Size-selective voltammetry: modification of the interface between two immiscible electrolyte solutions by zeolite Y

Heroin detection in a droplet hosted in a 3D printed support at the miniaturized electrified liquid-liquid interface

Simple sensing protocols for the detection of illicit drugs are needed. Electrochemical sensing is especially attractive in this respect, as its cost together with the analytical accuracy aspires to replace still frequently used colorimetric tests. In this work, we have shown that the interfacial transfer of protonated heroin can be followed at the electrified water-1,2-dichloroethane interface. We have comprehensively studied the interfacial behavior of heroin alone and in the presence of its major and abundant cutting agents, caffeine and paracetamol. To maximally increase developed sensing protocol applicability we have designed and 3D printed a platform requiring only a few microliters of the aqueous and the organic phase. The proposed sensing platform was equipped with a cavity hosting a short section of Ag/AgCl electrode, up to 20 µL of the aqueous phase and the end of the micropipette tip being used as a casing of a fused silica capillary having 25 µm as the internal pore diameter. The volume of the organic phase was equal to around 5 µL and was present inside the micropipette tip. We have shown that under optimized conditions heroin can be detected in the presence of caffeine and paracetamol existing in a sample with 10,000 times excess over the analyte of interest. The calculated limit of detection equal to 1.3 µM, linear dynamic range spanning to at least 50 µM, good reproducibility, and very low volume of needed sample is fully in line with forensic demands.

Ion-transfer voltammetric determination of folic acid at meso-liquid–liquid interface arrays

Voltammetric studies on the simple ion transfer (IT) behaviors of an important water-soluble B-vitamin, folic acid (FA), at the liquid–liquid (L–L) interface were firstly performed and applied as a novel detection method for FA under physiological conditions. This work provides a new and attractive strategy for the detection of FA⁻ and other biological anions.

Electrochemically assisted generation of silica deposits using a surfactant template at liquid/liquid microinterfaces

The electrochemically assisted generation of mesoporous silica deposits at arrays of microscopic liquid/liquid interfaces was investigated. Ion transfer voltammetry was used in order to initiate the formation of silica material by electrochemical transfer of template species (cetyltrimethylammonium, CTA(+)), initially present in the organic phase, to the aqueous phase containing the hydrolyzed silica precursors (tetraethoxysilane, TEOS). The deposition mechanism was investigated using cyclic voltammetry, based on the analysis of diffusion layer profiles of CTA(+) species from the organic side of the interface. The morphology of the deposits varied from hemispherical to almost flat with the potential scan rate, the spacing factor of the microinterfaces array supporting the liquid/liquid interfaces, or the initial CTA(+) and TEOS concentrations, as evidenced by scanning electron microscopy and profilometry analyses. The amount of deposited material can be related to the amount of CTA(+) species passing across the liquid/liquid interfaces. Confocal Raman spectroscopy was used to confirm the presence of surfactant-templated silica deposits and to analyze the effectiveness of calcination in removing the organic molecules filling the interior of the pores. After template removal, the mesoporous network became accessible to external reagents, as checked by interfacial alkylammonium cation transfer, suggesting a possible analytical interest of such modified micro-liquid/liquid interfaces.

Anion transfer across “anion channels” at the liquid/liquid interface modified by anion-exchange membrane

A novel strategy is proposed to mimic anion channels and study anion transfer reactions at the water/1,2-dichloroethane (W/DCE) interface modified by a homogeneous anion-exchange membrane (AEM).