Using ordered carbon nanomaterials for shedding light on the mechanism of the cathodic oxygen reduction reaction

Growth, Properties, and Applications of Branched Carbon Nanostructures

Nanomaterials featuring branched carbon nanotubes (b-CNTs), nanofibers (b-CNFs), or other types of carbon nanostructures (CNSs) are of great interest due to their outstanding mechanical and electronic properties. They are promising components of nanodevices for a wide variety of advanced applications spanning from batteries and fuel cells to conductive-tissue regeneration in medicine. In this concise review, we describe the methods to produce branched CNSs, with particular emphasis on the most widely used b-CNTs, the experimental and theoretical studies on their properties, and the wide range of demonstrated and proposed applications, highlighting the branching structural features that ultimately allow for enhanced performance relative to traditional, unbranched CNSs.

Detection of Superoxide Anion Oxygen Reduction Reaction Intermediate on Pt(111) by Infrared Reflection Absorption Spectroscopy in Neutral pH Conditions

In this work, in situ external infrared reflection absorption spectroscopy (IRRAS) is successfully employed for the detection of intermediate species in the oxygen reduction reaction (ORR) mechanism on a flat and well-defined Pt surface. Superoxide anion species (O2-) are detected on the Pt(111) surface in an O2-saturated solution with a NaF/HClO4 mixture with pH 5.5 by the observation of a O-O vibration band at ca. 1080 cm-1. The observation of O2- without the use of any other additional method of signal enhancement is possible because in these experimental conditions O2- is the main ORR-generated intermediate and its reactivity is limited in this pH. This leads to the accumulation of O2- near the Pt surface, facilitating its identification.

Kinetic Isotope Effect as a Tool To Investigate the Oxygen Reduction Reaction on Pt-based Electrocatalysts - Part II: Effect of Platinum Dispersion

We investigated the oxygen reduction reaction (ORR) mechanism on Pt nanoparticles (NPs) dispersed on several carbon blacks with various physicochemical properties (i. e. specific surface ranging from 80 to 900 m²  g^-1 , different graphitization degree, etc.). Using the kinetic isotope effect (KIE) along with various electrochemical characterizations, we determined that the rate determining step (RDS) of the ORR is a proton-independent step when the density of Pt NPs on the surface of the carbon support is high. Upon decrease of the density of Pt NPs on the surface, the RDS of the ORR starts involving a proton, as denoted by an increase of the KIE >1. This underlined the critical role played by the carbon support in the oxygen reduction reaction electrocatalysis by Pt supported on high surface area carbon.

The influence of mass-transport conditions on the ethanol oxidation reaction (EOR) mechanism of Pt/C electrocatalysts

This study aims to provide further understanding of the influence of different parameters that control mass-transport (the revolution rate of the rotating disk electrode and the potential scan rate) on the ethanol oxidation reaction (EOR).

Polyoxometalate-assisted fabrication of the Pd nanoparticle/reduced graphene oxide nanocomposite with enhanced methanol-tolerance for the oxygen reduction reaction

The prepared Pd/polyoxometalate/reduced graphene oxide (Pd/POM/rGO) nanocomposite exhibits enhanced catalytic activity and excellent methanol-tolerance due to the synergistic effect of Pd, POM, and rGO.

The role of surface oxygenated-species and adsorbed hydrogen in the oxygen reduction reaction (ORR) mechanism and product selectivity on Pd-based catalysts in acid media

Surface adsorbed species can significantly alter the catalytic activity and product selectivity.

Oxygen reduction reaction and peroxide generation on shape-controlled and polycrystalline platinum nanoparticles in acidic and alkaline electrolytes

Shape-controlled Pt nanoparticles (cubic, tetrahedral, and cuboctahedral) are synthesized using stabilizers and capping agents. The nanoparticles are cleaned thoroughly and electrochemically characterized in acidic (0.5 M H2SO4 and 0.1 M HClO4) and alkaline (0.1 M NaOH) electrolytes, and their features are compared to that of polycrystalline Pt. Even with less than 100% shape-selectivity and with the truncation at the edges and corners as shown by the ex-situ TEM analysis, the voltammetric features of the shape-controlled nanoparticles correlate very well with that of the respective single-crystal surfaces, particularly the voltammograms of shape-controlled nanoparticles of relatively larger size. Shape-controlled nanoparticles of smaller size show somewhat higher contributions from the other orientations as well because of the unavoidable contribution from the truncation at the edges and corners. The Cu stripping voltammograms qualitatively correlate with the TEM analysis and the voltammograms. The fractions of low-index crystallographic orientations are estimated through the irreversible adsorption of Ge and Bi. Pt-nanocubes with dominant {100} facets are the most active toward oxygen reduction reaction (ORR) in strongly adsorbing H2SO4 electrolytes, while Pt-tetrahedral with dominant {111} facets is the most active in 0.1 M HClO4 and 0.1 M NaOH electrolytes. The difference in ORR activity is attributed to both the structure-sensitivity of the catalyst and the inhibiting effect of the anions present in the electrolytes. Moreover, the percentage of peroxide generation is 1.5-5% in weakly adsorbing (0.1 M HClO4) electrolytes and 5-12% in strongly adsorbing (0.5 M H2SO4 and 0.1 M NaOH) electrolytes.

The particle size dependence of the oxygen reduction reaction for carbon-supported platinum and palladium

Model carbon supported Pt and Pd electrocatalysts have been prepared using a high-throughput physical vapor deposition method. For Pt, metal particle sizes are controlled between 1.5-5.5 nm over 100 electrodes of an electrochemical screening chip, allowing the oxygen reduction reaction (ORR) activity of the catalysts to be determined simultaneously. The ORR-specific current density is observed to increase with increasing particle diameter up to approximately 4 nm, at which point the activity begins to level off. The reduction in ORR activity for particles below 4 nm is accompanied by a concomitant increase in the overpotential for surface reduction. The resulting mass activity exhibits a maximum for particles with diameters of approximately 3.5 nm. These results are consistent with results published recently for high area carbon-supported Pt catalysts. For Pd particles, both the specific current density and the mass-specific activity for the ORR are observed to increase with increasing particle diameter, with no distinct optimum observed. The implications for the optimization of Pt- or Pd-based ORR catalysts for proton exchange membrane fuel cell (PEMFC) applications are discussed.

Effect of mass transfer on the oxygen reduction reaction catalyzed by platinum dendrimer encapsulated nanoparticles

Here we report on the effect of the mass transfer rate (k(t)) on the oxygen reduction reaction (ORR) catalyzed by Pt dendrimer-encapsulated nanoparticles (DENs) comprised of 147 and 55 atoms (Pt(147) and Pt(55)). The experiments were carried out using a dual-electrode microelectrochemical device, which enables the study of the ORR under high k(t) conditions with simultaneous detection of H(2)O(2). At low k(t) (0.02 to 0.12 cm s(-1)) the effective number of electrons involved in ORR, n(eff), is 3.7 for Pt(147) and 3.4 for Pt(55). As k(t) is increased, the mass-transfer-limited current for the ORR becomes significantly lower than the value predicted by the Levich equation for a 4-electron process regardless of catalyst size. However, the percentage of H(2)O(2) detected remains constant, such that n(eff) barely changes over the entire k(t) range explored (0.02 cm s(-1)). This suggests that mass transfer does not affect n(eff), which has implications for the mechanism of the ORR on Pt nanoparticles. Interestingly, there is a significant difference in n(eff) for the two sizes of Pt DENs (n(eff) = 3.7 and 3.5 for Pt(147) and Pt(55), respectively) that cannot be assigned to mass transfer effects and that we therefore attribute to a particle size effect.

Effect of microstructure of nitrogen-doped graphene on oxygen reduction activity in fuel cells

The development of fuel cells as clean-energy technologies is largely limited by the prohibitive cost of the noble-metal catalysts needed for catalyzing the oxygen reduction reaction (ORR) in fuel cells. A fundamental understanding of catalyst design principle that links material structures to the catalytic activity can accelerate the search for highly active and abundant nonmetal catalysts to replace platinum. Here, we present a first-principles study of ORR on nitrogen-doped graphene in acidic environment. We demonstrate that the ORR activity primarily correlates to charge and spin densities of the graphene. The nitrogen doping and defects introduce high positive spin and/or charge densities that facilitate the ORR on graphene surface. The identified active sites are closely related to doping cluster size and dopant-defect interactions. Generally speaking, a large doping cluster size (number of N atoms >2) reduces the number of catalytic active sites per N atom. In combination with N clustering, Stone-Wales defects can strongly promote ORR. For four-electron transfer, the effective reversible potential ranges from 1.04 to 1.15 V/SHE, depending on the defects and cluster size. The catalytic properties of graphene could be optimized by introducing small N clusters in combination with material defects.

Hydrogen peroxide electrochemistry on platinum: towards understanding the oxygen reduction reaction mechanism

Understanding the hydrogen peroxide electrochemistry on platinum can provide information about the oxygen reduction reaction mechanism, whether H(2)O(2) participates as an intermediate or not. The H(2)O(2) oxidation and reduction reaction on polycrystalline platinum is a diffusion-limited reaction in 0.1 M HClO(4). The applied potential determines the Pt surface state, which is then decisive for the direction of the reaction: when H(2)O(2) interacts with reduced surface sites it decomposes producing adsorbed OH species; when it interacts with oxidized Pt sites then H(2)O(2) is oxidized to O(2) by reducing the surface. Electronic structure calculations indicate that the activation energies of both processes are low at room temperature. The H(2)O(2) reduction and oxidation reactions can therefore be utilized for monitoring the potential-dependent oxidation of the platinum surface. In particular, the potential at which the hydrogen peroxide reduction and oxidation reactions are equally likely to occur reflects the intrinsic affinity of the platinum surface for oxygenated species. This potential can be experimentally determined as the crossing-point of linear potential sweeps in the positive direction for different rotation rates, hereby defined as the "ORR-corrected mixed potential" (c-MP).