to 5-HMF in the presence of a high proton concentration provided by H₂SO₄, leading to a high yield of 5-HMF.