Evaluation of interaction forces between profilin and designed peptide probes by atomic force microscopy

Role of Cel5H protein surface amino acids in binding with clay minerals and measurements of its forces

Our previous study on the binding activity between Cel5H and clay minerals showed highest binding efficiency among other cellulase enzymes cloned. Here, based on previous studies, we hypothesized that the positive amino acids on the surface of Cel5H protein may play an important role in binding to clay surfaces. To examine this, protein sequences of Bacillus licheniformis Cel5H (BlCel5H) and Paenibacillus polymyxa Cel5A (PpCel5A) were analyzed and then selected amino acids were mutated. These mutated proteins were investigated for binding activity and force measurement via atomic force microscopy (AFM). A total of seven amino acids which are only present in BlCel5H but not in PpCel5A were selected for mutational studies and the positive residues which are present in both were omitted. Of the seven selected surface lysine residues, only three mutants K196A(M2), K54A(M3) and K157T(M4) showed 12%, 7% and 8% less clay mineral binding ability, respectively compared with wild-type. The probable reason why other mutants did not show altered binding efficiency might be due to relative location of amino acids on the protein surface. Meanwhile, measurement of adhesion forces on mica sheets showed a well-defined maximum at 69 ± 19 pN for wild-type, 58 ± 19 pN for M2, 53 ± 19 pN for M3, and 49 ± 19 pN for M4 proteins. Hence, our results demonstrated that relative location of surface amino acids of Cel5H protein especially positive charged amino acids are important in the process of clay mineral-protein binding interaction through electrostatic exchange of charges.

Modeling the clay minerals-enzyme binding by fusion fluorescent proteins and under atomic force microscope

In the present study, binding of cellulase protein to different clay minerals were tested using fluorescent-protein complex and microscopic techniques. Cellulase gene (Cel5H) was cloned into three fluorescent vectors and expressed as fusion enzymes. Binding of Cel5H-mineral particles was confirmed by confocal microscopy, and enzyme assay. Among the Cel5H-fusion enzymes, green-fusion enzyme showed higher intensity compared with other red and yellow fusion-proteins. Intensity of fusion-proteins was dependent on the pH of the medium. Confocal microscopy revealed binding of the all three fusion proteins with different clay minerals. However, montmorillonite displayed higher binding capacity than kaolinite clay. Likewise, atomic force microscopy (AFM) image profile analysis showed proteins appeared globular molecules in free-state on mica surface with an average cross sectional diameter of 110 ± 2 nm and rough surface of montmorillonite made protein appear flattened due to structural alteration. Even surface of kaolinite also exerted some strain on protein molecular conformation after binding to surface. Our results provide further evidence for 3D visualization of enzyme-soil complex and encourage furthering study of the force involved interactions. Therefore, our results indicate that binding of proteins to clay minerals was external and provides a molecular method to observe the interaction of clay minerals-enzyme complex.

Optimization of a MT1-MMP-targeting Peptide and Its Application in Near-infrared Fluorescence Tumor Imaging

Membrane type 1 metalloproteinase (MT1-MMP) is an important regulator of cancer invasion, growth and angiogenesis, thus making it an attractive target for cancer imaging and therapy. A non-substrate peptide (MT1-AF7p) that bonded to the "MT-Loop" region of MT1-MMP was identified by using a phage-displayed peptide library and was used to image the MT1-MMP expression in vivo through optical imaging. However, the substrate in the screening did not have a 3D structure, thus resulting in a loose bonding of MT1-AF7p. To simulate the real conformation of the "MT-Loop" and improve the performance of MT1-AF7p, molecular simulations were performed, because this strategy provides multiple methods for predicting the conformation and interaction of proteinase in 3D. In view of the binding site of the receptor-ligand interactions, histidine 4 was selected for mutation to achieve an increased affinity effect. The optimized peptides were further identified and conformed by atomic force microscopy, isothermal titration calorimetry, cell fluorescence imaging in vitro, and near-infrared fluorescence tumor optical imaging in vivo. The results revealed that the optimized peptide with a mutation of histidine 4 to arginine has the highest affinity and specificity, and exhibited an increased fluorescence intensity in the tumor site in optical imaging.

Direct measurement of interaction forces between a platinum dichloride complex and DNA molecules

The interaction forces between a platinum dichloride complex and DNA molecules have been studied using atomic force microscopy (AFM). The platinum dichloride complex, di-dimethylsulfoxide-dichloroplatinum (II) (Pt(DMSO)₂Cl₂), was immobilized on an AFM probe by coordinating the platinum to two amino groups to form a complex similar to Pt(en)Cl₂, which is structurally similar to cisplatin. The retraction forces were measured between the platinum complex and DNA molecules immobilized on mica plates using force curve measurements. The histogram of the retraction force for λ-DNA showed several peaks; the unit retraction force was estimated to be 130 pN for a pulling rate of 60 nm/s. The retraction forces were also measured separately for four single-base DNA oligomers (adenine, guanine, thymine, and cytosine). Retraction forces were frequently observed in the force curves for the DNA oligomers of guanine and adenine. For the guanine DNA oligomer, the most frequent retraction force was slightly lower than but very similar to the retraction force for λ-DNA. A higher retraction force was obtained for the adenine DNA oligomer than for the guanine oligomer. This result is consistent with a higher retraction activation energy of adenine with the Pt complex being than that of guanine because the kinetic rate constant for retraction correlates to exp(FΔx - ΔE) where ΔE is an activation energy, F is an applied force, and Δx is a displacement of distance.

Binding affinity and adhesion force of organophosphate hydrolase enzyme with soil particles related to the isoelectric point of the enzyme

The binding affinity of organophosphate hydrolase enzyme (OphB) with soil particles in relation to the isoelectric point (pI) was studied. Immobilization of OphB with soil particles was observed by confocal microscopy, Fourier transform infrared spectroscopy (FT-IR), and Atomic force microscopy (AFM). The calculated pI of OphB enzyme was increased from 8.69 to 8.89, 9.04 and 9.16 by the single, double and triple mutant of OphB enzyme, respectively through the replacement of negatively charged aspartate with positively charged histidine. Practically, the binding affinity was increased to 5.30%, 11.50%, and 16.80% for single, double and triple mutants, respectively. In contrast, enzyme activity of OphB did not change by the mutation of the enzyme. On the other hand, adhesion forces were gradually increased for wild type OphB enzyme (90 pN) to 96, 100 and 104 pN for single, double and triple mutants of OphB enzyme, respectively. There was an increasing trend of binding affinity and adhesion force by the increase of isoelectric point (pI) of OphB enzyme.

Evaluating interaction forces between BSA and rabbit anti-BSA in sulphathiazole sodium, tylosin and levofloxacin solution by AFM

Protein-protein interactions play crucial roles in numerous biological processes. However, it is still challenging to evaluate the protein-protein interactions, such as antigen and antibody, in the presence of drug molecules in physiological liquid. In this study, the interaction between bovine serum albumin (BSA) and rabbit anti-BSA was investigated using atomic force microscopy (AFM) in the presence of various antimicrobial drugs (sulphathiazole sodium, tylosin and levofloxacin) under physiological condition. The results show that increasing the concentration of tylosin decreased the single-molecule-specific force between BSA and rabbit anti-BSA. As for sulphathiazole sodium, it dramatically decreased the specific force at a certain critical concentration, but increased the nonspecific force as its concentration increasing. In addition, the presence of levofloxacin did not greatly influence either the specific or nonspecific force. Collectively, these results suggest that these three drugs may adopt different mechanisms to affect the interaction force between BSA and rabbit anti-BSA. These findings may enhance our understanding of antigen/antibody binding processes in the presence of drug molecules, and hence indicate that AFM could be helpful in the design and screening of drugs-modulating protein-protein interaction processes.

Probing specific interaction forces between human IgG and rat anti-human IgG by self-assembled monolayer and atomic force microscopy

Interaction forces between biological molecules such as antigen and antibody play important roles in many biological processes, but probing these forces remains technically challenging. Here, we investigated the specific interaction and unbinding forces between human IgG and rat anti-human IgG using self assembled monolayer (SAM) method for sample preparation and atomic force microscopy (AFM) for interaction force measurement. The specific interaction force between human IgG and rat anti-human IgG was found to be 0.6-1.0 nN, and the force required for unbinding a single pair of human IgG and rat anti-human IgG was calculated to be 144 ± 11 pN. The results are consistent with those reported in the literatures. Therefore, SAM for sample preparation combined with AFM for interaction measurement is a relatively simple, sensitive and reliable technique to probe specific interactions between biological molecules such as antigen and antibody.