AFM studies of inhibition effect in binding of antimicrobial peptide and immune proteins

In situ mapping of biomineral skeletal proteins by molecular recognition imaging with antibody-functionalized AFM tips

Spatial localizing of skeletal proteins in biogenic minerals remains a challenge in biomineralization research. To address this goal, we developed a novel in situ mapping technique based on molecular recognition measurements via atomic force microscopy (AFM), which requires three steps: (1) the development and purification of a polyclonal antibody elicited against the target protein, (2) its covalent coupling to a silicon nitride AFM tip ('functionalization'), and (3) scanning of an appropriately prepared biomineral surface. We applied this approach to a soluble shell protein - accripin11 - recently identified as a major component of the calcitic prisms of the fan mussel Pinna nobilis [1]. Multiple tests reveal that accripin11 is evenly distributed at the surface of the prisms and also present in the organic sheaths surrounding the calcitic prisms, indicating that this protein is both intra- and inter-crystalline. We observed that the adhesion force in transverse sections is about twice higher than in longitudinal sections, suggesting that accripin11 may exhibit preferred orientation in the biomineral. To our knowledge, this is the first time that a protein is localized by molecular recognition atomic force microscopy with antibody-functionalized tips in a biogenic mineral. The 'pros' and 'cons' of this methodology are discussed in comparison with more 'classical' approaches like immunogold. This technique, which leaves the surface to analyze clean, might prove useful for clinical tests on non-pathological (bone, teeth) or pathological (kidney stone) biomineralizations. Studies using implants with protein-doped calcium phosphate coating can also benefit from this technology. STATEMENT OF SIGNIFICANCE: Our paper deals with an unconventional technical approach for localizing proteins that are occluded in biominerals. This technique relies on the use of molecular recognition atomic force microscopy with antibody-functionalized tips. Although such approach has been employed in other system, this is the very first time that it is developed for biominerals. In comparison to more classical approaches (such as immunogold), AFM microscopy with antibody-functionalized tips allows higher magnification and keeps the scanned surface clean for other biophysical characterizations. Our method has a general scope as it can be applied in human health, for non-pathological (bone, teeth) and pathological (kidney stone) biomineralizations as well as for bone implants coated with protein-doped calcium phosphate.

A self-assembled nanocompartment in anammox bacteria for resisting intracelluar hydroxylamine stress

Anammox bacteria play an important role in the global nitrogen cycle, but research on anammoxosome structure is still in its initial stages. In particular, the anammox bacteria genome contains nanocompartments gene loci. However, the function and structure of the nanocompartments in anammox bacteria is poorly understood. We apply genetic engineering to demonstrate the self-assembled nanocompartments of anammox bacteria. The encapsulin shell protein (cEnc) and cargo protein hydroxylamine oxidoreductase (HAO) can self-assemble to form regular nanocompartments (about 128 nm in diameter) in vitro. Cell growth curve tests show that nanocompartments help model bacteria resist hydroxylamine (NH₂OH) stress. Batch test results and transcriptional data show that cEnc and HAO are highly expressed in response to the negative effects of NH₂OH on anammox efficiency, predicting a potential role of nanocompartments in helping anammox bacteria resist NH₂OH stress. These findings improve our understanding of the mechanisms by which anammox bacteria respond to harmful environmental metabolites.

Evaluating the effect of aminoglycosides on the interaction between bovine serum albumins by atomic force microscopy

Characterization and determination of protein-protein interactions (PPIs) plays an important role in molecular biological science. In this study, the effect of aminoglycosides (AGs: streptomycin, gentamycin, lincomycin and clindamycin) on interactions between bovine serum albumin (BSA) was evaluated employing imaging and probing adhesion event by AFM. Multi-spectroscopy and molecular docking were supplementary to investigate the acting forces of the effect. AFM measurements revealed the aggregation of BSA grains and changes of adhesion forces at single molecule level. With adhesion forces between BSA pairs decomposed by Poisson method, specific forces in streptomycin, gentamycin, lincomycin and climdamycin were obviously decreased with the rate of 33.1%, 26.4%, 32.3% and 31.3% while non-specific forces slightly decreased with 5.5%, 3.3%, 4.0% and 7.7%. Combined with results of multi-spectroscopy as well as molecular docking, the whole determination showed AGs affected PPIs by multiple forces, where the hydrogen bonding and hydration effect were the main reasons. The binding of drugs and proteins acted by hydrogen bonding affected the interaction forces between BSA. Consequently, AFM was proposed to be an effective and precise tool in application including evaluating the effects of exogenous compounds on biomacromolecular interactions and rapid screening of drug candidates to avoid potential damages in disease treatment.

Investigating biomolecular recognition at the cell surface using atomic force microscopy

Probing the interaction forces that drive biomolecular recognition on cell surfaces is essential for understanding diverse biological processes. Force spectroscopy has been a widely used dynamic analytical technique, allowing measurement of such interactions at the molecular and cellular level. The capabilities of working under near physiological environments, combined with excellent force and lateral resolution make atomic force microscopy (AFM)-based force spectroscopy a powerful approach to measure biomolecular interaction forces not only on non-biological substrates, but also on soft, dynamic cell surfaces. Over the last few years, AFM-based force spectroscopy has provided biophysical insight into how biomolecules on cell surfaces interact with each other and induce relevant biological processes. In this review, we focus on describing the technique of force spectroscopy using the AFM, specifically in the context of probing cell surfaces. We summarize recent progress in understanding the recognition and interactions between macromolecules that may be found at cell surfaces from a force spectroscopy perspective. We further discuss the challenges and future prospects of the application of this versatile technique.

Evaluating interaction forces between BSA and rabbit anti-BSA in sulphathiazole sodium, tylosin and levofloxacin solution by AFM

Protein-protein interactions play crucial roles in numerous biological processes. However, it is still challenging to evaluate the protein-protein interactions, such as antigen and antibody, in the presence of drug molecules in physiological liquid. In this study, the interaction between bovine serum albumin (BSA) and rabbit anti-BSA was investigated using atomic force microscopy (AFM) in the presence of various antimicrobial drugs (sulphathiazole sodium, tylosin and levofloxacin) under physiological condition. The results show that increasing the concentration of tylosin decreased the single-molecule-specific force between BSA and rabbit anti-BSA. As for sulphathiazole sodium, it dramatically decreased the specific force at a certain critical concentration, but increased the nonspecific force as its concentration increasing. In addition, the presence of levofloxacin did not greatly influence either the specific or nonspecific force. Collectively, these results suggest that these three drugs may adopt different mechanisms to affect the interaction force between BSA and rabbit anti-BSA. These findings may enhance our understanding of antigen/antibody binding processes in the presence of drug molecules, and hence indicate that AFM could be helpful in the design and screening of drugs-modulating protein-protein interaction processes.

Immuno-atomic force microscopy characterization of adsorbed fibronectin

The fibronectin (Fn) binding conformation on mica and ultraflat poly(D,L-lactide-co-glycolide) (UPLGA) was characterized using atomic force microscopy (AFM). AFM topographic images showed that Fn was in an extended form on mica and in a compact structure on UPLGA. With immuno-AFM, an antibody (Ab(hep)) was used to characterize the Fn binding conformation. When Fn opens its binding site for an antibody upon adsorption to a surface, the resulting Fn-antibody complex creates an additional peak in the sample's height distribution. Immuno-AFM uses this change to detect antigen-antibody binding. In this letter, height histograms (distributions) were generated using the mean true height of molecules, which was measured by examining the histogram for each individual molecule and subtracting the mica background. Mean true height values were obtained from the histograms and showed that Fn and Ab(hep) formed complexes on mica, signifying that one of the heparin binding sites on Fn was open when Fn was adsorbed to mica. The mean true height of the Fn-antibody complex from the histogram is greater than expected, suggesting that the antibody had pulled the extended "arms" of Fn together and caused an Fn conformation change upon binding. The height histograms can illustrate the Fn binding conformation and other antigen-antibody binding.